Production of bio-fuels by high temperature pyrolysis of sewage sludge using conventional and microwave heating.

The pyrolysis of sewage sludge was investigated using microwave and electrical ovens as the sources of heat, and graphite and char as microwave absorbers. The main objective of this work was to maximize the gas yield and to assess its quality as a fuel and as a source of hydrogen or syngas (H2 + CO). Both gases were produced in a higher proportion by microwave pyrolysis than by conventional pyrolysis, with a maximum value of 38% for H2 and 66% for H2 + CO.

Gas chromatographic-mass spectrometric study of the oil fractions produced by microwave-assisted pyrolysis of different sewage sludges.

The pyrolysis of sewage sludge was studied in a microwave oven using graphite as microwave absorber. The pyrolysis temperature ranged from 800 to 1000 degrees C depending on the type of sewage sludge. A conventional electrical furnace was also employed in order to compare the results obtained with both methods.

Microwave-induced pyrolysis of sewage sludge.

This paper describes a new method for pyrolyzing sewage sludge using a microwave furnace. It was found that if just the raw wet sludge is treated in the microwave, only drying of the sample takes place. However, if the sludge is mixed with a small amount of a suitable microwave absorber (such as the char produced in the pyrolysis itself) temperatures of up to 900 degrees C can be achieved, so that pyrolysis takes place rather than drying.