Photonic Band Gap Engineering by Varying the Inverse Opal Wall Thickness.

We demonstrate the band gap programming of inverse opals by fabrication of different wall thickness by atomic layer deposition (ALD). The opal templates were synthesized using polystyrene and carbon nanospheres by the vertical deposition method. The structure and properties of the TiO inverse opal samples were investigated using Scanning Electron Microscope (SEM) and Focused Ion Beam Scanning Electron Microscopy (FIB-SEM), Energy Dispersive X-ray analysis (EDX), X-ray Diffraction (XRD) and Finite Difference Time Domain (FDTD) simulations.

Experimental and theoretical aspects of the growth of vertically aligned CNTs by CCVD on AZO substrate.

An efficient and reproducible growth of vertically aligned carbon nanotubes by CCVD requires accurate and specific setting of the synthesis parameters and the properties of catalyst thin layers. In this work, the growth of vertically aligned carbon nanotubes onto AZO (= aluminum doped zinc oxide) glass substrate covered by AlO and Fe-Co catalyst layer system is presented. Investigation of the effect of catalyst composition and synthesis temperature on CVD growth revealed the optimum condition of the synthesis.

Thermodynamic analysis of mono and hybrid nanofluid effect on the photovoltaic-thermal system performance: A comparative study.

The energy and exergy efficiency of a photovoltaic thermal (PV/T) system at various volume fractions is investigated with mono TiO nanofluid and new hybrid TiO-FeO nanofluid. Serpentine tubes soldered on an absorbing plate attached to the rear of the PV module have been proposed to evaluate the effect of nanofluids on the PV/T temperature reduction, energy produced, and exergy losses. The study compared energy and exergy with previous studies and delivered an economic analysis to confirm the feasibility of applying nanofluids.

Novel partially cross-linked nanoparticles graft co-polymer as pore former for polyethersulfone membranes for dyes removal.

A newly developed water-soluble polymeric nano-additive termed "partially cross-linked nanoparticles graft copolymer (PCLNPG)" has been successfully synthesized and harnessed as a pore former for modifying a polyethersulfone ultrafiltration membrane for dyes removal. The PCLNPG content was varied in the PES polymeric matrix aiming to scrutinize its impact on membrane surface characteristics, morphological structure, and overall performance. Proposed interaction mechanism between methylene blue (MB), methyle orange (MO), and malachite green (MG) dyes with PES membrane was presented as well.

Enhanced Antifouling in Flat-Sheet Polyphenylsulfone Membranes Incorporating Graphene Oxide-Tungsten Oxide for Ultrafiltration Applications.

In this study tungsten oxide and graphene oxide (GO-WO) were successfully combined using the ultra-sonication method and embedded with polyphenylsulfone (PPSU) to prepare novel low-fouling membranes for ultrafiltration applications. The properties of the modified membranes and performance were investigated using Fourier-transform infrared spectroscopy (FT-IR), scanning electron microscopy (SEM), contact angle (CA), water permeation flux, and bovine serum albumin (BSA) rejection. It was found that the modified PPSU membrane fabricated from 0.