Dynamic cytoplasmic projections connect mammalian spermatogonia .

Throughout the male reproductive lifespan, spermatogonial stem cells (SSCs) produce committed progenitors that proliferate and then remain physically connected in growing clones via short cylindrical intercellular bridges (ICBs). These ICBs, which enlarge in meiotic spermatocytes, have been demonstrated to provide a conduit for postmeiotic haploid spermatids to share sex chromosome-derived gene products. In addition to ICBs, spermatogonia exhibit multiple thin cytoplasmic projections.

Rhox13 is required for a quantitatively normal first wave of spermatogenesis in mice.

We previously described a novel germ cell-specific X-linked reproductive homeobox gene (Rhox13) that is upregulated at the level of translation in response to retinoic acid (RA) in differentiating spermatogonia and preleptotene spermatocytes. We hypothesize that RHOX13 plays an essential role in male germ cell differentiation, and have tested this by creating a Rhox13 gene knockout (KO) mouse. Rhox13 KO mice are born in expected Mendelian ratios, and adults have slightly reduced testis weights, yet a full complement of spermatogenic cell types.

Ion-pair reversed phase liquid chromatography with ultraviolet detection for analysis of ultraviolet transparent cations.

This paper describes the use of an anionic ion-pair reagent (IPR) to impove the ultraviolet (UV) detection and hydrophobic retention of polar and UV transparent cations. Anionic IPR added to the mobile phase forms an ion-pair with cations. Formation of the ion-pair causes a redshift in the absorption wavength, making it possible for direct UV detection of UV-inactive cations.

The effect of fat on the measurement of bone mineral density by digital X-ray radiogrammetry (DXR-BMD).

OBJECTIVE: We have previously shown that surrounding fat causes an increase of up to 21% in bone mineral density (BMD) measured by Lunar 'Intelligent DXA' (iDXA), one of the latest generation dual energy X-ray absorptiometry (DXA) scanners [1]. The purpose of our study was to see if it was possible to avoid this artifact when measuring the BMD of metacarpals II, III, and IV by digital X-ray radiogrammetry (DXR). METHODS: We took X-rays of the bones of a cadaveric left hand which were immobilized in a wooden cradle to preserve an approximate in vivo configuration.