Improving the Quantum Yields of Perylene Diimide Aggregates by Increasing Molecular Hydrophobicity in Polar Media.

Here we report the quantum yield of four aggregated perylene diimide (PDI) species that vary by the length of the branched side chains attached at the N,N' imide positions. The PDI molecules were dissolved in binary water:methanol solvents as a means to vary the solvent polarity and control the degree of aggregation in solution. By performing spectroscopy, kinetics, and light scattering experiments, the nature of the molecular interactions in the solutions was determined.

Enhanced Davydov Splitting in Crystals of a Perylene Diimide Derivative.

We report the polarized absorption spectra of high-quality, thin crystals of a perylene diimide (PDI) species with branched side chains (B2). The absorption spectrum shows exemplary polarization-dependent H-like and J-like aggregate behavior upon orthogonal excitation, with a sizable Davydov splitting (DS) of 1230 cm and peak to peak splitting of 3040 cm. The experimental results are compared to theoretical calculations with remarkable agreement.

Lock-arm supramolecular ordering: a molecular construction set for cocrystallizing organic charge transfer complexes.

Organic charge transfer cocrystals are inexpensive, modular, and solution-processable materials that are able, in some instances, to exhibit properties such as optical nonlinearity, (semi)conductivity, ferroelectricity, and magnetism. Although the properties of these cocrystals have been investigated for decades, the principal challenge that researchers face currently is to devise an efficient approach which allows for the growth of high-quality crystalline materials, in anticipation of a host of different technological applications. The research reported here introduces an innovative design, termed LASO-lock-arm supramolecular ordering-in the form of a modular approach for the development of responsive organic cocrystals.

Effects of Exciton Polarity in Charge-Transfer Polymer/PCBM Bulk Heterojunction Films.

Charge-transfer copolymers with local electron density gradients, systematically modified by quantity and position of fluorination, result in widely variable (2-8%) power conversion efficiencies (PCEs). Ultrafast, near-infrared, transient absorption spectroscopy on the corresponding films reveals the influence of exciton polarity on ultrafast populations and decay dynamics for the charge-separated and charge-transfer states as well as their strong correlation to device PCEs. By using an excitation energy-dependent, dynamic red shift in the transient absorption signal for the polymer cation, the exciton polarity induced by push-pull interactions within each polymer fragment is shown to enhance charge dissociation on time scales of tens to hundreds of picoseconds after excitation.

Room-temperature ferroelectricity in supramolecular networks of charge-transfer complexes.

Materials exhibiting a spontaneous electrical polarization that can be switched easily between antiparallel orientations are of potential value for sensors, photonics and energy-efficient memories. In this context, organic ferroelectrics are of particular interest because they promise to be lightweight, inexpensive and easily processed into devices. A recently identified family of organic ferroelectric structures is based on intermolecular charge transfer, where donor and acceptor molecules co-crystallize in an alternating fashion known as a mixed stack: in the crystalline lattice, a collective transfer of electrons from donor to acceptor molecules results in the formation of dipoles that can be realigned by an external field as molecules switch partners in the mixed stack.

Ultrafast intramolecular exciton splitting dynamics in isolated low-band-gap polymers and their implications in photovoltaic materials design.

Record-setting organic photovoltaic cells with PTB polymers have recently achieved ~8% power conversion efficiencies (PCE). A subset of these polymers, the PTBF series, has a common conjugated backbone with alternating thieno[3,4-b]thiophene and benzodithiophene moieties but differs by the number and position of pendant fluorine atoms attached to the backbone. These electron-withdrawing pendant fluorine atoms fine tune the energetics of the polymers and result in device PCE variations of 2-8%.

Strong steric hindrance effect on excited state structural dynamics of Cu(I) diimine complexes.

The metal-to-ligand-charge-transfer (MLCT) excited state of Cu(I) diimine complexes is known to undergo structural reorganization, transforming from a pseudotetrahedral D(2d) symmetry in the ground state to a flattened D(2) symmetry in the MLCT state, which allows ligation with a solvent molecule, forming an exciplex intermediate. Therefore, the structural factors that influence the coordination geometry change and the solvent accessibility to the copper center in the MLCT state could be used to control the excited state properties. In this study, we investigated an extreme case of the steric hindrance caused by attaching bulky tert-butyl groups in bis(2,9-di-tert-butyl-1,10-phenanthroline)copper(I), [Cu(I)(dtbp)(2)](+).

Effects of additives on the morphology of solution phase aggregates formed by active layer components of high-efficiency organic solar cells.

Processing additives are used in organic photovoltaic systems to optimize the active layer film morphology. However, the actual mechanism is not well understood. Using X-ray scattering techniques, we analyze the effects of an additive diiodooctane (DIO) on the aggregation of a high-efficiency donor polymer PTB7 and an acceptor molecule PC(71)BM under solar cell processing conditions.

Nanoscale structure, dynamics and power conversion efficiency correlations in small molecule and oligomer-based photovoltaic devices.

Photovoltaic functions in organic materials are intimately connected to interfacial morphologies of molecular packing in films on the nanometer scale and molecular levels. This review will focus on current studies on correlations of nanoscale morphologies in organic photovoltaic (OPV) materials with fundamental processes relevant to photovoltaic functions, such as light harvesting, exciton splitting, exciton diffusion, and charge separation (CS) and diffusion. Small molecule photovoltaic materials will be discussed here.

Examining the effect of the dipole moment on charge separation in donor-acceptor polymers for organic photovoltaic applications.

A new low band gap copolymer PBB3 containing [6,6']bi[thieno[3,4-b]thiophenyl]-2,2'-dicarboxylic acid bis-(2-butyloctyl) ester (BTT) and 4,8-bis(2-butyloctyl)benzo[1,2-b:4,5-b']dithiophene (BDT) units was synthesized and tested for solar cell efficiency. PBB3 showed a broad absorbance in the near-IR region with a substantially red-shifted (by more than 100 nm) λ(max) at 790 nm as compared to the PTB series of polymers, which have been previously reported. The PBB3 polymer also showed both a favorable energy level match with PCBM (with a LUMO energy level of -3.

Electronic processes in conjugated diblock oligomers mimicking low band-gap polymers: experimental and theoretical spectral analysis.

Conjugated oligomers containing a common central thienothiophene unit symmetrically connected to two identical thiophene oligomers were studied as model systems for a series of low bandgap organic diblock copolymers. The oligothiophene side chain fragments were varied in length as a means to tune the electronic coupling between the thienothiophene and oligothiophene moieties. The fragment length dependence of both the ground- and excited-state electronic and structural properties of a series of diblock oligomers were investigated in detail.

Room temperature light emission from the low-dimensional semiconductors AZrPS6 (A = K, Rb, Cs).

The new semiconducting thiophosphate compounds KZrPS(6), RbZrPS(6), and CsZrPS(6) exhibit red light emission at room temperature. The materials have longer photoluminescence lifetimes than most of the inorganic chalcogenide semiconductors. They can be solution processed into thin films for potential device fabrication.

Dye-sensitized solar cells: sensitizer-dependent injection into ZnO nanotube electrodes.

Two porphyrin-based dyes with carboxylic acid tethers of differing acidity in both protonated and deprotonated forms were examined on ZnO nanotube electrodes. All of the dyes have similar surface coverage, but only the more acidic dye in the acid form injects electrons well; this dye is the only one that corrodes the ZnO. In control experiments on TiO(2) nanoparticle electrodes, both dyes load and inject in protonated and deprotonated forms.

Zinc oxide nanorod growth on gold islands prepared by microsphere lithography on silicon and quartz.

Gold islands, vapor deposited on silicon and quartz by microsphere lithography patterning, are used to nucleate arrays of ZnO nanorods. ZnO is grown on approximately 0.32 microm2 Au islands by carbothermal reduction in a tube furnace.

Ultrafast wavelength-dependent lasing-time dynamics in single ZnO nanotetrapod and nanowire lasers.

The ultrafast lasing dynamics of single zinc oxide nanotetrapods and nanowires are investigated by two-color femtosecond excitation/optical injection spectroscopy. The transient spectral gain induced by time-delayed optical injection pulses (400 nm) is used to investigate the spectrally and temporally resolved lasing properties in a single tetrapod or nanowire laser excited by 267-nm pulses. The lasing output pulse exhibits a faster lasing decay time than the carrier decays due to the superlinear dependence of the lasing on the carrier density.