Far field energy distribution control using a coherent beam combining femtosecond digital laser.

We report on far field energy distribution control using a coherent beam combining femtosecond digital laser employing 61 tiled channels. Each channel is considered as an individual pixel where amplitude and phase are controlled independently. Applying a phase difference between neighboring fibers or neighboring fiber-lines gives high agility for far field energy distribution and paves the way for deeper exploration of phase patterns as a tool to further improve tiled-aperture CBC laser efficiency and far field shaping on demand.

Phase noise measurements and diagnoses of a large array of fiber lasers by PISTIL.

One of the most promising solutions to access high power laser chains is to achieve a coherent combination of a large number of elementary lasers. To interfere constructively, these laser sources should be identical and operate under the same conditions. However, despite these efforts, differential delays appear in the course of time, which must be compensated for.

Orbital angular momentum beams generation from 61 channels coherent beam combining femtosecond digital laser.

We report on the use of a 61 beamlets coherent beam combination femtosecond fiber amplifiers as a digital laser source to generate high-power orbital angular momentum beams. Such an approach opens the path for higher-order non-symmetrical user-defined far field distributions.

Coherent beam combining of 61 femtosecond fiber amplifiers.

We report on the coherent beam combining of 61 femtosecond fiber chirped-pulse amplifiers in a tiled-aperture configuration along with an interferometric phase measurement technique. Relying on coherent beam recombination in the far field, this technique appears suitable for the combination of a large number of fiber amplifiers. The 61 output beams are stacked in a hexagonal arrangement and collimated through a high fill factor hexagonal micro-lens array.

Coherent beam combining of seven fiber chirped-pulse amplifiers using an interferometric phase measurement.

Coherent beam combining in tiled-aperture configuration is demonstrated on seven femtosecond fiber amplifiers using an interferometric phase measurement technique. The residual phase error between two fibers is as low as λ/55 RMS and a combination efficiency of 48% has been achieved. The combined pulses are compressed to 216 fs, delivering 71 W average power at a repetition rate of 55 MHz.

Phase evolution of the direct detection noise figure of a nondegenerate fiber phase-sensitive amplifier.

We experimentally investigate the evolution of the direct detection noise figure of a nondegenerate phase-sensitive amplifier based on a nonlinear fiber, as a function of the relative phase between the signal, idler, and pump, all other parameters remaining fixed. The use of a fiber with a high stimulated Brillouin scattering threshold permits us to investigate the full range of phase-sensitive gain and noise figure without pump dithering. Good agreement is found with theory, both for signal only and combined signal and idler direct detections.

Ultra-low noise dual-frequency VECSEL at telecom wavelength using fully correlated pumping.

An ultra-low intensity and beatnote phase noise dual-frequency vertical-external-cavity surface-emitting laser is built at telecom wavelength. The pump laser is realized by polarization combining two single-mode fibered laser diodes in a single-mode fiber, leading to a 100% in-phase correlation of the pump noises for the two modes. The relative intensity noise is lower than -140  dB/Hz, and the beatnote phase noise is suppressed by 30 dB, getting close to the spontaneous emission limit.

Optimization of a degenerate dual-pump phase-sensitive optical parametric amplifier for all-optical regenerative functionality.

We present a thorough investigation aimed at the optimization of a phase-sensitive optical parametric amplifier capable of simultaneous phase and amplitude regeneration. The regeneration potential, quantified in terms of the phase-sensitive extinction ratio, has been carefully assessed by a scalar model involving high-order waves associated with high-order four-wave mixing processes, going beyond the usual three-wave approach. Additionally, this model permits to unveil the physics involved in the high-order waves assisted regeneration.

Investigation of degenerate dual-pump phase sensitive amplifier using multi-wave model.

Operation of a degenerate dual-pump phase sensitive amplifier (PSA) is thoroughly numerically investigated using a multi-wave model, taking into account high-order waves associated with undesired four-wave mixing (FWM) processes. More accurate phase-sensitive signal gain characteristics are obtained compared to the conventional 3-wave model, leading to precise optimization of the pump configuration in a degenerate dual-pump PSA. The signal gain for different pump configurations, as well as the phase sensitivity, is obtained and interpreted by investigating the dominant FWM processes in terms of the corresponding phase matching.

UV-induced Bragg grating inscription into single-polarization all-solid hybrid microstructured optical fiber.

We demonstrate a single-polarization all-solid hybrid microstructured optical fiber with a UV-induced Bragg grating. A strong (∼20 dB) UV-induced Bragg grating was inscribed within the 30 nm-wide single-polarization window of the fiber, producing polarized Bragg reflection. The sharp band-edge cutoff allows a large polarization-extinction ratio of the Bragg reflection.

Source coherence impairments in a direct detection direct sequence optical code-division multiple-access system.

We demonstrate that direct sequence optical code- division multiple-access (DS-OCDMA) encoders and decoders using sampled fiber Bragg gratings (S-FBGs) behave as multipath interferometers. In that case, chip pulses of the prime sequence codes generated by spreading in time-coherent data pulses can result from multiple reflections in the interferometers that can superimpose within a chip time duration. We show that the autocorrelation function has to be considered as the sum of complex amplitudes of the combined chip as the laser source coherence time is much greater than the integration time of the photodetector.