[Preparation and characterization of wood/methylolurea composite with in-situ polymerization].

Wood/methylolurea composite was prepared with the in-situ polymerization. The green timber with high moisture content was impregnated by a pulse-dipping machine and then was dried in a hot-press drying kiln. The cross-linking reaction was taken under the heat treatment between the wood modifier and the wood composition, including cellulose, hemicelluloses, and lignin.

[The influence of reference data noise on the NIR prediction results].

This article used hemicelluloses content in acacia spp. wood as a case study to demonstrate the influence of noise in the reference data on the results of NIR calibration model. The results indicated that the accuracy of NIR calibration model was affected by the reference data noise.

[Preparation and properties of wood/modified UF prepolymer composite materials].

In the present research, the urea-formaldehyde prepolymer and multilayer hot-press drying were used to modify poplar plantation. The prepolymer was impregnated into cell lumen space by pulse-dipping machine. Then the timbers were compressed and dried by the multilayer hot-press drying kiln.

[Extending hemicelluloses content calibration of Acacia spp using NIR to new sites].

In this research, hemicellulose contents of 78 wood meal samples of Acacia spp trees grown in Guangxi and another 33 wood meal samples of Acacia spp trees grown in Fujian were measured by wet chemistry. NIR spectra were also collected by a Bruker MPA spectrometer within 4 000-12 500 cm(-1) of wavenumbers using a standard sample cup. Equations were developed using partial least squares (PLS) regression and cross validation for multivariate calibration in this study.

[Application of near infrared spectroscopy in analysis of wood properties].

There is substantial interest in the improvement of wood properties through genetic selection or a change in silviculture prescription. Tree breeding purpose requires measurement of a large number of samples. However, traditional methods of assessing wood properties are both time consuming and destructive, limiting the numbers of samples that can be processed, so new method would be needed to find.