Langmuir-Blodgett Films with Immobilized Glucose Oxidase Enzyme Molecules for Acoustic Glucose Sensor Application.

In this work, a sensitive coating based on Langmuir-Blodgett (LB) films containing monolayers of 1,2-dipalmitoyl-sn-glycero-3-phosphoethanolamine (DPPE) with an immobilized glucose oxidase (GOx) enzyme was created. The immobilization of the enzyme in the LB film occurred during the formation of the monolayer. The effect of the immobilization of GOx enzyme molecules on the surface properties of a Langmuir DPPE monolayer was investigated.

Langmuir-Blodgett Films of Arachidic and Stearic Acids as Sensitive Coatings for Chloroform HF SAW Sensors.

Properties of the Langmuir-Blodgett (LB) films of arachidic and stearic acids, versus the amount of the films' monolayers were studied and applied for chloroform vapor detection with acoustoelectric high-frequency SAW sensors, based on an AT quartz two-port Rayleigh type SAW resonator (414 MHz) and ST-X quartz SAW delay line (157.5 MHz). Using both devices, it was confirmed that the film with 17 monolayers of stearic acid deposited on the surface of the SAW delay line at a surface pressure of 30 mN/m in the solid phase has the best sensitivity towards chloroform vapors, compared with the same films with other numbers of monolayers.

Morphology of Mixed Langmuir and Langmuir-Schaefer Monolayers with Covered CdSe/CdS/ZnS Quantum Dots and Arachidic Acid.

The process of formation of a Langmuir-Schaefer (LS) matrix based on a mixed monolayer of arachidic acid (AA) and 8 nm CdSe/CdS/ZnS quantum dots (QDs) stabilized by molecules of trioctylphosphine oxide (TOPO) was investigated. The change in the morphology, monolayer compressibility, and area per elementary cell of the created mixed monolayers, depending on the ratio of the components, was studied. It is shown that the change in the morphology of Langmuir-Blodgett (LB) monolayers begins to occur at a ratio between the number of QDs and AA molecules of 1:24.