Experimental Characterization of Laser Trepanned Microholes in Superalloy GH4220 with Water-Based Assistance.

An experiment using water-assisted millisecond laser trepanning on superalloy GH4220 was carried out, and the effects of pulse energy on the hole entrance morphology, diameter, roundness, cross-section morphology, taper angle, sidewall roughness, and recast layer in air and with water-based assistance were compared and analyzed. The results show that, compared with the air condition, the water-based assistance improved the material removal rate and hole quality, increased the diameter of the hole entrance and exit, increased the hole roundness, decreased the hole taper angle, decreased the hole sidewall roughness, and reduced the recast layer thickness. In addition, under the combined action of water and steam inside the hole, the sidewall surface morphology quality was improved.

Experimental investigation of femtosecond laser through-hole drilling of stainless steel with and without transverse magnetic assistance.

An experimental investigation of femtosecond laser through-hole drilling of stainless-steel 304 with and without transverse magnetic assistance was conducted. The characteristics of the through-hole geometry and sidewall as well as the chemical composition of the through-hole sidewall surface were analyzed. In addition, a theoretical analysis of magnetic-field-assisted femtosecond laser through-hole drilling is proposed.

On-site visualized classification of transparent hazards and noxious substances on a water surface by multispectral techniques.

This paper investigated the use of spectra and multispectral images for on-site visualized classification of transparent hazards and noxious substances (HNS), such as benzene, xylene, and palm oil, floating on a water surface with the potential use for rapid classification of multiple HNS during a leak accident. Partial least-squares discrimination analysis (PLS-DA) and least-squares support vector machine (LS-SVM) models achieved a classification accuracy of 100% for spectral reflectance (325-900 nm) and multispectral image at nine wavelengths. Wavelength division and selection were applied for spectra and spectral images, respectively, to reduce the difficulty in data collection and to simplify the redundant bands.