Method for Determining the Coefficient of Friction Variation Pattern as a Function of Density at Low Temperatures Using the Example of Dry Ice-Steel Contact.

The developments in manufacturing technologies are expected to reduce energy input without compromising product quality. Regarding the material densification process, numerical simulation methods are applied to achieve this goal. In this case, relevant material models are built using functions that describe the variation in mechanical parameters of the material in question due to its deformation.

Composite Lamina Model Design with the Use of Heuristic Optimization.

In engineering practice, a problem is quite often faced in which the number of unknown parameters exceeds the number of conditions or requirements or, otherwise, there are too many requirements for too few parameters to design. Such under- or over-defined tasks are sometimes not possible to solve using a direct approach. The number of solutions to such problems is multiple, and it is most rational to search for the optimal one by numerical methods since the more unknown design parameters there are to be designed, the more potential solutions there are.

Influence of Gating System Parameters of Die-Cast Molds on Properties of Al-Si Castings.

The resulting quality of castings indicates the correlation of the design of the mold inlet system and the setting of technological parameters of casting. In this study, the influence of design solutions of the inlet system in a pressure mold on the properties of Al-Si castings was analyzed by computer modelling and subsequently verified experimentally. In the process of computer simulation, the design solutions of the inlet system, the mode of filling the mold depending on the formation of the casting and the homogeneity of the casting represented by the formation of shrinkages were assessed.

Research and Evaluation of the Influence of the Construction of the Gate and the Influence of the Piston Velocity on the Distribution of Gases into the Volume of the Casting.

Distribution of gasses to the cast volume and volume of pores can be maintained within the acceptable limits by means of correct setting of technological parameters of casting and by selection of suitable structure and gating system arrangement. The main idea of this paper solves the issue of suitability of die casting adjustment-i.e.