Novel Fabrication Process for Integration of Microwave Sensors in Microfluidic Channels.

This paper presents a novel fabrication process that allows integration of polydimethylsiloxane (PDMS)-based microfluidic channels and metal electrodes on a wafer with a micrometer-range alignment accuracy. This high level of alignment accuracy enables integration of microwave and microfluidic technologies, and furthermore accurate microwave dielectric characterization of biological liquids and chemical compounds on a nanoliter scale. The microfluidic interface between the pump feed lines and the fluidic channels was obtained using magnets fluidic connection.

A Microwave Platform for Reliable and Instant Interconnecting Combined with Microwave-Microfluidic Interdigital Capacitor Chips for Sensing Applications.

This work presents a novel platform conceived as an interconnect box (ICB) that brings high-frequency signals from microwave instruments to consumable lab-on-a-chip devices. The ICB can be connected to instruments with a standard coaxial connector and to consumable chips by introducing a spring-levered interface with elastomer conductive pins. With the spring-system, microwave-microfluidic chips can be mounted reliably on the setup in a couple of seconds.

An Interdigital Capacitor for Microwave Heating at 25 GHz and Wideband Dielectric Sensing of nL Volumes in Continuous Microfluidics.

This paper proposes a miniature microwave-microfluidic chip based on continuous microfluidics and a miniature interdigital capacitor (IDC). The novel chip consists of three individually accessible heaters, three platinum temperature sensors and two liquid cooling and mixing zones. The IDC is designed to achieve localized, fast and uniform heating of nanoliter volumes flowing through the microfluidic channel.

Rapid ultrasound-induced transient-liquid-phase bonding of Al-50Si alloys with Zn interlayer in air for electrical packaging application.

Al-50Si alloys were joined by rapid ultrasound-induced transient-liquid-phase bonding method using Zn foil as interlayer at 390°C in air, below the melt point of interlayer. The fracture of oxide films along the edge of Si particles led to contact and inter-diffusion between aluminum substrate and Zn interlayer, and liquefied Zn-Al alloys were developed. The width of Zn-Al alloys gradually decreased with increasing the ultrasonic vibration time due to liquid squeezing out and accelerated diffusion.

[Practice and exploration of medical equipment's preventive maintenance based on risk analysis].

This paper analyzes the characteristics of medical equipment's preventive maintenance, and it expounds the objective and methods of introducing risk management to medical equipment's preventive maintenance,what's more,the problem of establishment object and cycle of preventive maintenance was solved scientifically.

[Exploration and practice of the medical equipment maintenance management based on HRP].

Based on HRP (Hospital Resource Planning) system's device management module, A new online information management system is proposed and realized to meet the new challenge of medical devices' repairing and maintenance. the traditional telephone report or online report can all be deal. the repair progress can be visualized in real time PM planning and it's early warning are added.

[Evaluation of bubble oxygen inhalators' performances and an investigation on their solutions for improvement].

This paper analyses the defects of bubble oxygen inhalators currently used, and investigates into their solutions for improvement.