Inversion of the temperature dependence of thermal conductivity of hcp iron under high pressure.

Investigating how the thermal transport properties of iron change under extremely high pressure and temperature conditions, such as those found in the Earth's core, is a major experimental challenge. Over the past decade, there has been a great deal of discussion and debate surrounding the thermal conductivity of the iron-based Earth's core and its thermal evolution. One reason for this may be the variability in the experimentally obtained thermal conductivity of iron at high pressures and temperatures.

Submillisecond in situ X-ray diffraction measurement system with changing temperature and pressure using diamond anvil cells at BL10XU/SPring-8.

Recently, there has been a high demand for elucidating kinetics and visualizing reaction processes under extreme dynamic conditions, such as chemical reactions under meteorite impact conditions, structural changes under nonequilibrium conditions, and in situ observations of dynamic changes. To accelerate material science studies and Earth science fields under dynamic conditions, a submillisecond in situ X-ray diffraction measurement system has been developed using a diamond anvil cell to observe reaction processes under rapidly changing pressure and temperature conditions replicating extreme dynamic conditions. The development and measurements were performed at the high-pressure beamline BL10XU/SPring-8 by synchronizing a high-speed hybrid pixel array detector, laser heating and temperature measurement system, and gas-pressure control system that enables remote and rapid pressure changes using the diamond anvil cell.

Measuring the Electrical Resistivity of Liquid Iron to 1.4 Mbar.

We determined the electrical resistivity of liquid Fe to 135 GPa and 6680 K using a four-probe method in a diamond-anvil cell combined with two novel techniques: (i) enclosing a molten Fe in a sapphire capsule, and (ii) millisecond time-resolved simultaneous measurements of the resistance, x-ray diffraction, and temperature of instantaneously melted Fe. Our results show the minimal temperature dependence of the resistivity of liquid Fe and its anomalous resistivity decrease around 50 GPa, likely associated with a gradual magnetic transition, both in agreement with previous ab initio calculations.

High-P-T impedance measurements using a laser-heated diamond anvil cell.

The electrical conductivity (EC) of minerals found on Earth and throughout the solar system is a fundamental transport property that is used to understand various dynamical phenomena in planetary interiors. High-pressure and high-temperature (P-T) EC measurements are also an important tool for observing phase transitions. Impedance measurements can accurately measure the EC of a nonmetallic sample.

The thermal conductivity of the Earth's core and implications for its thermal and compositional evolution.

Determining the thermal conductivity of iron alloys at high pressures and temperatures are essential for understanding the thermal history and dynamics of the Earth's metallic cores. The authors summarize relevant high-pressure experiments using a diamond-anvil cell and discuss implications of high core conductivity for its thermal and compositional evolution.

Numerous chondritic impactors and oxidized magma ocean set Earth's volatile depletion.

Earth's surface environment is largely influenced by its budget of major volatile elements: carbon (C), nitrogen (N), and hydrogen (H). Although the volatiles on Earth are thought to have been delivered by chondritic materials, the elemental composition of the bulk silicate Earth (BSE) shows depletion in the order of N, C, and H. Previous studies have concluded that non-chondritic materials are needed for this depletion pattern.

A cylindrical SiC heater for an externally heated diamond anvil cell to 1500 K.

Semiconductor-based heaters for diamond anvil cells (DACs) have advantages over metal wire heaters in terms of repeated use and the ability to reach higher temperatures. We introduce a cylindrical SiC heater for an externally heated DAC (EHDAC) that works satisfactorily at temperatures up to 1500 K and pressures around 90 GPa. The heater is reusable and inexpensive, and only slight modifications to the DAC are required to fit the heater.

Laboratory-based x-ray computed tomography for 3D imaging of samples in a diamond anvil cell in situ at high pressures.

Three-dimensional (3D) visualization of a material under pressure can provide a great deal of information about its physical and chemical properties. We developed a technique combining in-house x-ray computed tomography (XCT) and a diamond anvil cell to observe the 3D geometry of a sample in situ at high pressure with a spatial resolution of about 610 nm. We realized observations of the 3D morphology and its evolution in minerals up to a pressure of 55.

Combination of pulsed light heating thermoreflectance and laser-heated diamond anvil cell for in-situ high pressure-temperature thermal diffusivity measurements.

By combining thermoreflectance measurements and laser heated diamond anvil cell (LHDAC) techniques, an instrument for the measurement of in situ high pressure-temperature thermal diffusivity of materials was developed. In an LHDAC system, high-power continuous-wave laser beams irradiate both faces of a disk-shaped metal sample loaded into diamond anvil cells (DACs), to maintain a stable high-temperature condition. During the operation of the LHDAC system, temperature of the sample is determined from the thermal radiation spectrum between 640 and 740 nm to fit Planck's law.

Experimental determination of the electrical resistivity of iron at Earth's core conditions.

Earth continuously generates a dipole magnetic field in its convecting liquid outer core by a self-sustained dynamo action. Metallic iron is a dominant component of the outer core, so its electrical and thermal conductivity controls the dynamics and thermal evolution of Earth's core. However, in spite of extensive research, the transport properties of iron under core conditions are still controversial.

Phase boundary of hot dense fluid hydrogen.

We investigated the phase transformation of hot dense fluid hydrogen using static high-pressure laser-heating experiments in a laser-heated diamond anvil cell. The results show anomalies in the heating efficiency that are likely to be attributed to the phase transition from a diatomic to monoatomic fluid hydrogen (plasma phase transition) in the pressure range between 82 and 106 GPa. This study imposes tighter constraints on the location of the hydrogen plasma phase transition boundary and suggests higher critical point than that predicted by the theoretical calculations.

Experimental evidence of superionic conduction in H2O ice.

Ionic conductivity and molar volume measurements were performed on H(2)O ice at high pressure (P) and temperature (T) in a resistive-heated diamond anvil cell. The conductivity data obtained at P = 20-62 GPa, T = 304-930 K are well fitted with a single Arrhenius equation. Isothermal volume measurements at T = 873 K, P = 30-101 GPa indicate that H(2)O ice undergoes phase transitions at P = 50 GPa and 53 GPa due to hydrogen-bond symmetrization.

Experimental and theoretical evidence for pressure-induced metallization in FeO with rocksalt-type structure.

Electrical conductivity of FeO was measured up to 141 GPa and 2480 K in a laser-heated diamond-anvil cell. The results show that rock-salt (B1) type structured FeO metallizes at around 70 GPa and 1900 K without any structural phase transition. We computed fully self-consistently the electronic structure and the electrical conductivity of B1 FeO as a function of pressure and temperature, and found that although insulating as expected at ambient condition, B1 FeO metallizes at high temperatures, consistent with experiments.

The electrical conductivity of post-perovskite in Earth's D'' layer.

Recent discovery of a phase transition from perovskite to post-perovskite suggests that the physical properties of Earth's lowermost mantle, called the D'' layer, may be different from those of the overlying mantle. We report that the electrical conductivity of (Mg0.9Fe0.

The effect of iron spin transition on electrical conductivity of (Mg,Fe)O magnesiowüstite.

We measured the electrical conductivity of Mg0.81Fe0.19O magnesiowüstite, one of the important minerals comprising Earth's lower mantle, at high pressures up to 135 GPa and 300 K in a diamond-anvil cell (DAC).