Formation of Self-Assembled Anticorrosion Films on Different Metals.

The review will first discuss shortly the phenomenon of corrosion and enroll some general possibilities to decrease the rate of this deterioration. The stress will be laid upon the presentation of anticorrosive self-assembled molecular (SAM) layers as well as on the preparation technology that is a simple technique, does not need any special device, and can be applied on different solids (metals or non-metals) alone or in combination. The paper groups the chemicals (mainly amphiphiles) that can develop nanolayers on different pure or oxidized metal surfaces.

Influence of poly(ethylene oxide)-based copolymer on protein adsorption and bacterial adhesion on stainless steel: modulation by surface hydrophobicity.

The aim of the present work is to study the adhesion of Pseudomonas NCIMB 2021, a typical aerobic marine microorganism, on stainless steel (SS) substrate. More particularly, the potential effect on adhesion of adsorbed poly(ethylene oxide)-poly(propylene oxide)-poly(ethylene oxide) (PEO-PPO-PEO) triblock copolymer is investigated. Bacterial attachment experiments were carried out using a modified parallel plate flow chamber, allowing different surface treatments to be compared in a single experiment.

Polystyrene films as barrier layers for corrosion protection of copper and copper alloys.

Dip-coated polystyrene layers of sub-micrometre thickness (85-500nm) have been applied on copper and copper alloys (aluminium brass, copper-nickel 70/30), as well as on stainless steel 304, and produced an effective barrier against corrosion and adhesion of corrosion-relevant microorganisms. According to the dynamic wettability measurements, the coatings exhibited high advancing (103°), receding (79°) and equilibrium (87°) contact angles, low contact angle hysteresis (6°) and surface free energy (31mJ/m(2)). The corrosion rate of copper-nickel 70/30 alloy samples in 3.

Thermotropic and structural effects of poly(malic acid) on fully hydrated multilamellar DPPC-water systems.

The thermotropic and structural effects of low molecular weight poly(malic acid) (PMLA) on fully hydrated multilamellar dipalmitoylphosphatidylcholine (DPPC)-water systems were investigated using differential scanning calorimetry (DSC), small-angle X-ray scattering (SAXS), and freeze-fracture transmission electron microscopy (FFTEM). Systems of 20wt% DPPC concentration and 1 and 5wt% PMLA to lipid ratios were studied. The PMLA derivatives changed the thermal behavior of DPPC significantly and caused a drastic loss in correlation between lamellae in the three characteristic thermotropic states (i.

Organization of the enantiomeric and racemic forms of an amphiphilic resorcinol derivative at the air-water and graphite-1-phenyloctane interfaces.

This article describes a study of the outcome of racemate condensation in different types of monolayers. The study was performed on a resorcinol surfactant bearing an octadecyl chain and a lactate group which formed a monolayer at the interface of graphite and 1-phenyloctane as well as a Langmuir film at the air-water interface. Control experiments with the enantiopure materials provided the characteristics of the chiral organizations.

Investigation of solid surfaces modified by Langmuir-Blodgett monolayers using sum-frequency vibrational spectroscopy and X-ray photoelectron spectroscopy.

Langmuir-Blodgett (LB) monomolecular layers of alkylhydroxamic acids and alkylphosphonic acids on copper and iron substrates have been studied by X-ray photoelectron spectroscopy (XPS) and sum-frequency vibrational spectroscopy. According to the XPS results, the structures of the hydroxamic acid and phosphonic acid Langmuir-Blodgett films are very similar: the thickness of the layer of the hydrocarbon tails is typically 1.9-2.