Linear Micro-patterned Drug Eluting Balloon (LMDEB) for Enhanced Endovascular Drug Delivery.

In-stent restenosis (ISR) often occurs after applying drug eluting stents to the blood vessels suffering from atherosclerosis or thrombosis. For treatment of ISR, drug eluting balloons (DEB) have been developed to deliver anti-proliferative drugs to the lesions with ISR. However, there are still limitations of DEB such as low drug delivery efficiency and drug loss to blood flow.

Transfer-molded wrappable microneedle meshes for perivascular drug delivery.

After surgical procedures such as coronary/peripheral bypass grafting or endarterectomy for the treatment of organ ischemia derived from atherosclerosis, intimal hyperplasia (IH) which leads to restenosis or occlusion at the site of graft anastomosis frequently occurs. In order to inhibit IH caused by abnormal growth of smooth muscle cells (SMCs) in tunica media, various perivascular drug delivery devices are reported for delivery of anti-proliferation drugs into vascular tissue. However, there still remain conflicting requirements such as local and unidirectional delivery vs device porosity, and conformal tight device installation vs pulsatile expansion and constriction of blood vessels.

A Biodegradable Microneedle Cuff for Comparison of Drug Effects through Perivascular Delivery to Balloon-Injured Arteries.

Restenosis at a vascular anastomosis site is a major cause of graft failure and is difficult to prevent by conventional treatment. Perivascular drug delivery has advantages as drugs can be diffused to tunica media and subintima while minimizing the direct effect on endothelium. This in vivo study investigated the comparative effectiveness of paclitaxel, sirolimus, and sunitinib using a perivascular biodegradable microneedle cuff.

Impact insertion of transfer-molded microneedle for localized and minimally invasive ocular drug delivery.

It has been challenging for microneedles to deliver drugs effectively to thin tissues with little background support such as the cornea. Herein, we designed a microneedle pen system, a single microneedle with a spring-loaded microneedle applicator to provide impact insertion. To firmly attach solid microneedles with 140 μm in height at the end of macro-scale applicators, a transfer molding process was employed.

Rapid and repeatable fabrication of high A/R silk fibroin microneedles using thermally-drawn micromolds.

Thermal drawing is a versatile rapid prototyping method that can freely form microneedle (MN) structures with ultra-high aspect ratio without relying on any complex and expensive process. However, it is still challenging to repeatedly produce MNs with identical shapes using this thermal drawing due to small fluctuations in processing conditions such as temperatures, drawing speeds, drawing heights, or parallelism in the drawing setup. In addition, thermal drawing is only applicable to thermoplastic materials and most natural biomaterials are incompatible with this method.