1.8 mJ pulses at 1560 nm based on a 55 µm core pure-erbium-doped VLMA fiber.

Despite the increasing demand for high-energy erbium lasers for LIDAR imaging applications, the scaling of the current Er-Yb co-doped technology is still hindered by a 1 µm parasitic emission. In this study, we present the first, to the best of our knowledge, utilization of the REPUSIL powder synthesis method to fabricate a 55 µm double-clad fiber with a remarkably large modal area. Doped solely with erbium and free of ytterbium, its estimated cladding absorption is 2 dB/m at 976 nm, enabling short amplification lengths.

40 W of supercontinuum generated by a self-pulsed pump-sharing oscillator-amplifier.

We demonstrate an all-fiber supercontinuum (SC) source delivering up to 40 W of average power ranging from 750 to 2200 nm. The laser source is based on a self-Q-switched pump-sharing oscillator-amplifier. The self-Q-switched master oscillator generates giant pulses, amplified in the high-power stage.

Noise analysis in a seeded four-wave mixing process generated in a photonic crystal fiber pumped by a chirped pulse.

Four-wave mixing is investigated when chirped pump and signal pulses are injected in a photonic crystal fiber. The shot-to-shot stability of the amplified coherent signal was measured by using the dispersive Fourier transform method and compared with numerical simulations. We highlight that the signal-to-noise ratio (SNR) of the pulsed signal increases with the injected power and show that it is not deteriorated through the amplification when the fiber optical parametric amplifier is strongly saturated.

Few-cycle all-fiber supercontinuum laser for ultrabroadband multimodal nonlinear microscopy.

Temporally coherent supercontinuum sources constitute an attractive alternative to bulk crystal-based sources of few-cycle light pulses. We present a monolithic fiber-optic configuration for generating transform-limited temporally coherent supercontinuum pulses with central wavelength at 1.06 µm and duration as short as 13.

Design and fabrication of dispersion controlled highly nonlinear fibers for far-detuned four-wave mixing frequency conversion.

We report on the conception, fabrication and characterization of a new concept of optical fiber enabling a precise control of the ratio between the 2 and 4-order of chromatic dispersion (respectively β and β) at 1.55 µm which is at the heart of the Four-Wave-Mixing (FWM) generation. For conventional highly nonlinear fiber the sensitivity of this ratio to fiber geometry fluctuations is very critical, making the fabrication process challenging.

Pre-compensation of thermally induced refractive index changes in a depressed core fully aperiodic large-pitch fiber for high average power operation.

To prevent the thermally induced spatial beam degradation occurring in high-power fiber lasers and amplifiers, index-depressed core "fully aperiodic large-pitch fibers" (FA-LPFs) have been designed and fabricated. In contrast to previous experimental works performed on FA-LPFs, in which the active core and the surrounding cladding material are quasi-index-matched, the core refractive index is in slight depression compared to the surrounding material (≈-3×10). Thus, the index-depressed fiber core tends first to behave as an anti-guide, preventing light from being properly guided into it.

Spectral correlation of four-wave mixing generated in a photonic crystal fiber pumped by a chirped pulse.

We report the spectral distribution of the parametric process generated in a photonic crystal fiber pumped by a chirped pulse. The spectral correlation of four-wave mixing has been measured using the dispersive Fourier transform method. From statistical analysis of multiple shot-to-shot spectral measurements, the spectral correlation between the signal and idler photons reveals physical insights into the particular portion of the pump spectrum responsible for generating the four-wave mixing.

Widely tunable Q-switched dual-wavelength synchronous-pulsed Tm-doped fiber laser emitting in the 2 μm region.

We demonstrate a widely tunable Q-switched dual-wavelength fiber laser emitting synchronized pulses in the 2 μm spectral range. Owing to the use of a Tm-doped rod-type fully aperiodic large pitch fiber, together with an acousto-optic modulator and two volume Bragg gratings (VBGs), the wavelength separation was shown to be continuously tunable from 1 to 120 nm (∼0.1-10  THz).

Polarization-maintaining Yb-doped large-mode-area fully aperiodic large-pitch fibers.

Based on a special large-pitch architecture that has already proved its single-mode single-polarization behavior in a passive configuration, two ytterbium-doped versions of such large-mode-area fibers have been fabricated and tested in both laser and amplification configurations for high-power laser source applications. Due to the high sensitivity of large-pitch fiber design to the active-core-to-passive-cladding index mismatch, the realization of a single-polarization structure is highly challenging. However, we report on the preservation of a polarization-maintaining feature.

Comparison between Different Structures of Suspended-Core Microstructured Optical Fibers for Volatiles Sensing.

In this paper, different core structures of microstructured optical fibers (MOFs) for low-finesse Fabry⁻Pérot (FP) sensors are experimentally compared to get the highest sensitivity. These devices are designed for volatile organic compounds (VOCs) measurements. Indium tin oxide (ITO) thin films were deposited by sputtering on the MOFs and different optical fast Fourier transform (FFT) phase responses from the FP were measured for saturated atmospheres of ethanol.

High-power widely tunable ps source in the visible light based on four wave mixing in optimized photonic crystal fibers.

We present a detailed study on the generation of widely tunable visible light through four wave mixing in specifically designed micro-structured fibers. The fiber's properties are optimized for an efficient conversion to the visible and near infrared with a combined tunability from 620 to 910 nm of a picosecond Yb-doped tunable source for biomedical applications.

Experimental study of the mode instability onset threshold in high-power FA-LPF lasers.

We report here on an experimental investigation of the temporal behavior of transverse mode instabilities into "fully aperiodic large-pitch fibers" (FA-LPFs) operated in high-power continuous-wave laser configuration. To ensure an effective transverse single-mode emission into FA-LPFs, a perfect index matching between the active core and the background cladding materials (Δn=0) is required. The original design of such fibers enables an effective transverse single-mode emission by strengthening the higher-order mode delocalization out of the gain region, even for high heat load levels, consequently leading to the improvement of the beam spatial quality.

140 μm single-polarization passive fully aperiodic large-pitch fibers operating near 2 μm.

In this paper, we demonstrate a single-polarization feature out of passive very-large-mode-area fully aperiodic large-pitch fibers. It has been previously shown theoretically that one of the two polarizations of the fundamental mode is selectively coupled to a cladding mode. This coupling does not require fiber bending, which permits us to avoid any decrease in mode effective area.

Study of Optical Fiber Sensors for Cryogenic Temperature Measurements.

In this work, the performance of five different fiber optic sensors at cryogenic temperatures has been analyzed. A photonic crystal fiber Fabry-Pérot interferometer, two Sagnac interferometers, a commercial fiber Bragg grating (FBG), and a π-phase shifted fiber Bragg grating interrogated in a random distributed feedback fiber laser have been studied. Their sensitivities and resolutions as sensors for cryogenic temperatures have been compared regarding their advantages and disadvantages.

Broadband single-mode single-polarization passive fully aperiodic large-pitch fibers.

Two evolutions of fully aperiodic large-pitch fiber designs employing few stress-applying parts are presented. The induced elasto-optic stress discriminates the two orthogonal polarization modes (LP and LP) of the fundamental mode, selectively delocalizing one of them into the cladding via a suitable coupling to one or several cladding modes. This ensures the propagation of a single linear polarization mode.

Precompensation of the thermal-induced refractive index changes into a fully aperiodic LPF for heat load resilience.

In this paper, a strategy consisting of precompensating the thermal-induced transverse refractive index changes is undertaken to push further the appearance threshold of a multimode regime. First, a standard air-silica large pitch fiber (LPF) and a fully aperiodic large pitch fiber are confronted in regard to their heat load resilience and capabilities for single-mode emission. Thereafter, slight refractive index depressions are judiciously introduced into the active core area.

Demonstration of a homogeneous Yb-doped core fully aperiodic large-pitch fiber laser.

The first demonstration of a 40 μm core homogeneously ytterbium-doped fully aperiodic large-pitch fiber laser, to the best of our knowledge, is reported here. In this concept, the amplification of unwanted high-order modes is prevented by means of an aperiodic inner-cladding structure, while the core and inner-cladding material has a higher refractive index than pure silica. In a laser configuration, up to 252 W of extracted power, together with an optical-to-optical efficiency of 63% with respect to the incident pump power, have been achieved.

50.4% slope efficiency thulium-doped large-mode-area fiber laser fabricated by powder technology.

We report on a triple clad large-mode-area Tm-doped fiber laser with 18 μm core diameter manufactured for the first time by an alternative manufacturing process named REPUSIL. This reactive powder sinter material enables similar properties compared to conventional CVD-made fiber lasers, while offering the potential of producing larger and more uniform material. The fiber characterization in a laser configuration provides a slope efficiency of 47.

Experimental and numerical characterization of a hybrid Fabry-Pérot cavity for temperature sensing.

A hybrid Fabry-Pérot cavity sensing head based on a four-bridge microstructured fiber is characterized for temperature sensing. The characterization of this cavity is performed numerically and experimentally in the L-band. The sensing head output signal presents a linear variation with temperature changes, showing a sensitivity of 12.

Highly efficient higher-order modes filtering into aperiodic very large mode area fibers for single-mode propagation.

We report here on the first experimental demonstration, to the best of our knowledge, of a new generation of very large mode area (VLMA) fibers intended to strengthen single-mode propagation. The originality of this work relies on an aperiodicity of the inner cladding microstructuration exacerbating the spatial rejection of higher-order-modes (HOMs) while preserving a significant confinement of the fundamental mode. The single-mode behavior was demonstrated using an optical low-coherence interferometry measurement based on the group-velocity dispersion.

Evaporation of volatile compounds in suspended-core fibers.

A sensing configuration for fluid evaporation monitoring using a suspended-core fiber tip is proposed. Strong differences between the evaporation processes of acetone and isopropyl alcohol were observed, both in terms of the signal's intensity fluctuations and total duration. In each fluid, the main signal variations were due to changes in reflectivity inside a collapsed region of the suspended-core fiber near the spliced interface with a standard single-mode fiber.

Generation and confinement of microwave gas-plasma in photonic dielectric microstructure.

We report on a self-guided microwave surface-wave induced generation of ~60 μm diameter and 6 cm-long column of argon-plasma confined in the core of a hollow-core photonic crystal fiber. At gas pressure of 1 mbar, the micro-confined plasma exhibits a stable transverse profile with a maximum gas-temperature as high as 1300 ± 200 K, and a wall-temperature as low as 500 K, and an electron density level of 10¹⁴ cm⁻³. The fiber guided fluorescence emission presents strong Ar⁺ spectral lines in the visible and near UV.

Inner cladding microstructuration based on symmetry reduction for improvement of singlemode robustness in VLMA fiber.

Very large mode area, active optical fibers with a low high order mode content in the actively doped core region were designed by removing the inner cladding symmetry. The relevance of the numerical approach is demonstrated here by the investigation of a standard air-silica Large Pitch Fiber, used as a reference. A detailed study of all-solid structures is also performed.

Highly birefringent photonic bandgap Bragg fiber loop mirror for simultaneous measurement of strain and temperature.

A highly birefringent photonic bandgap Bragg fiber loop mirror configuration for simultaneous measurement of strain and temperature is proposed. The group birefringence and the sharp loss peaks are observable in the spectral response. Because the sensing head presents different sensitivities for strain and temperature measurands, these physical parameters can be discriminated by using the matrix method.

Simplified hollow-core photonic crystal fiber.

An original design of hollow-core photonic crystal fiber composed of a thin silica ring suspended in air by six silica struts is proposed. This structure can be viewed as a simplified Kagomé-lattice fiber reduced to one layer of air holes. By working on the core surround parameters, an efficient antiresonant air guiding was successfully demonstrated.