Hydrothermal deposition as a novel method for the preparation of Co-Mn mixed oxide catalysts supported on stainless steel meshes: application to VOC oxidation.

The aim of this work was to develop a novel method for the preparation of structured Co-Mn mixed oxide catalysts: deposition on stainless steel meshes by hydrothermal synthesis. The use of meshes enabled the deposition of a thin layer of the active phase, which significantly suppressed the influence of internal diffusion. Consequently, the prepared catalysts exhibited from 48 to 114 times higher catalytic activity in ethanol oxidation than the commercial pelleted Co-Mn-Al catalyst.

Structured cobalt oxide catalysts for VOC abatement: the effect of preparation method.

Magnetron sputtering was employed for the deposition of cobalt oxide thin films on stainless steel meshes. Catalysts prepared by sputtering in inert and oxidation atmosphere were compared with those obtained by electrochemical deposition and hydrothermal synthesis. Systematic characterization using X-ray diffraction, scanning electron microscopy, N physisorption, infrared spectroscopy, Raman spectroscopy, and temperature-programmed reduction by hydrogen allowed detailed monitoring of their physicochemical properties.

[Acute myocardial infarction in young patients--severe failures in the system of acute and secondary care].

Introduction: The incidence of cardiovascular (CV) diseases and acute myocardial infarction (AMI) in Czech Republic is de-clining. In spite of this in a proportion of patients AMI occurs in young age. The aim of our project was to assess the character of risk factors, precipitating diseases and the quality of care in young AMI survivors.

Mechanical treatment of TiO2 and ZrO2 oxide mixtures.

The mixed ZrO2-TiO2 system (5-50 wt% of ZrO2) has been studied to investigate the influence of the mechanical treatment on its physicochemical properties depending on the composition, time of milling (5, 10 and 20 min, r.p.m.