Analysis of the environmental impact on a stream: is only tannery to blame?

The contribution of wastewater from a tannery industry to the pollution of a stream was investigated. The main parameters studied were biochemical oxygen demand, chemical oxygen demand, chromium, dissolved oxygen, fecal and total coliforms, nitrogen, oils and greases, pH, phosphorous, sulfides, suspended solids, turbidity, and volatile solids. Three sampling points were located: (1) at the discharge point of tannery wastewater, (2) 50 m upstream, and (3) 80 m downstream of discharge point.

Simultaneous determination of the textile dyes in industrial effluents by first-order derivative spectrophotometry.

A first-order derivative spectrophotometric method for the simultaneous determination of three textile dyes, Procion Yellow HE4R, Procion Red HE7B and Remazol Black 5 (RB5), has been developed. The effects of pH, heating and ionic strength of the solution on the absorption spectra of the dyes were investigated. The wavelengths selected for the measures of the derivative signals of HE4R (395 nm), HE7B (604 nm) and RB5 (659 nm) presented these coefficients of linear correlation: 0.

Square wave voltammetry in the determination of Ni2+ and Al3+ in biological sample.

In this contribution, the amounts of Ni (nickel) and Al (aluminum) in tilapias (Oreochromis niloticus) were determined using square wave voltammetry (SWV) with glassy carbon working microelectrode with a mercury thin film, platinum counter electrode, and Ag/AgCl reference electrode. Ni was studied through the formation of the dimethylglyoxime-Ni (Ni-DMG) complex, while Al was studied through the formation of the Alizarin R-Al complex. The detection limit found for Ni-DMG and Alizarin R-Al complexes were 1.

Comparison of metal analysis in sediments using EDXRF and ICP-OES with the HCl and Tessie extraction methods.

The work presents an investigation on metal availability in sediments during 13 months using the dispersive-energy X-ray fluorescence (EDXRF) and atomic emission spectrometry with induced argon plasma (ICP-OES) techniques and single extraction (0.1moll(-1) HCl) and Tessie's sequential speciation methods. The EDXRF technique could yield essentially the same profile as ICP-OES for the seasonal variation of metals in sediments, but in a more practical way.

Combined electrocoagulation and TiO(2) photoassisted treatment applied to wastewater effluents from pharmaceutical and cosmetic industries.

The treated wastewater consists of refractory materials and high organic content of hydrolyzed peptone residues from pharmaceutical factory. The combination of electrocoagulation (EC) followed by heterogeneous photocatalysis (TiO(2)) conditions was maximized. The EC: iron cathode/anode (12.

The effect of operational parameters on electrocoagulation-flotation process followed by photocatalysis applied to the decontamination of water effluents from cellulose and paper factories.

Cellulose and paper pulp factories utilize a large amount of water generating several undesirable contaminants. The present work is a preliminary investigation that associates the electrocoagulation-flotation (EC) method followed by photocatalysis to treat such wastewater. For EC, the experiment with aluminium and iron electrodes showed similar efficiency.

Capacity of adsorption of Pb2+ and Ni2+ from aqueous solutions by chitosan produced from silkworm chrysalides in different degrees of deacetylation.

The binding capacities of chitin (CT) and chitosan (CS) produced from silkworm chrysalides were investigated aiming at their future application in the removal of Pb2+ and Ni2+ from wastewaters. CS with 75% deacetylation degree (DD) exhibited good binding performance for Pb(2+), but bad efficiency for Ni2+. The maximum binding capacity obtained from isotherms for CS-Pb was 141.

Novel adsorbent based on silkworm chrysalides for removal of heavy metals from wastewaters.

In this contribution, maximum capacity for adsorption of Pb(2+), Ni(2+), and Cu(2+) by silkworm chrysalides (SC) was determined. The raw silkworm chrysalides (SC(r)) and chrysalides after acidic washing (SC(w)) were used. Chitin (CT), extracted from SC, and chitosan (CS), with 85% deacetylation, were employed as reference samples.

Removal of methylene blue dye from an aqueous media using superabsorbent hydrogel supported on modified polysaccharide.

The removal of methylene blue (MB) in water with the superabsorbent hydrogel (SH) formed by modified gum arabic, polyacrylate, and polyacrylamide was investigated. The SH exhibited excellent performance in MB absorption. The maximum absorption capacity was 48 mg of the dye per g of SH, representing 98% of the MB removed.

Spectrophotometric determination of Blue Procion HEGN in effluents of textile industry exploiting the dye aggregation effect and flow injection analysis.

A new spectrophotometric method involving flow injection analysis and textile dye aggregation effect is proposed. The method is based on the aggregation effect of Blue Procion HEGN at pH 3, which relocates its maximum absorption wavelength from 620 to 776 nm, avoiding the interference of other blue textile dyes. For this task, a simple and robust flow injection system was designed, which became a very stable analytical method.

Interpretation of seasonal variation of metals and abiotic properties in a tropical lake using multivariate analysis and MINTEQA2 program.

The hydrological cycle of Lake Ipê and the principal parameters that could affect its abiotic parameters and its metal (Fe, Mn, and Cd) concentrations were investigated. A detailed study of seasonal variations using Principal Components Analysis (PCA) for the most relevant metals (Fe, Mn and Cd) was performed, assisted by the MINTEQA2 geochemical equilibrium program using 15 water abiotic parameters. The abiotic variables and metals in the lake were governed by the hydrological regimen of the Parana River and by the occurrence of occasional flood pulses and rainfall.