Melt granulation in fluidized bed: a comparative study of spray-on versus in situ procedure.

Objective: The aim of this study was to investigate the influence of process parameters, binder content and binder addition method on characteristics of the granules obtained by melt granulation (MG) in fluidized bed.

Methods: Spray-on experiments were performed according to 2(3) full factorial design. The effect of binder content, molten binder feed rate, and spray air pressure on granule size and size distribution, granule shape, flowability and drug release rate was investigated.

Design space approach in optimization of fluid bed granulation and tablets compression process.

The aim of this study was to optimize fluid bed granulation and tablets compression processes using design space approach. Type of diluent, binder concentration, temperature during mixing, granulation and drying, spray rate, and atomization pressure were recognized as critical formulation and process parameters. They were varied in the first set of experiments in order to estimate their influences on critical quality attributes, that is, granules characteristics (size distribution, flowability, bulk density, tapped density, Carr's index, Hausner's ratio, and moisture content) using Plackett-Burman experimental design.

An investigation into the effect of formulation variables and process parameters on characteristics of granules obtained by in situ fluidized hot melt granulation.

The aim of this study was to investigate the influence of binder content, binder particle size, granulation time and inlet air flow rate on granule size and size distribution, granule shape and flowability, as well as on drug release rate. Hydrophilic (polyethyleneglycol 2000) and hydrophobic meltable binder (glyceryl palmitostearate) were used for in situ fluidized hot melt granulation. Granule size was mainly influenced by binder particle size.