Quantitative, Dynamic Detection of Neuronal Na Transients Using Multi-photon Excitation and Fluorescence Lifetime Imaging (FLIM) in Acute Mouse Brain Slices.

Fluorescence lifetime imaging microscopy (FLIM) is a highly valuable technique in the fluorescence microscopy toolbox because it is essentially independent of indicator concentrations. Conventional fluorescence microscopy analyzes changes in emission intensity. In contrast, FLIM assesses the fluorescence lifetime, which is defined as the time a fluorophore remains in an excited state before emitting a photon.

Real-time data processing for serial crystallography experiments.

We report the use of streaming data interfaces to perform fully online data processing for serial crystallography experiments, without storing intermediate data on disk. The system produces Bragg reflection intensity measurements suitable for scaling and merging, with a latency of less than 1 s per frame. Our system uses the CrystFEL software in combination with the ASAP::O data framework.

Deep-Learning-Based Segmentation of Cells and Analysis (DL-SCAN).

With the recent surge in the development of highly selective probes, fluorescence microscopy has become one of the most widely used approaches to studying cellular properties and signaling in living cells and tissues. Traditionally, microscopy image analysis heavily relies on manufacturer-supplied software, which often demands extensive training and lacks automation capabilities for handling diverse datasets. A critical challenge arises if the fluorophores employed exhibit low brightness and a low signal-to-noise ratio (SNR).

Towards a validated glossary of usability attributes for the evaluation of wearable robotic devices.

Background: Despite technical advances in the field of wearable robotic devices (WRD), there is still limited user acceptance of these technologies. While usability often comes as a key factor influencing acceptance, there is a scattered landscape of definitions and scopes for the term. To advance usability evaluation, and to integrate usability features as design requirements during technology development, there is a need for benchmarks and shared terminology.

Direct Band Gap Semiconductors with Two- and Three-Dimensional Triel-Phosphide Frameworks (Triel=Al, Ga, In).

Recently, several ternary phosphidotrielates and -tetrelates have been investigated with respect to their very good ionic conductivity, while less focus was pointed towards their electronic structures. Here, we report on a novel series of compounds, in which several members possess direct band gaps. We investigated the known compounds LiAlP, LiGaP, LiInP, and NaInP and describe the synthesis and the crystal structure of novel NaInP.

Mixed methods usability evaluation of an assistive wearable robotic hand orthosis for people with spinal cord injury.

Background: Robotic hand orthoses (RHO) aim to provide grasp assistance for people with sensorimotor hand impairment during daily tasks. Many of such devices have been shown to bring a functional benefit to the user. However, assessing functional benefit is not sufficient to evaluate the usability of such technologies for daily life application.

Temperature-dependent photo-elastic coefficient of silicon at 1550 nm.

This paper presents a study on the temperature dependent photo-elastic coefficient in single-crystal silicon with (100) and (110) orientations at a wavelength of 1550 nm. The measurement of the photo-elastic coefficient was performed using a polarimetric scheme across a wide temperature range from 5 to 300 K. The experimental setup employed high-sensitivity techniques and incorporated automatic beam path correction, ensuring precise and accurate determination of the coefficient's values.

Design and validation of a novel online platform to support the usability evaluation of wearable robotic devices.

Wearable robotic devices (WRD) are still struggling to fulfill their vast potential. Inadequate daily life usability is one of the main hindrances to increased technology acceptance. Improving usability evaluation practices during the development of WRD could help address these limitations.

Usability of an exosuit in domestic and community environments.

Background: Exosuits have been shown to reduce metabolic cost of walking and to increase gait performance when used in clinical environment. Currently, these devices are transitioning to private use to facilitate independent training at home and in the community. However, their acceptance in unsupervised settings remains unclear.

Rapid and efficient room-temperature serial synchrotron crystallography using the CFEL TapeDrive.

Serial crystallography at conventional synchrotron light sources (SSX) offers the possibility to routinely collect data at room temperature using micrometre-sized crystals of biological macromolecules. However, SSX data collection is not yet as routine and currently takes significantly longer than the standard rotation series cryo-crystallography. Thus, its use for high-throughput approaches, such as fragment-based drug screening, where the possibility to measure at physio-logical temperatures would be a great benefit, is impaired.

An Analysis of Intention Detection Strategies to Control Advanced Assistive Technologies at the CYBATHLON.

With the increasing range of functionalities of advanced assistive technologies (AAT), reliable control and initiation of the desired actions become increasingly challenging for users. In this work, we present an analysis of current practices, user preferences, and usability of AAT intention detection strategies based on a survey among participants with disabilities at the CYBATHLON 2020 Global Edition. We collected data from 35 respondents, using devices in various disciplines and levels of technology maturity.

A Novel Mixed-Method Approach to Identify Needs and Requirements for Upper Limb Assistive Technology for Persons after Stroke.

Following stroke, a significant portion of individuals suffer from upper limb impairments and struggle with activities of daily living. Dedicated assistive technology (AT), such as robotic hand orthoses (RHO), can help facilitate upper limb usage and allow users to regain independence in their daily lives. Often, users' needs and requirements are neglected in AT design, thereby contributing to poor technology acceptance.

A survey on the influence of CYBATHLON on the development and acceptance of advanced assistive technologies.

Background: Advanced assistive technologies (AAT) aim to exploit the vast potential of technological developments made in the past decades to improve the quality of life of people with disabilities. Combining complex robotic technologies with the unique needs of people with disabilities requires a strong focus on user-centered design to ensure that the AAT appropriately addresses the daily life struggles of target users. The CYBATHLON aims to promote this mindset by empowering the AAT target users ("pilots") to compete on race tracks that represent approximations of daily life obstacles.

Intention Detection Strategies for Robotic Upper-Limb Orthoses: A Scoping Review Considering Usability, Daily Life Application, and User Evaluation.

Wearable robotic upper limb orthoses (ULO) are promising tools to assist or enhance the upper-limb function of their users. While the functionality of these devices has continuously increased, the robust and reliable detection of the user's intention to control the available degrees of freedom remains a major challenge and a barrier for acceptance. As the information interface between device and user, the intention detection strategy (IDS) has a crucial impact on the usability of the overall device.

Implementing an interprofessional user-centered design approach to develop a bedside leg exercise device.

Background: Early mobilization is important to improve critically ill patients' outcomes, but barriers to its implementation are common. A suitable in-bed device to exercise patients' legs might facilitate early mobilization.

Objective: The aim of this study was to develop an in-bed leg press that would facilitate early mobilization and enhance strength training of patients in acute care settings.

An analysis of usability evaluation practices and contexts of use in wearable robotics.

Background: User-centered design approaches have gained attention over the past decade, aiming to tackle the technology acceptance issues of wearable robotic devices to assist, support or augment human capabilities. While there is a consensus that usability is key to user-centered design, dedicated usability evaluation studies are scarce and clear evaluation guidelines are missing. However, the careful consideration and integration of user needs appears to be essential to successfully develop an effective, efficient, and satisfactory human-robot interaction.

Rapid Fluorescence Lifetime Imaging Reveals That TRPV4 Channels Promote Dysregulation of Neuronal Na in Ischemia.

Fluorescence imaging is an indispensable method for analysis of diverse cellular and molecular processes, enabling, for example, detection of ions, second messengers, or metabolites. Intensity-based approaches, however, are prone to artifacts introduced by changes in fluorophore concentrations. This drawback can be overcome by fluorescence lifetime imaging (FLIM) based on time-correlated single-photon counting.

Supertetrahedral polyanionic network in the first lithium phosphidoindate LiInP - structural similarity to LiSiP and LiGeP and dissimilarity to LiAlP and LiGaP.

Phosphide-based materials have been investigated as promising candidates for solid electrolytes, among which the recently reported LiAlP displays an ionic conductivity of 3 mS cm. While the phases Li-Al-P and Li-Ga-P have already been investigated, no ternary indium-based phosphide has been reported up to now. Here, we describe the synthesis and characterization of the first lithium phosphidoindate LiInP, which is easily accessible ball milling of the elements and subsequent annealing.

Exacerbation of Epilepsy by Astrocyte Alkalization and Gap Junction Uncoupling.

Seizures invite seizures. At the initial stage of epilepsy, seizures intensify with each episode; however, the mechanisms underlying this exacerbation remain to be solved. Astrocytes have a strong control over neuronal excitability and the mode of information processing.

Quasi-bound states in the continuum for deep subwavelength structural information retrieval for DUV nano-optical polarizers.

We demonstrate the retrieval of deep subwavelength structural information in nano-optical polarizers by scatterometry of quasi-bound states in the continuum (quasi-BICs). To this end, we investigate titanium dioxide wire grid polarizers for application wavelengths in the deep ultraviolet (DUV) spectral range fabricated with a self-aligned double-patterning process. In contrast to the time-consuming and elaborate measurement techniques like scanning electron microscopy, asymmetry induced quasi-BICs occurring in the near ultraviolet and visible spectral range provide an easily accessible and efficient probe mechanism.

Multimodal X-ray imaging of nanocontainer-treated macrophages and calcium distribution in the perilacunar bone matrix.

Studies of biological systems typically require the application of several complementary methods able to yield statistically-relevant results at a unique level of sensitivity. Combined X-ray fluorescence and ptychography offer excellent elemental and structural imaging contrasts at the nanoscale. They enable a robust correlation of elemental distributions with respect to the cellular morphology.

Manufacturing and Characterization of Femtosecond Laser-Inscribed Bragg Grating in Polymer Waveguide Operation in an IR-A Wavelength Range.

Optical sensors, such as fiber Bragg gratings, offer advantages compared to other sensors in many technological fields due to their outstanding characteristics. This sensor technology is currently transferred to polymer waveguides that provide the potential for cost-effective, easy, and flexible manufacturing of planar structures. While sensor production itself, in the majority of cases, is performed by means of phase mask technique, which is limited in terms of its degrees of freedom, other inscription techniques enable the manufacture of more adaptable sensor elements for a wider range of applications.