A cavity optomechanical magneto-meter operating in the 100 pT range is reported. The device operates at earth field, achieves tens of megahertz bandwidth with 60 μm spatial resolution and microwatt optical-power requirements. These unique capabilities may have a broad range of applications including cryogen-free and microfluidic magnetic resonance imaging (MRI), and investigation of spin-physics in condensed matter systems.
View Article and Find Full Text PDFWe present the characterization of the recently developed cavity enhanced amplitude modulation laser absorption spectroscopy (CEAMLAS) technique to measure dissipation within the evanescent field of a whispering-gallery mode resonator, and demonstrate the parallel use of CEAMLAS and the Pound-Drever-Hall measurement techniques to provide both dissipation and dispersive real-time microresonator measurements. Using an atomic force microscope tip, we introduce a controlled perturbation to the evanescent field of the resonator. In this case, dissipative sensing allows up to 16.
View Article and Find Full Text PDFWe demonstrate a lock-in particle tracking scheme in optical tweezers based on stroboscopic modulation of an illuminating optical field. This scheme is found to evade low frequency noise sources while otherwise producing an equivalent position measurement to continuous measurement. This was demonstrated to yield up to 20 dB of noise suppression at both low frequencies (< 1 kHz), where low frequency electronic noise was significant, and around 630 kHz where laser relaxation oscillations introduced laser noise.
View Article and Find Full Text PDFCavity optoelectromechanical regenerative amplification is demonstrated. An optical cavity enhances mechanical transduction, allowing sensitive measurement even for heavy oscillators. A 27.
View Article and Find Full Text PDFWe present a laser amplitude modulation technique to actively stabilize the critical coupling of a microresonator by controlling the evanescent coupling gap from an optical fiber taper. It is a form of nulled lock-in detection, which decouples laser intensity fluctuations from the critical coupling measurement. We achieved a stabilization bandwidth of ∼ 20 Hz, with up to 5 orders of magnitude displacement noise suppression at 10 mHz, and an inferred gap stability of better than a picometer/√Hz.
View Article and Find Full Text PDFJ Opt Soc Am A Opt Image Sci Vis
December 2010
We present an experimental demonstration of an optical pattern recognition scheme based on spatial homodyne detection. Our scheme is adaptive, all-optical, utilizes a single-element photo-detector, and provides a single parameter readout to quantify the efficacy of pattern recognition, thereby allowing very fast pattern recognition speeds. The spatial homodyne detector was applied to the identification of one- and two-dimensional phase profiles.
View Article and Find Full Text PDFWe implement a cavity optoelectromechanical system integrating electrical actuation capabilities of nanoelectromechanical devices with ultrasensitive mechanical transduction achieved via intracavity optomechanical coupling. Electrical gradient forces as large as 0.40 microN are realized, with simultaneous mechanical transduction sensitivity of 1.
View Article and Find Full Text PDFThe next generation of optical data storage system beyond DVDs will use blue laser light and an objective lens with a high numerical aperture of 0.85 to increase storage capacity. Such high numerical aperture systems have an inherent higher sensitivity to aberrations.
View Article and Find Full Text PDFObjectives: To assess the potential of confocal laser scanning microscopy for imaging of the urinary bladder after intravesical instillation of a fluorescent dye.
Methods: The study was performed on the bladder of male Copenhagen rats. For confocal fluorescence microscopy (CFM), a standard confocal laser scanning microscope (Zeiss LSM 410) was used.