3D Printed Lenses for Vertical Beam Collimation of Optical Phased Arrays.

This article presents the design, fabrication, and characterization of edge-coupled 1D optical phased arrays (OPAs) combined with collimating lenses. Our concept was tested with two OPAs having different collimation ranges. Both OPA designs have 3-μm waveguide spacing and the maximum beam steering range is about 30° based on wavelength tuning around 1550 nm.

Brilliant quantum dots' photoluminescence from a dual-resonance plasmonic grating.

Semiconductor quantum dots (QDs) have recently caused a stir as a promising and powerful lighting material applied in real-time fluorescence detection, display, and imaging. Photonic nanostructures are well suited for enhancing photoluminescence (PL) due to their ability to tailor the electromagnetic field, which raises both radiative and nonradiative decay rate of QDs nearby. However, several proposed structures with a complicated manufacturing process or low PL enhancement hinder their application and commercialization.

Additive manufacturing of double-sided centimeter-scale optics.

In this article we demonstrate rapid manufacturing of an illumination quality double-sided centimeter-scale optics without any post-processing. Two methods are presented: additive manufacturing (AM) using an optically transparent material with a water-soluble support material (support method), and alternatively, using only the optically transparent material but flipping the optics mid-process (flipping method). The main advantage of the flipping method is that only one material is needed.

Stable and Reusable Lace-like Black Silicon Nanostructures Coated with Nanometer-Thick Gold Films for SERS-Based Sensing.

We propose a simple, fast, and low-cost method for producing Au-coated black Si-based SERS-active substrates with a proven enhancement factor of 10. Room temperature reactive ion etching of silicon wafer followed by nanometer-thin gold sputtering allows the formation of a highly developed lace-type Si surface covered with homogeneously distributed gold islands. The mosaic structure of deposited gold allows the use of Au-uncovered Si domains for Raman peak intensity normalization.

A chiral microchip laser using anisotropic grating mirrors for single mode emission.

A pair of nanostructured mirrors made of a diffraction grating inscribed in the top layer of a Bragg mirror are designed such that a phase shift near π and different reflected amplitudes exist between transverse electric (TE) and magnetic (TM) reflected polarization states at normal incidence. When a standing wave laser resonator is formed with two such mirrors and the two mirrors' principal axes are twisted one with respect to the other, this phase shift condition suppresses multiple longitudinal mode emission arising from axial spatial hole burning. In addition, the different amplitudes of TE and TM reflected polarizations create polarization eigenstates with different round-trip losses, suppressing one polarization eigenstate.

Thermal Control of Plasmonic Surface Lattice Resonances.

Plasmonic metasurfaces exhibiting collective responses known as surface lattice resonances (SLRs) show potential for realizing flat photonic components for wavelength-selective processes, including lasing and optical nonlinearities. However, postfabrication tuning of SLRs remains challenging, limiting the applicability of SLR-based components. Here, we demonstrate how the properties of high quality factor SLRs are easily modified by breaking the symmetry of the nanoparticle surroundings.

Multiply-resonant second-harmonic generation using surface lattice resonances in aluminum metasurfaces.

Nonlinear metamaterials show potential for realizing flat nonlinear optical devices but are generally lacking in terms of achievable conversion efficiencies. Recent work has focused on enhancing nonlinear processes by utilizing high quality factor resonances, such as collective responses known as surface lattice resonances (SLRs) taking place in periodic metal nanoparticle arrays. Here, we investigate how the dispersive nature of SLRs affects the nonlinear responses of SLR-supporting metasurfaces.

Enhanced sensing performance from trapezoidal metallic gratings fabricated by laser interference lithography.

Nanograting-based plasmonic sensors are widely regarded as promising platforms due to their real-time label-free detection and ease of integration. However, many reported grating structures are too complicated to fabricate, which limits their application. We propose a 1D bilayer metallic grating with trapezoidal profile as a near-infrared plasmonic sensor in the spectral interrogation.

High-power thin-disk lasers emitting beams with axially-symmetric polarizations.

We present the intracavity generation of beams with radial polarization at an average output power of 750 W and an optical efficiency of 43% from a continuous wave thin-disk laser. Circular grating waveguide output couplers (GWOC) were used to select the radial polarization. The sensitivity of the polarizing function of the GWOC with regards to the fabrication tolerances is also analysed in details with a particular emphasis on the effect of the duty cycle and the geometrical profile of the gratings.

Visualizing hypochlorous acid production by human neutrophils with fluorescent graphene quantum dots.

In living organisms, redox reactions play a crucial role in the progression of disorders accompanied by the overproduction of reactive oxygen and reactive chlorine species, such as hydrogen peroxide and hypochlorous acid, respectively. We demonstrate that green fluorescence graphene quantum dots (GQDs) can be employed for revealing the presence of the hypochlorous acid in aqueous solutions and cellular systems. Hypochlorous acid modifies the oxygen-containing groups of the GQD, predominantly opens epoxide ring C-O-C, forms excessive C=O bonds and damages the carbonic core of GQDs.

Spectral monitoring at SwissFEL using a high-resolution on-line hard X-ray single-shot spectrometer.

The performance and parameters of the online photon single-shot spectrometer (PSSS) at the Aramis beamline of the SwissFEL free-electron laser are presented. The device operates between the photon energies 4 and 13 keV and uses diamond transmission gratings and bent Si crystals for spectral measurements on the first diffraction order of the beam. The device has an energy window of 0.

Optically induced crossover from weak to strong coupling regime between surface plasmon polaritons and photochromic molecules.

We demonstrate optically induced crossover from a weak to a strong coupling regime in a single photonic system consisting of propagating surface plasmon polaritons (SPPs) on a planar silver film and ultraviolet (UV)-switchable photochromic molecules. A gradual increase is observed in the vacuum Rabi splitting upon increasing UV exposure, along with intriguing behavior, where the reflectivity initially decreases due to increased losses at the weak coupling regime, and then increases due to the emergence of strongly coupled modes and the associated band gap formation at the resonance frequency of the uncoupled states. This work explicitly demonstrates the optical tunability of the degree of hybridization of the SPP and exciton modes, spanning the range from weak to intermediate and finally to the strong coupling regime.

Influence of Fano resonance on SERS enhancement in Fano-plasmonic oligomers.

Plasmonic oligomers can provide profound Fano resonance in their scattering responses. The sub-radiant mode of Fano resonance can result in significant near-field enhancement due to its light trapping capability into the so-called hotspots. Appearance of these highly localized hotspots at the excitation and/or Stokes wavelengths of the analytes makes such oligomers promising SERS active substrates.

Fabrication and characterization of high-efficiency double-sided blazed x-ray optics.

The focusing efficiency of conventional diffractive x-ray lenses is fundamentally limited due to their symmetric binary structures and the corresponding symmetry of their focusing and defocusing diffraction orders. Fresnel zone plates with asymmetric structure profiles can break this limitation; yet existing implementations compromise either on resolution, ease of use, or stability. We present a new way for the fabrication of such blazed lenses by patterning two complementary binary Fresnel zone plates on the front and back sides of the same membrane chip to provide a compact, inherently stable, single-chip device.

Controlling Orientational and Translational Order of Iron Oxide Nanocubes by Assembly in Nanofluidic Containers.

We demonstrate that spatial confinement can be used to control the orientational and translational order of cubic nanoparticles. For this purpose we have combined X-ray scattering and scanning electron microscopy to study the ordering of iron oxide nanocubes that have self-assembled from toluene-based dispersions in nanofluidic channels. An analysis of scattering vector components with directions parallel and perpendicular to the slit walls shows that the confining walls induce a preferential parallel alignment of the nanocube (100) faces.

Artifact characterization and reduction in scanning X-ray Zernike phase contrast microscopy.

Zernike phase contrast microscopy is a well-established method for imaging specimens with low absorption contrast. It has been successfully implemented in full-field microscopy using visible light and X-rays. In microscopy Cowley's reciprocity principle connects scanning and full-field imaging.

High resolution double-sided diffractive optics for hard X-ray microscopy.

The fabrication of high aspect ratio metallic nanostructures is crucial for the production of efficient diffractive X-ray optics in the hard X-ray range. We present a novel method to increase their structure height via the double-sided patterning of the support membrane. In transmission, the two Fresnel zone plates on the two sides of the substrate will act as a single zone plate with added structure height.

Following the dynamics of matter with femtosecond precision using the X-ray streaking method.

X-ray Free Electron Lasers (FELs) can produce extremely intense and very short pulses, down to below 10 femtoseconds (fs). Among the key applications are ultrafast time-resolved studies of dynamics of matter by observing responses to fast excitation pulses in a pump-probe manner. Detectors with sufficient time resolution for observing these processes are not available.

Kinoform diffractive lenses for efficient nano-focusing of hard X-rays.

A nano-focusing module based on two linear Fresnel zone plates is presented. The zone plates are designed to generate a kinoform phase profile in tilted geometry, thus overcoming the efficiency limitations of binary diffractive structures. Adjustment of the tilt angle enables tuning of the setup for optimal efficiency over a wide range of photon energies, ranging from 5 to 20 keV.

High-throughput ptychography using Eiger: scanning X-ray nano-imaging of extended regions.

The smaller pixel size and high frame rate of next-generation photon counting pixel detectors opens new opportunities for the application of X-ray coherent diffractive imaging (CDI). In this manuscript we demonstrate fast image acquisition for ptychography using an Eiger detector. We achieve above 25,000 resolution elements per second, or an effective dwell time of 40 μs per resolution element, when imaging a 500 μm × 290 μm region of an integrated electronic circuit with 41 nm resolution.

High-efficiency zone-plate optics for multi-keV X-ray focusing.

High-efficiency nanofocusing of hard X-rays using stacked multilevel Fresnel zone plates with a smallest zone width of 200 nm is demonstrated. The approach is to approximate the ideal parabolic lens profile with two-, three-, four- and six-level zone plates. By stacking binary and three-level zone plates with an additional binary zone plate, the number of levels in the optical transmission function was doubled, resulting in four- and six-level profiles, respectively.

X-ray ptychographic computed tomography at 16 nm isotropic 3D resolution.

X-ray ptychography is a scanning variant of coherent diffractive imaging with the ability to image large fields of view at high resolution. It further allows imaging of non-isolated specimens and can produce quantitative mapping of the electron density distribution in 3D when combined with computed tomography. The method does not require imaging lenses, which makes it dose efficient and suitable to multi-keV X-rays, where efficient photon counting, pixelated detectors are available.

The Materials Science beamline upgrade at the Swiss Light Source.

The Materials Science beamline at the Swiss Light Source has been operational since 2001. In late 2010, the original wiggler source was replaced with a novel insertion device, which allows unprecedented access to high photon energies from an undulator installed in a medium-energy storage ring. In order to best exploit the increased brilliance of this new source, the entire front-end and optics had to be redesigned.

Single-shot analysis of hard x-ray laser radiation using a noninvasive grating spectrometer.

We present a spectrometer setup based on grating dispersion for hard x-ray free-electron lasers. This setup consists of a focusing spectrometer grating and a charge-integrating microstrip detector. Measurement results acquired at Linac Coherent Light Source are presented, demonstrating noninvasive monitoring of single-shot spectra with a resolution of 2.