Elastic Recovery Properties of Ultralight Carbon Nanotube/Carboxymethyl Cellulose Composites.

Ultralight materials exhibit superelastic behavior depending on the selection, blending, and carbonization of the materials. Recently, ultimate low-density materials of 5 mg/cm or less have attracted attention for applications such as sensors, electrodes, and absorbing materials. In this study, we fabricated an ultralight material composed of single-walled carbon nanotubes (CNT) and sodium carboxymethyl cellulose (CMC), and we investigated the effect of density, composition, and weight average molecular weight of CMC on elastic recovery properties of ultralight CNT/CMC composites.

Light-induced levitation of ultralight carbon aerogels via temperature control.

We demonstrate that ultralight carbon aerogels with skeletal densities lesser than the air density can levitate in air, based on Archimedes' principle, when heated with light. Porous materials, such as aerogels, facilitate the fabrication of materials with density less than that of air. However, their apparent density increases because of the air inside the materials, and therefore, they cannot levitate in air under normal conditions.

Ion transportation by Prussian blue nanoparticles embedded in a giant liposome.

A new type of artificial giant liposome incorporating ion transport channels and using nanoparticles of metal organic frameworks was demonstrated. The micropores of Prussian blue nanoparticles served as ion transport channels between the outer and inner phases of liposomes.

Solvent-Free Fabrication of an Elastomeric Epoxy Resin Using Glycol Lignin from Japanese Cedar.

In this study, a simple formulation of softwood-derived glycol lignin (GL)-based epoxy resin with a high GL content of greater than 50 wt % was demonstrated by direct mixing with poly(ethylene glycol) diglycidyl ether (PEGDGE), an aliphatic epoxide, without using any solvent. Because the GL powder produced from poly(ethylene glycol) (PEG400) solvolysis of Japanese cedar softwood meal was a PEG400-modified lignin (GL400), a strong affinity between PEG counterparts facilitates the uniform mixing of GL400 with PEGDGE, and one component uncured GL400/PEGDGE epoxy resin was prepared at a relatively lower temperature (100 °C) than the curing temperature (130 °C). The epoxy curing reaction was monitored by H NMR and Fourier transform infrared spectroscopies.

Improvement of the Heat Resistance of Prussian Blue Nanoparticles in a Clay Film Composed of Smectite Clay and ε-Caprolactam.

Prussian blue (PB) is limited in its application by its breakdown at elevated temperatures. To improve the heat resistance of PB, we prepared a composite film comprising PB nanoparticles (NPs), smectite clay, and an organic compound. The composite film had a microstructure in which PB NPs were intercalated between smectite/organic compound layers.

Grain-Boundary-Free Super-Proton Conduction of a Solution-Processed Prussian-Blue Nanoparticle Film.

A porous crystal family has been explored as alternatives of Nafion films exhibiting super-proton conductivities of ≥10  S cm . Here, the proton-conduction natures of a solution-processed film of nanoparticles (NPs) have been studied and compared to those of a Nafion film. A mono-particle film of Prussian-blue NPs is spontaneously formed on a self-assembled monolayer substrate by a one-step solution process.