Cysteine-Encapsulated Liposome for Investigating Biomolecular Interactions at Lipid Membranes.

The development of a strategy to investigate interfacial phenomena at lipid membranes is practically useful because most essential biomolecular interactions occur at cell membranes. In this study, a colorimetric method based on cysteine-encapsulated liposomes was examined using gold nanoparticles as a probe to provide a platform to report an enzymatic activity at lipid membranes. The cysteine-encapsulated liposomes were prepared with varying ratios of 1,2-dimyristoyl-sn-glycero-3-phosphocholine (DMPC) and cholesterol through the hydration of lipid films and extrusions in the presence of cysteine.

Dual Stimuli-Responsive Multifunctional Silicon Nanocarriers for Specifically Targeting Mitochondria in Human Cancer Cells.

Specific targeting, selective stimuli-responsiveness, and controlled release of anticancer agents are requested for high therapeutic efficiency with a minimal adverse effect. Herein, we report the sophisticated synthesis and functionalization of fluorescent mesoporous silicon (FMPSi) nanoparticles decorated with graphene oxide (GO) nanosheets. GO-wrapped FMPSi (FMPSi@GO) was loaded with a cisplatin (Cis) anticancer agent, and Cis-loaded FMPSi@GO (FMPSi-Cis@GO) exhibited the dual stimuli (pH and NIR)-responsiveness of controlled drug release, i.

Erratum: The effect of pH and transition metal ions on cysteine-assisted gold aggregation for a distinct colorimetric response.

[This corrects the article DOI: 10.1039/D1RA00013F.].

The effect of pH and transition metal ions on cysteine-assisted gold aggregation for a distinct colorimetric response.

Colorimetric detection is a promising sensing strategy that is applicable to qualitative and quantitative determination of an analyte by monitoring visually detectable color changes with the naked eye. This study explored the cysteine (Cys)-induced aggregation of gold nanoparticles (AuNPs) in order to develop a sensitive colorimetric detection method for Cys. For this purpose, we systematically investigated the colorimetric response of AuNPs to Cys with varying particle sizes and concentrations.

Preparation, characterization, and chemical stability of gold nanoparticles coated with mono-, bis-, and tris-chelating alkanethiols.

A systematically varying series of monolayer-protected clusters (MPCs) was prepared by exposing small gold nanoparticles ( approximately 2 nm in diameter) to the following four adsorbates: n-octadecanethiol ( n - C18), 2-hexadecylpropane-1,3-dithiol ( C18C2), 2-hexadecyl-2-methylpropane-1,3-dithiol ( C18C3), and 1,1,1-tris(mercaptomethyl)heptadecane ( t - C18). The resultant MPCs were characterized by solubility studies, UV-vis spectroscopy, transmission electron microscopy (TEM), X-ray photoelectron spectroscopy (XPS), and Fourier-transform infrared spectroscopy (FT-IR). All of the MPCs were soluble in common organic solvents; moreover, analysis by TEM showed that the core dimensions were unaffected by exposure to any of the adsorbates.

The wettability of fluoropolymer surfaces: influence of surface dipoles.

The wettabilities of fluorinated polymers were evaluated using a series of contacting probe liquids ranging in nature from nonpolar aprotic to polar aprotic to polar protic. Fully fluorinated polymers were wet less than partially fluorinated polymers, highlighting the weak dispersive interactions of fluorocarbons. For partially fluorinated polymers, the interactions between the distributed dipoles along the polymer backbone and the dipoles of the contacting liquids were evaluated using both polar and nonpolar probe liquids.

Influence of 4-cyano-4'-biphenylcarboxylic acid on the orientational ordering of cyanobiphenyl liquid crystals at chemically functionalized surfaces.

We report two methods that involve tailoring of the chemical composition of the nematic liquid crystal 4-cyano-4'-pentylbiphenyl to achieve control over the orientational ordering of the liquid crystal on chemically functionalized surfaces. The first method involves the direct addition of 4-cyano-4'-biphenylcarboxylic acid to 4-cyano-4'-pentylbiphenyl. The second method involves exposure of 4-cyano-4'-pentylbiphenyl to ultraviolet light and photochemical generation of a range of products, including 4-cyano-4'-biphenylcarboxylic acid.

Loosely packed self-assembled monolayers on gold generated from 2-alkyl-2-methylpropane-1,3-dithiols.

A series of 2-alkyl-2-methylpropane-1,3-dithiol derivatives with increasing alkyl chain lengths (i.e., CH3(CH2)mC(CH3)[CH2SH]2, where m = 7, 9, 11, 13, 15) were synthesized and used to generate self-assembled monolayers (SAMs) on gold.

Synthesis of tetraoctylammonium-protected gold nanoparticles with improved stability.

This paper shows that an introduction of thiosulfate anions in place of bromide anions greatly improves both chemical and thermal stability of tetraoctylammonium-protected gold nanoparticles. Tetraoctylammonium thiosulfate [(Oct)4N+-O3SS]-protected gold nanoparticles are synthesized by the reduction of (Oct)4N+-AuCl4 to Au(I)-SSO3-, followed by the addition of sodium borohydride. The presence of thiosulfate anions instead of bromide anions on the surface of gold nanoparticles results in a significant dampening of the surface plasmon band of gold at 526 nm due to the strong interaction between thiosulfate and the gold nanoparticle surface.

Systematic control of the packing density of self-assembled monolayers using bidentate and tridentate chelating alkanethiols.

The structural and interfacial properties of self-assembled monolayers (SAMs) on gold derived from the adsorption of a series of 1,1,1-tris(mercaptomethyl)alkanes (i.e., CH3(CH2)mC[CH2SH]3, where m = 9, 11, 13, 15) were investigated.