Post-compression of 12-fs laser pulses with multi-TW peak power from an optical parametric chirped pulse amplification (OPCPA) system was performed by using a single thin fused silica plate in a vacuum. By optimizing the input pulses in both spatial and temporal domains, after compression with customized chirped mirrors, we achieved pulses as short as 3.87 fs, in combination with 12-mJ energy.
View Article and Find Full Text PDFThe calibration of an ion detection system was carried out for protons and carbon ions from a few tens of keV up to about 1 MeV energies. A Thomson spectrometer deflecting the particle beam accelerated from a laser plasma creates the ion spectra on a phosphor screen behind a micro-channel plate (MCP), which are recorded by a camera. During calibration, the ion spectra simultaneously hit the slotted CR-39 track detector installed in front of the MCP and, passing through the adjacent CR-39 stripes, the MCP.
View Article and Find Full Text PDFSpatial characterization of 0.5 MeV proton beam, driven by 12 fs, 35 mJ, 10 W/cm intense laser-foil interaction is presented. The accelerated proton beam has been applied to obtain a high-resolution, point-projection static radiograph of a fine mesh using a CR-39 plate.
View Article and Find Full Text PDFThe spectral phase shift of broadband amplified pulses, induced by population inversion, was measured in Ti:Sapphire at different pump fluence values. The measurement was performed for two orthogonal polarization directions and at two different crystal temperatures of 296 K and 30 K. Zero shifts and sign changes were observed in the spectral phase, which are connected to the gain spectrum of the crystal.
View Article and Find Full Text PDFWe demonstrate a 100 kHz optical parametric chirped-pulse amplifier delivering under 4-cycle (38 fs) pulses at ~3.2 µm with an average power of 15.2 W with a pulse-to-pulse energy stability <0.
View Article and Find Full Text PDFThe scheme of cascaded extraction optical parametric amplifier (CE-OPA) has been proposed as a final amplifier for high peak power laser systems. 4D numerical simulations show that conversion efficiency of a CE-OPA system pumped with a temporal Gaussian pump pulse is as close to the theoretical limit of quantum efficiency as a conventional OPA pumped with temporal flat-top pump pulse. The CE-OPA system is also similar to the conventional scheme in output energy stability and alignment sensitivity of the phase-matching angles, too.
View Article and Find Full Text PDFWe report on the successful implementation of an adaptive pre-amplification pulse shaping technique in a high-power, coherently combined fiber laser system to achieve sub-300-fs pulse durations at 320 W average power and 3.2 mJ pulse energy. The pulse shaper is utilized to impose a gain flattening mask to increase the spectral width of the amplified pulse by 60%.
View Article and Find Full Text PDFWe demonstrate an optical parametric chirped-pulse amplifier delivering 4-cycles (38-fs) pulses centered around 3.1 µm at 100-kHz repetition rate with an average power of 4 W and an undersampled single-shot carrier-envelope phase noise of 81 mrad recorded over 25 min. The amplifier is pumped by a ~1.
View Article and Find Full Text PDFFew-cycle lasers are essential for many research areas such as attosecond physics that promise to address fundamental questions in science and technology. Therefore, further advancements are connected to significant progress in the underlying laser technology. Here, two-stage nonlinear compression of a 660 W femtosecond fiber laser system is utilized to achieve unprecedented average power levels of energetic ultrashort or even few-cycle laser pulses.
View Article and Find Full Text PDFThe combination of the extraction during pumping (EDP) amplification scheme and the thin disk (TD) technology has been successfully applied to the Ti:sapphire (Ti:sa) laser medium for the first time, to the best of our knowledge. In a proof-of-principle experiment, we demonstrate high energy broadband amplification in a room temperature water cooled EDP-TD head of stretched femtosecond pulses at a 10 Hz repetition rate, instead of performing a cryogenically cooled traditional multi-pass scheme. Hence, the EDP-TD combination can overcome the limits associated with thermal effects and transverse amplified spontaneous emission, enabling Ti:sa laser systems to have a petawatt peak and hundreds of watts of average power.
View Article and Find Full Text PDFCombination of the scheme of extraction during pumping (EDP) and the Thin Disk (TD) technology is presented to overcome the limitations associated with thermal cooling of crystal and transverse amplified spontaneous emission in high average power laser systems based on Ti:Sa amplifiers. The optimized design of high repetition rate 1-10 PW Ti:Sapphire EDP-TD power amplifiers are discussed, including their thermal dynamic behavior.
View Article and Find Full Text PDFThe bandwidth of titanium sapphire (Ti:Sa) laser amplifiers can be greatly broadened with shaping the spectral gain via engineering the spectral polarization of amplified pulses and using both π- and σ-cross-sections. In a proof-of-principle experiment, an amplification bandwidth exceeding 85 nm at a gain of 200 was demonstrated. The accompanying computer modeling revealed that a polarization-encoded chirped pulse amplification scheme can be scaled to higher energies and thus can produce multijoule pulses with bandwidth close to 200 nm, making few-cycle petawatt Ti:Sa systems feasible.
View Article and Find Full Text PDFPhotothermal characteristics and light-induced structural (volume) changes of carotenoid-containing and noncontaining photosynthetic reaction centers (RCs) were investigated by wide frequency band hydrophone. We found that the presence of carotenoid either does not play considerable role in the light-induced conformational movements, or these rearrangements are too slow for inducing a photoacoustic (PA) signal. The kinetic component with a few tens of microseconds, exhibited by the carotenoid-less RCs, appears to be similar to that of triplet state lifetimes, identified by other methods.
View Article and Find Full Text PDFSeveral inorganic and organic materials have been suggested for utilization as nonlinear optical material performing light-controlled active functions in integrated optical circuits, however, none of them is considered to be the optimal solution. Here we present the first demonstration of a subpicosecond photonic switch by an alternative approach, where the active role is performed by a material of biological origin: the chromoprotein bacteriorhodopsin, via its ultrafast BR->K and BR->I transitions. The results may serve as a basis for the future realization of protein-based integrated optical devices that can eventually lead to a conceptual revolution in the development of telecommunications technologies.
View Article and Find Full Text PDFThe refractivity of wild-type bacteriorhodopsin (bR(WT)) suspended in tris(hydroxymethyl)aminomethane (TRIS) buffer has been measured in the spectral range of 390-840 nm by the method of angle of minimal deviation with the use of a hollow glass prism. The refractive indices of pure bR(WT) as well as of TRIS buffer have been determined from the concentration dependent refraction values. Sellmeier-type dispersion equations have been fitted for both the TRIS buffer and pure bR(WT).
View Article and Find Full Text PDFA concept for orthogonal control of phase and group delay inside a laser cavity by a specially designed compensator assembly is discussed. Similar to the construction of variable polarization retarder, this assembly consists of two thin wedge prisms made from appropriately chosen optical materials. Being shifted as a whole, the assembly allows changing the phase delay with no influence on the cavity round-trip time, whereas relative shifting of the prisms enables adjustment of the latter.
View Article and Find Full Text PDFWe propose and demonstrate a novel linear procedure for measurement of the carrier-envelope offset (CEO) phase of femtosecond oscillators. The technique is based on a Mach-Zehnder interferometer, a ring resonator, and a spectrograph. In this scheme, interference between subsequent pulses from a pulse train may frustrate the interference between identical pulses in the Mach-Zehnder, resulting in a modification of interference contrast depending on the CEO phase.
View Article and Find Full Text PDFFused silica gratings with periods of 154 nm, 266 nm, and 550 nm have been fabricated by the method of two-beam interferometric laser induced backside wet etching (TWIN-LIBWE). The spatially filtered pulses at 266nm were splitted into two parts and interfered at an incident angle of 60(o), 30(o), and 14(o), respectively, on the backside surface of a fused silica plate contacting with the liquid absorber. The morphology of the etched gratings was characterized by atomic force microscope.
View Article and Find Full Text PDFHigh-order harmonic generation in gases by use of femtosecond lasers is a source of ultrashort pulses in the extreme-ultraviolet (XUV). For many applications it is necessary to select radiation of only one specific harmonic order without affecting the duration of the ultrashort pulse. A three-grating monochromator that meets this demand has been designed and modeled by ray tracing as well as by wave-optical simulations.
View Article and Find Full Text PDF