Subscapularis Repair in Reverse Total Shoulder Arthroplasty: Differences in Outcomes Based on Preoperative Quality of Subscapularis Tendon.

Purpose: This study examines the influence of preoperative fatty infiltration (FI) of the subscapularis tendon (SBS) on outcomes following reverse total shoulder arthroplasty (rTSA) with SBS repair.

Methods: A cohort of 161 rTSA patients with SBS repair, followed for a mean of 45.3 months, was divided into three groups based on FI: Group A (intact upper and lower portions,  = 85), Group B (intact lower portions,  = 44), and Group C (fatty infiltrated in both portions,  = 32).

Arthroscopic decompression of calcific tendinitis without cuff repair.

Aims: The aim of this study was to investigate the outcomes of arthroscopic decompression of calcific tendinitis performed without repairing the rotator cuff defect.

Methods: A total of 99 patients who underwent treatment between December 2013 and August 2019 were retrospectively reviewed. Visual analogue scale (VAS) and American Shoulder and Elbow Surgeons (ASES) scores were reviewed pre- and postoperatively according to the location, size, physical characteristics, and radiological features of the calcific deposits.

Assembly and alignment method for optimized spatial resolution of off-axis three-mirror fore optics of hyperspectral imager.

A fore optics for the hyperspectral spectrometer is designed, manufactured, assembled, and aligned. The optics has a telecentric off-axis three-mirror configuration with a field of view wider than 14 degrees and an f-number as small as 2.3.

Design and construction of an Offner spectrometer based on geometrical analysis of ring fields.

A method to obtain an aberration-corrected Offner spectrometer without ray obstruction is proposed. A new, more efficient spectrometer optics design is suggested in order to increase its spectral resolution. The derivation of a new ring equation to eliminate ray obstruction is based on geometrical analysis of the ring fields for various numerical apertures.

Initial design method based on an iterative calculation of aberration and its application to an objective lens for imaging spectrometer.

An initial optical design method based on an iterative calculation of third-order aberration is presented to overcome the problems of the conventional method. The aberrations of each lens group in the optical system are calculated individually and iteratively under the constraint that aberrations of one group compensate for those of the other groups. The stabilities of initial design results have been confirmed and the iterative design method has been applied for the design of optical system with an external entrance pupil for imaging spectrometer.

Zoom lens design for a novel imaging spectrometer that controls spatial and spectral resolution individually.

A novel imaging spectrometer can individually control spatial and spectral resolution by using zoom lenses as the foreoptics of the system and a focusing lens. By varying the focal length we can use the focusing lens to change the spatial and spectral dimensions; with the foreoptics, however, we can change only the spatial dimension. Therefore the spectral resolution and the spectral range are affected by the zoom ratio of the focusing lens, whereas the spatial resolution and the field of view are affected by the multiplication of the zoom ratios of the foreoptics and the focusing lens.