Alteration in HDEMG Spatial Parameters of Trunk Muscle Due to Handle Design during Pushing.

Previous research identifies that pushing and pulling is responsible for approximately 9-18% of all low back injuries. Additionally, the handle design of a cart being pushed can dramatically alter a worker's capacity to push (≅9.5%).

Effect of stiffness and movement speed on selected dynamic torque characteristics of hydraulic-actuation joystick controls for heavy vehicles.

The purpose of this work was to quantify the effects of joystick stiffness and movement speed on the dynamic torque characteristics of hydraulic-actuation joystick controls, as found in off-road vehicles, as one of the initial steps towards the development of a joystick design protocol. Using a previously developed mathematical model in which a hydraulic-actuation joystick is assumed to rotate about two axes where the rotation origin is a universal joint, the dynamic torque characteristics incurred by an operator were predicted. Utilizing a laboratory mock-up of an excavator cab environment, three actuation torque characteristics (peak torque, angular impulse and deceleration at the hard endpoint) were quantified for nine unskilled joystick operators during the use of a commonly used North American hydraulic-actuation joystick.

Bilateral isokinetic training reduces the bilateral leg strength deficit for both old and young adults.

The bilateral limb deficit (BLD) describes the difference in maximal or near-maximal force generating capacity of muscles when they are contracted alone and in combination with the contralateral muscles. This study examined the effects of a 6-week (three times per week) bilateral leg strength training programme on BLD in younger and older adults. Data were collected from 33 subjects during slow (45 degrees /s) isokinetic knee extensions and flexions before and after the training programme.