Impression Disinfection and Its Effect on Dimensional Accuracy and Surface Detail in the Times of COVID-19: An In Vitro Study.

Introduction The disinfection of impressions is crucial to eliminate the viral and other microbial loads to prevent the cross contamination of diseases. The aim of this study was to compare the effect of different virucidal disinfecting methods on the dimensional accuracy and surface detail reproduction (SDR) of impression materials. Methods A total of 160 samples were fabricated with different impression materials using zinc oxide eugenol (Group 1), alginate (Group 2), polyether (Group 3), and addition silicone (Group 4) impression materials, each containing 40 samples (n=40).

Evaluation and Comparison of Mechanical Properties of Heat Polymerized Acrylic Resin After Reinforcement of Different Fibers in Different Patterns: An In Vitro Study.

Introduction: Most denture fractures occur within the mouth due to resin flexural fatigue. For example, the deep labial notch at the high labial frenum causes denture breakage, as can deep scratches and generated processing stresses. The rising cost of annual prosthetic repairs is evidence that the problem of total denture fracture has not been solved.

Evaluation and Comparison of Two Different Cleaning Procedures on Mechanical Properties for Recemented Restoration Using Two Conventional Glass Ionomer Cement Types: An In Vitro Study.

Background In modern dentistry, fixed dental prostheses are often the preferred and the most complex treatment procedures. However, the success of these procedures depends to a great extent on the durability and consistency of the ongoing reconstruction. This paper aimed to compare the shear bond characteristics of conventional glass ionomer cement types, namely, Vivaglass luting cement and GC fuji 1 cement, after being subjected to two different dentin-cleaning techniques: the tungsten carbide bur and the prophy jet.