Spatiotemporal aberrations due to the groove density mismatching of compression gratings in ultra-intense femtosecond lasers.

The groove density mismatching of compression gratings, an often-neglected key issue, can induce significant spatiotemporal aberrations especially for super-intense femtosecond lasers. We mainly investigate the angular chirp and the consequent degradation of the effective focused intensity introduced by the groove density mismatching of compression gratings in ultra-intense femtosecond lasers. The results indicate that the tolerances of grating groove density mismatching will rapidly decrease with the beam aperture or spectral bandwidth increases.

Gigahertz electromagnetic pulse emission from femtosecond relativistic laser-irradiated solid targets.

The interactions between high-intensity laser and matter produce particle flux and electromagnetic radiation over a wide energy range. The generation of extremely intense transient fields in the radio frequency-microwave regime has been observed in femtosecond-to-nanosecond laser pulses with 10-10-W/cm intensity on both conductive and dielectric targets. These fields typically cause saturation and damage to electronic equipment inside and near an experimental chamber; nevertheless, they can also be effectively used as diagnostic tools.

Generation of 13.9-mJ Terahertz Radiation from Lithium Niobate Materials.

Extremely strong-field terahertz (THz) radiation in free space has compelling applications in nonequilibrium condensed matter state regulation, all-optical THz electron acceleration and manipulation, THz biological effects, etc. However, these practical applications are constrained by the absence of high-intensity, high-efficiency, high-beam-quality, and stable solid-state THz light sources. Here, the generation of single-cycle 13.

Angular dispersion compensation for ultra-broadband pulses by using a cascaded prism and hollow-core fiber configuration.

In this paper, we report that the angular dispersion of the output pulses in a nonlinear process can be efficiently compensated by using a cascaded prism(s) and short hollow-core fiber (HCF) configuration. Here, the prism(s) is used to suppress the angular dispersion and transform it into spatial chirp, while the HCF is used for removing this spatial chirp and the residual angular dispersion, which can also significantly improve the beam quality. The feasibility of this novel method is numerically and experimentally investigated with the ultra-broadband idler pulses centered at 1250 nm wavelength and generated by an LBO crystal based non-collinear optical parametric amplifier.

Investigation and suppression of pre-pulses on nanosecond time scale in the SULF-1PW laser.

It is of crucial significance to investigate and suppress pre-pulses on nanosecond time scale because the intense pre-plasma generated by them may have enough time to expand and, thus, cause fatal impact on laser-matter interactions. In this research, we analyze the potential origins of pre-pulses on nanosecond time scale in a typical Ti:sapphire chirped pulse amplification laser system. Based on the analysis, the initial status of these generated pre-pulses in the SULF-1PW laser is measured and investigated.

Performance improvement of a nonlinear temporal filter by using cascaded femtosecond optical parametric amplification.

In this paper, we report that the conversion efficiency and spectrum of femtosecond optical parametric amplification (fs-OPA) can be significantly enhanced by employing a compact cascaded femtosecond OPA (CF-OPA) scheme with the self-compensation of the temporal walk-off between two nonlinear gain media. Correspondingly, the gain related temporal contrast can also be improved. The feasibility of the CF-OPA method using three cascaded BBO crystals is numerically and experimentally analyzed.

A novel design of double chirped pulse amplification laser systems for fourth-order dispersion control.

A novel design of double chirped pulse amplification laser systems implementing a combination of negatively and positively chirped pulse amplification is proposed for the first time. Without utilizing any extra dispersion compensation element, this design can sufficiently cancel out the second-, third- and especially fourth-order dispersion simultaneously, just by optimizing the parameters of the stretcher and compressor in first chirped pulse amplification stage which applies negatively chirped pulse amplification. The numerical results indicate that near Fourier-transform-limited pulse duration about 20fs can be achieved in high-peak-power femtosecond laser systems up to multi-Petawatt level.