Publications by authors named "K Mazeika"

The adsorption of Eu(III) on composites synthesised from graphene oxide (GO), maghemite (MGH), and chitosan (CS) has been studied using different approaches. The physicochemical and morphological characteristics of the composites GO-MGH, GO-CS, GO-MGH-CS I, II, and III were determined by XRD, Mössbauer spectroscopy, FTIR, Raman spectroscopy, and TEM. According to the results of batch experiments, the maximum experimental adsorption capacity was 52, 54, 25, 103, and 102 mg/g for GO-MGH, GO-CS, GO-MGH-CS I, II, and III, respectively.

View Article and Find Full Text PDF

In this study, an environmentally friendly sol-gel synthetic approach was used for the preparation of yttrium-doped MgFeO. Two series of compounds with different iron content were synthesized and A-site substitution effects were investigated. In the first series, the iron content was fixed and the charge balance was suggested to be compensated by a partial reduction of Fe to Fe or formation of interstitial O ions.

View Article and Find Full Text PDF

The muscovite mica clay-graphene oxide-maghemite-magnetite (γ-FeO-FeO) composite was first used for the adsorption of caesium(I) and cobalt(II). The presence of clay minerals, graphene oxide, maghemite, and magnetite was detected in the prepared composite by XRD, WD-XRF, Mössbauer spectroscopy, and ATR-FTIR. The SEM and TEM results show that the composite has a layered structure with irregularly shaped pores on the surface.

View Article and Find Full Text PDF

In this work, lanthanum and manganese co-substitution effects on different properties of bismuth ferrite solid solutions BiLaFeMnO (x from 0 to 1) prepared by a sol-gel synthetic approach have been investigated. It was observed that the structural, morphological, and magnetic properties of obtained specimens are influenced by the amount of introduced La ions. Surprisingly, only the compound with a composition of BiFeMnO was not monophasic, and the presence of neighboring phases was determined from X-ray diffraction analysis and Mössbauer measurements.

View Article and Find Full Text PDF

In this study, an aqueous sol-gel synthesis method and subsequent dip-coating technique were applied for the preparation of yttrium iron garnet (YIG), yttrium iron perovskite (YIP), and terbium iron perovskite (TIP) bulk and thin films. The monophasic highly crystalline different iron ferrite powders have been synthesized using this simple aqueous sol-gel process displaying the suitability of the method. In the next step, the same sol-gel solution was used for the fabrication of coatings on monocrystalline silicon (100) using a dip-coating procedure.

View Article and Find Full Text PDF