Structural and nanomechanical properties of paperboard coatings studied by peak force tapping atomic force microscopy.

Paper coating formulations containing starch, latex, and clay were applied to paperboard and have been investigated by scanning electron microscopy and Peak Force tapping atomic force microscopy. A special focus has been on the measurement of the variation of the surface topography and surface material properties with a nanometer scaled spatial resolution. The effects of coating composition and drying conditions were investigated.

Probing material properties of polymeric surface layers with tapping mode AFM: which cantilever spring constant, tapping amplitude and amplitude set point gives good image contrast and minimal surface damage?

A phase shift between the oscillatory motion and drive motion of an AFM-cantilever used for tapping mode AFM imaging can be related to adhesive and elastic properties of surface layers. In this study it was studied how optimal contrast between hard and soft surface layers can be achieved while minimizing the surface damage. This was investigated by performing classical force-distance measurements while driving the cantilever as in tapping mode imaging.

Influence of anisotropy on the dynamic wetting and permeation of paper coatings.

A void network model, named Pore-Cor, has been used to study the permeation of an ink solvent into paper coating formulations coated onto a synthetic substrate. The network model generated anisotropic void networks of rectangular cross-sectional pores connected by elliptical cross-sectional throats. These structures had porosities and mercury intrusion properties which closely matched those of the experimental samples.