Particle Emissions from Laboratory Activities Involving Carbon Nanotubes.

This site study was conducted in a chemical laboratory to evaluate nanomaterial emissions from 20-30 nm diameter bundles of single-walled carbon nanotubes (CNTs) during product development activities. Direct-reading instruments were used to monitor the tasks in real time and airborne particles were collected using various methods to characterize released nanomaterials using electron microscopy and elemental carbon (EC) analyses. CNT clusters and a few high aspect ratio particles were identified as being released from some activities.

Nano-metal oxides: Exposure and engineering control assessment.

In January 2007, the National Institute for Occupational Safety and Health (NIOSH) conducted a field study to evaluate process specific emissions during the production of ENMs. This study was performed using the nanoparticle emission assessment technique (NEAT). During this study, it was determined that ENMs were released during production and cleaning of the process reactor.

Performance of Particulate Containment at Nanotechnology Workplaces.

The evaluation of engineering controls for the production or use of carbon nanotubes (CNTs) was investigated at two facilities. These controls assessments are necessary to evaluate the current status of control performance and to develop proper control strategies for these workplaces. The control systems evaluated in these studies included ventilated enclosures, exterior hoods, and exhaust filtration systems.

Airborne exposure patterns from a passenger source in aircraft cabins.

Airflow is a critical factor that influences air quality, airborne contaminant distribution, and disease transmission in commercial airliner cabins. The general aircraft-cabin air-contaminant transport effect model seeks to build exposure-spatial relationships between contaminant sources and receptors, quantify the uncertainty, and provide a platform for incorporation of data from a variety of studies. Knowledge of infection risk to flight crews and passengers is needed to form a coherent response to an unfolding epidemic, and infection risk may have an airborne pathogen exposure component.

The characterization of airborne occupational safety and health hazards in selected small businesses; manufacturing wood pallets.

Researchers from the National Institute for Occupational Safety and Health (NIOSH) investigated occupational safety and health concerns in the small business wood pallet manufacturing industry because of an injury rate (2000) 226% greater than that for general industry. NIOSH investigators conducted walk-through evaluations at seven wood pallet manufacturing companies, and returned to four of them to take environmental measurements. Carbon monoxide (CO) levels, noise levels, and total particulate were measured, ergonomic observations made, and occupational safety practices analyzed at each of the four facilities where measurements were taken.

Development of evaluation procedures for local exhaust ventilation for United States postal service mail-processing equipment.

Researchers from the National Institute for Occupational Safety and Health (NIOSH) have conducted several evaluations of local exhaust ventilation (LEV) systems for the United States Postal Service (USPS) since autumn 2001 when (a) terrorist(s) employed the mail system for acts of bioterrorism. As a part of the USPS 2002 Emergency Preparedness Plan, the development and installation of LEV onto USPS mail-processing equipment can reduce future exposures to operators from potentially hazardous contaminants, such as anthrax, which might be emitted during the processing of mail. This article describes how NIOSH field testing led to the development of recommended testing procedures for evaluations of LEV capture efficiency for mail-processing equipment, including tracer gas measurements, smoke release observations, air velocity measurements, and decay-rate testing under access hoods.