Stimuli-Responsive Hybrid Polymer for Enhanced Solid-Liquid Separation of Industrial Effluents.

In the current study, a novel stimuli-responsive hybrid polymer with aluminum hydroxide colloids incorporated into a cationic copolymer of N-isopropylacrylamide and N-[3-(dimethylamino)propyl]methacrylamide was synthesized to enhance the settling and filtration performance of fine clay suspensions. The conformation of the synthesized hybrid copolymer was shown to respond to changes in both temperature and pH. Compared with a cationic copolymer of similar structure without aluminum hydroxide colloids, settling and filtration rates were significantly enhanced using the hybrid copolymer, which is attributed to the synergy between the inorganic aluminum hydroxide cores and organic copolymer.

Measurement and modeling on hydrodynamic forces and deformation of an air bubble approaching a solid sphere in liquids.

The interaction between bubbles and solid surfaces is central to a broad range of industrial and biological processes. Various experimental techniques have been developed to measure the interactions of bubbles approaching solids in a liquid. A main challenge is to accurately and reliably control the relative motion over a wide range of hydrodynamic conditions and at the same time to determine the interaction forces, bubble-solid separation and bubble deformation.

Nonmonotonous variation of DNA angular separation during asymmetric pulsed field electrophoresis.

Asymmetric pulsed field electrophoresis within crystalline arrays is used to generate angular separation of DNA molecules. Four regimes of the frequency response are observed, a low frequency rise in angular separation, a plateau, a subsequent decline, and a second plateau at higher frequencies. It is shown that the frequency response for different sized DNA is governed by the relation between pulse time and the reorientation time of DNA molecules.

Interaction of divalent cations with basal planes and edge surfaces of phyllosilicate minerals: muscovite and talc.

Smooth basal plane and edge surfaces of two platy phyllosilicate minerals (muscovite and talc) were prepared successfully to allow accurate colloidal force measurement using an atomic force microscope (AFM), which allowed us to probe independently interactions of divalent cations with phyllosilicate basal planes and edge surfaces. The Stern potential of basal planes and edge surfaces was obtained by fitting the measured force profiles with the classical DLVO theory. The fitted Stern potential of the muscovite basal plane became less negative with increasing Ca(2+) or Mg(2+) concentration but did not reverse its sign even at Ca(2+) or Mg(2+) concentrations up to 5 mM.

A systematic evaluation of the role of crystalline order in nanoporous materials on DNA separation.

The role of order within a porous separation matrix on the separation efficiency of DNA was studied systematically. DNA separation was based on a ratchet mechanism. Monodisperse colloidal suspensions of nanoparticles were used to fabricate highly ordered separation media with a hexagonal close-packed structure.

Determination of anisotropic surface characteristics of different phyllosilicates by direct force measurements.

To fundamentally understand the electrokinetic behavior of clay minerals, it is necessary to study the anisotropic surface charge properties of clay surfaces. In this study, two 2:1 layer natural minerals, talc and muscovite, were chosen as representatives of magnesium and aluminum phyllosilicate minerals, respectively. The molecularly smooth basal planes of both platy minerals were obtained by cleavage along the basal planes, while suitable edge surfaces were prepared by an ultramicrotome cutting technique.

Flocculation kinetics and aggregate structure of kaolinite mixtures in laminar tube flow.

Flocculation is commonly used in various solid-liquid separation processes in chemical and mineral industries to separate desired products or to treat waste streams. This paper presents an experimental technique to study flocculation processes in laminar tube flow. This approach allows for more realistic estimation of the shear rate to which an aggregate is exposed, as compared to more complicated shear fields (e.

Mechanistic study on demulsification of water-in-diluted bitumen emulsions by ethylcellulose.

In our previous study, ethylcellulose (EC), an effective, nontoxic, and biodegradable natural polymer, was found effective in dewatering water-in-diluted bitumen emulsions. In this study, the demulsification mechanism of water-in-diluted bitumen emulsions by EC is investigated. In situ experiments using a micropipet apparatus provided direct evidence on both flocculation and coalescence of water droplets in diluted bitumen by EC.

Study of Al(OH)3-polyacrylamide-induced pelleting flocculation by single molecule force spectroscopy.

A nanocomposite polymer, Al(OH)3-polyacrylamide (Al-PAM) hybrid, was tested as a flocculant. This novel hybrid polymer was found to induce pellet-like floccules, leading to a more effective solid-liquid separation than common polyacrylamide (PAM)-based flocculants. To understand the mechanism of Al-PAM-induced pelleting flocculation, the molecular structure of this hybrid polymer was studied using an atomic force microscope (AFM).

Probing surface charge potentials of clay basal planes and edges by direct force measurements.

The dispersion and gelation of clay suspensions have major impact on a number of industries, such as ceramic and composite materials processing, paper making, cement production, and consumer product formulation. To fundamentally understand controlling mechanisms of clay dispersion and gelation, it is necessary to study anisotropic surface charge properties and colloidal interactions of clay particles. In this study, a colloidal probe technique was employed to study the interaction forces between a silica probe and clay basal plane/edge surfaces.

Analysis of electroosmotic flow of power-law fluids in a slit microchannel.

Electroosmotic flow of power-law fluids in a slit channel is analyzed. The governing equations including the linearized Poisson-Boltzmann equation, the Cauchy momentum equation, and the continuity equation are solved to seek analytical expressions for the shear stress, dynamic viscosity, and velocity distribution. Specifically, exact solutions of the velocity distributions are explicitly found for several special values of the flow behavior index.

Electrokinetic Phenomena in concentrated disperse systems: general problem formulation and Spherical Cell Approach.

Electrokinetic Phenomena in concentrated disperse and colloid systems have been studied employing Spherical Cell Approach for over three decades. The critical review of the advances in this area, which is conducted in the present paper, demonstrates a number of contradictions between the results reported by different authors. These contradictions are largely associated with imposition of boundary conditions at the outer boundary of the representative Spherical Cell.

Single molecule force spectroscopy of asphaltene aggregates.

Asphaltene aggregation and deposition cause severe problems in nearly all phases of petroleum processing. To resolve those problems, understanding the aggregation mechanisms is a prerequisite and has attracted the interest of a great number of investigators. However, to date, the nature and extent of asphaltene aggregation remain widely debated.

Stability and disintegration of ultrathin heptane films in water: molecular dynamics simulations.

Molecular dynamics simulations of ultrathin heptane films (less than 5 nm in thickness) in water were conducted to study their stability and disintegration behavior. The density distributions of heptane and water molecules across the film were determined for different equilibrium film thicknesses ranging from 1.5 to 4 nm.

Particle deposition onto charge heterogeneous surfaces: convection-diffusion-migration model.

The role of surface charge heterogeneity of planar collectors on particle deposition and distribution was investigated in the vicinity of a heterogeneous surface for a radial impinging jet flow geometry. The charge heterogeneity was modeled as concentric circular stripes bearing different surface charges. Particle deposition was studied employing the Eulerian approach (convection-diffusion-migration equation).

Colloidal interactions between Langmuir-Blodgett bitumen films and fine solid particles.

In oil sand processing, accumulation of surface-active compounds at various interfaces imposes a significant impact on bitumen recovery and bitumen froth cleaning (i.e., froth treatment) by altering the interfacial properties and colloidal interactions among various oil sand components.

Spherical cell approach for the effective viscosity of suspensions.

In the present paper, the spherical cell approach is employed for addressing the effective viscosity of suspensions of spherical particles. The proposed derivation is based on the only assumption which constitutes the essence of the spherical cell approach: a representative part of the suspension is a spherical cell which contains a particle surrounded by the continuous phase. In contrast with the previous studies on this topic, no additional assumptions are used in the present analysis.

Adhesion of single polyelectrolyte molecules on silica, mica, and bitumen surfaces.

In a recent study (Energy Fuels 2005, 19, 936), a partially hydrolyzed polyacrylamide (HPAM) was used as a process aid to recover bitumen from oil sand ores. It was found that HPAM addition at the bitumen extraction step not only improved bitumen recovery but also enhanced fine solids settling in the tailings stream. To understand the role of HPAM, single-molecule force spectroscopy was employed for the first time to measure the desorption/adhesion forces of single HPAM molecules on silica, mica, and bitumen surfaces using an atomic force microscope (AFM).

Sandwich structures at oil-water interfaces under alkaline conditions.

Equilibrium liquid crystal (LC) layer on an interface between crude oils and water was observed at high pH. This layer is composed mainly of sodium naphthenates produced in situ at the water/oil interface. Transient LC layer was also evolved at the interface of aqueous phase of sodium hydroxide solutions and oleic phase of naphthenic acid (NA) solutions as result of a chemical reaction between NaOH and NA.

Emulsion stability based on phase behavior in sodium naphthenates containing systems: gels with a high organic solvent content.

Addition of heptane to a sodium naphthenates/toluene/water system at 25 degrees C reduces the lamellar liquid-crystal phase range and increases the microemulsion phase range. Both of these effects result in the extension of the composition range where emulsions have low stability. This effect is even stronger at 40 degrees C.

Acoustic and electroacoustic spectroscopy of water-in-diluted-bitumen emulsions.

Water-in-oil emulsions of Athabasca bitumen diluted with toluene have been studied using the latest advances in acoustic and electroacoustic spectroscopy. From the sound attenuation spectra of emulsions, the water droplet size distribution is measured. The electrical surface charge density of the water droplets is obtained from the colloid vibration current.

Adsorption of bituminous components at oil/water interfaces investigated by quartz crystal microbalance: implications to the stability of water-in-oil emulsions.

Silica-gel-coated QCM crystals oscillating in a thickness shear mode are used to measure adsorption of bituminous components in water-saturated heptol (1/1 vol ratio of a heptane/toluene mixture) at the oil/water interface. In addition to the viscoelasticity of the adsorbed film, the effects of the bulk liquid density and viscosity as well as the liquid trapped in interfacial cavities are taken into account for the calculation of adsorbed mass. Asphaltenes in heptol adsorb continuously at the oil/water interface, while resins (the surface-active species in maltenes) show adsorption saturation in the same solvent.

Particle deposition onto micropatterned charge heterogeneous substrates: trajectory analysis.

A trajectory analysis of particles near a micropatterned charged substrate under radial impinging jet flow conditions is presented to investigate the effect of surface charge heterogeneity on particle trajectory and deposition efficiency. The surface charge heterogeneity is modeled as concentric bands of specified width and pitch having positive and negative surface potentials. The flow distribution is obtained using finite element analysis of the governing Navier-Stokes equations.

Simulations of a dielectrophoretic membrane filtration process for removal of water droplets from water-in-oil emulsions.

A novel separation technique based on simultaneous application of AC dielectrophoresis and preferential transport through a semipermeable hydrophilic membrane is proposed for separation of small amounts of emulsified water droplets from a water-in-oil emulsion. Embedding an array of parallel microelectrodes on a membrane matrix, followed by application of an AC potential to these electrodes, can result in capturing the water droplets onto the membranes from the emulsion during a crossflow filtration process. The present paper describes the theoretical principles underlying such a process, and describes a simple mathematical framework based on trajectory analysis for assessing the separation efficiency of such a technique.