Headspace solid-phase microextraction based on the metal-organic framework CIM-80(Al) coating to determine volatile methylsiloxanes and musk fragrances in water samples using gas chromatography and mass spectrometry.

A headspace solid-phase microextraction (HS-SPME) method was developed using the metal-organic framework (MOF) CIM-80(Al) as extraction phase and in combination with gas chromatography-mass spectrometry (GC-MS) for the simultaneous determination of 6 methylsiloxanes and 7 musk fragrances in different environmental waters. The chromatographic separation was optimized in different GC instruments equipped with different detectors, allowing the correct separation and identification of the compounds. The HS-SPME method was optimized using a Box-Behnken experimental design, while the validation was carried out together with the most suitable commercial fiber (divinylbenzene/polydimethylsiloxane) for comparison purposes.

A green miniaturized aqueous biphasic system prepared with cholinium chloride and a phosphate salt to extract and preconcentrate personal care products in wastewater samples.

A miniaturized extraction/preconcentration method based on an aqueous biphasic system (μ-ABS) was developed with reagents commonly used as food additives: cholinium chloride (ChCl) as main extraction phase, KHPO as salting-out agent, and water as the main component (being the sample for analyses). With the aim of obtaining high enrichment factors, miniaturization, and adequate analytical performance, a point in the biphasic region with the lowest amount of ChCl was selected, corresponding to 1.55% (w/w) of ChCl, 59.

A Simple Assay Using Amphipods for the Evaluation of Potential Biocompatible Metal-Organic Frameworks.

In this study, the application of amphipods assays was evaluated. The main aim of this work was to check the potential use of this model in biocompatibility assessments of metal-organic frameworks (MOFs). Hence, six different MOFs were synthesized and the and cytotoxicity was first assessed using a colorimetric assay and a macrophage cell line.

Insights into coacervative and dispersive liquid-phase microextraction strategies with hydrophilic media - A review.

Since the development of liquid-phase microextraction (LPME), different LPME modes depending on the experimental set-up to carry out the extraction have been described. Dispersive liquid-liquid microextraction (DLLME), in which a small amount of the water-insoluble extraction solvent is dispersed in the sample, is the most successful mode in terms of number of applications reported. Advances within DLLME have been mainly shifted to the incorporation of green, smart and tunable materials as extraction solvents to improve the sustainability and efficiency of the method.

Evolution and current advances in sorbent-based microextraction configurations.

This review overviews the main developments achieved in analytical sample preparation regarding the use of solid sorbents as extractants in different sorbent-based miniaturized, micro-scale and microextraction methods. Two main groups are proposed for the classification of the current approaches, based on their operational mode: micro-solid-phase extraction (µ-SPE) and solid-phase microextraction (SPME), while describing their respective main sub-modes: static- and dispersive-µ-SPE, and SPME with fibers and in tube SPME. Furthermore, other important sorbent-based microscale approaches (e.

Evaluation of Structurally Different Ionic Liquid-Based Surfactants in a Green Microwave-Assisted Extraction for the Flavonoids Profile Determination of sp. and sp. Leaves from Canary Islands.

Aqueous solutions of ionic liquids (ILs) with surface active properties were used as extraction solvents, taking advantage of their impressive solvation properties, in a green microwave-assisted solid-liquid extraction method (IL-MA-SLE) for the extraction of flavonoids from passion fruit and mango leaves. The extraction method was combined with high-performance liquid chromatography and photodiode-array detection (HPLC-PDA) and optimized by response surface methodology using the Box-Behnken experimental design. Under optimum conditions, the extraction efficiency of six structurally different IL-based surfactants was evaluated.

Green solid-phase microextraction fiber coating based on the metal-organic framework CIM-80(Al): Analytical performance evaluation in direct immersion and headspace using gas chromatography and mass spectrometry for the analysis of water, urine and brewed coffee.

A new solid-phase microextraction (SPME) fiber coating was prepared by the immobilization of the metal-organic framework (MOF) CIM-80(Al) on nitinol wires by a green in situ growth approach, using an aqueous synthetic approach, and without the need of any additional material to ensure the attachment of the MOF to the nitinol support. The coating was used for the development of headspace (HS) and direct immersion (DI) SPME methods in combination with gas chromatography and mass spectrometry (GC-MS) for the determination of polycyclic aromatic hydrocarbons (PAHs) as model compounds. Both methods were optimized and validated using the MOF-based fiber together with the commercial polydimethylsiloxane (PDMS) fiber.

Sustainable Micro-Scale Extraction of Bioactive Phenolic Compounds from Leaves with Ionic Liquid-Based Surfactants.

This paper proposes a new sustainable and simple strategy for the micro-scale extraction of phenolic compounds from grapevine leaves with analytical purpose. The method is based on a microwave-assisted solid-liquid extraction approach (MA-SLE), using an aqueous solution of an ionic liquid (IL)-based surfactant as extraction phase. The method does not require organic solvents, nor any clean-up step, apart from filtration prior to the injection in the analytical system.

Use of a pH-sensitive polymer in a microextraction and preconcentration method directly combined with high-performance liquid chromatography.

A pH-sensitive polymer based on the poly(styrene-alt-maleic anhydride) co-polymer serves as basis to develop a microextraction method (pH-HGME) in direct combination with high-performance liquid chromatography (HPLC) and fluorescence detection (FD) for the determination of seven organic compounds, including three polycyclic aromatic hydrocarbons (PAHs), three monohydroxylated PAHs and one alkylphenol, in urine. The method bases on the structural modification of the pH-sensitive polymer in the aqueous sample at a high pH value, followed by the formation and insolubilization of a hydrogel containing the preconcentrated analytes by decreasing the pH, and the direct injection of the hydrogel-rich phase in the HPLC-FD system. The optimization of the main variables permitted the selection of low amounts of aqueous sample (10 mL), which was mixed with 10 mg of co-polymer also present in a low volume (150 µL) of concentrated NaOH.

Ionic liquid-based miniaturized aqueous biphasic system to develop an environmental-friendly analytical preconcentration method.

Two ILs containing guanidinium cations (butylguanidinium chloride -CGu-Cl- and hexylguanidinium chloride -CGu-Cl-) were synthesized and characterized. Their cytotoxicity was also assessed, obtaining adequate CC values of 680 ± 99 mg·L for CGu-Cl and 135 ± 8 mg·L for CGu-Cl. Miniaturized aqueous biphasic systems (μ-ABSs) were developed using amounts lower than 1% (w/w) of these synthesized guanidinium-based ILs, KPO as salting-out agent, and ultrapure water.

Zwitterionic polymeric ionic liquid-based sorbent coatings in solid phase microextraction for the determination of short chain free fatty acids.

Five different zwitterionic sorbent coatings based on polymeric ionic liquids (PILs) were developed by the on fiber UV co-polymerization of the zwitterionic monomers 1-vinyl-3-(alkylsulfonate)imidazolium or 1-vinyl-3-(alkylcarboxylate)imidazolium and different dicationic ionic liquid (IL) crosslinkers. The developed sorbent coatings were applied in headspace solid-phase microextraction in combination with gas chromatography-mass spectrometry for the determination of short chain free fatty acids in wine. The sorbent coatings were found to extract these analytes via a non-competitive extraction mechanism.

Salt-induced ionic liquid-based microextraction using a low cytotoxic guanidinium ionic liquid and liquid chromatography with fluorescence detection to determine monohydroxylated polycyclic aromatic hydrocarbons in urine.

A novel ionic liquid (IL)-based microextraction method has been developed for the determination of four hydroxylated polycyclic aromatic hydrocarbons (OHPAHs) in urine samples. The water soluble IL-based surfactant selected as extraction solvent is decylguanidinium chloride (CGu-Cl), the cytotoxicity and micellar behavior of which were evaluated. The proposed salt-induced IL-based preconcentration method simply consists in adding NaClO to the aqueous medium containing the IL to promote its water insolubility.

Anti-Acanthamoeba activity of Tunisian Thymus capitatus essential oil and organic extracts.

Acanthamoeba species are free-living amoebae widely distributed in the environment and which cause serious human infections. The treatment of Acanthamoeba infections is always very difficult and not constantly effective. More efficient drugs against Acanthamoeba must be developed and medicinal plants can be useful in this case.

Guanidinium ionic liquid-based surfactants as low cytotoxic extractants: Analytical performance in an in-situ dispersive liquid-liquid microextraction method for determining personal care products.

The IL-based surfactant octylguanidinium chloride (CGu-Cl) was designed and synthetized with the purpose of obtaining a less harmful surfactant: containing guanidinium as core cation and a relatively short alkyl chain. Its interfacial and aggregation behavior was evaluated through conductivity and fluorescence measurements, presenting a critical micelle concentration value of 42.5 and 44.

Are metal-organic frameworks able to provide a new generation of solid-phase microextraction coatings? - A review.

Solid-phase microextraction (SPME) is a powerful technique commonly used in sample preparation for extraction/preconcentration of analytes from a wide variety of samples. Among the trends in improving SPME applications, current investigations are focused on the development of novel coatings able to improve the extraction efficiency, sensitivity, and thermal and mechanical stability, within other properties, of current commercial SPME fibers. Metal-organic frameworks (MOFs) merit to be highlighted as promising sorbent materials in SPME schemes.

Monitoring trihalomethanes in chlorinated waters using a dispersive liquid-liquid microextraction method with a non-chlorinated organic solvent and gas chromatography-mass spectrometry.

The environmental monitoring of trihalomethanes (THMs) has been performed by setting up a dispersive liquid-liquid microextraction method in combination with gas chromatography (GC)-mass spectrometry (MS). The optimized method only requires ∼26 µL of decanol as extractant solvent, dissolved in ∼1 mL of acetone (dispersive solvent) for 5 mL of the environmental water containing THMs. The mixture is then subjected to vortex for 1 min and then centrifuged for 2 min at 3500 rpm.

Utilization of highly robust and selective crosslinked polymeric ionic liquid-based sorbent coatings in direct-immersion solid-phase microextraction and high-performance liquid chromatography for determining polar organic pollutants in waters.

Several crosslinked polymeric ionic liquid (PIL)-based sorbent coatings of different nature were prepared by UV polymerization onto nitinol wires. They were evaluated in a direct-immersion solid-phase microextraction (DI-SPME) method in combination with high-performance liquid chromatography (HPLC) and diode array detection (DAD). The studied PIL coatings contained either vinyl alkyl or vinylbenzyl imidazolium-based (ViCnIm- or ViBCnIm-) IL monomers with different anions, as well as different dicationic IL crosslinkers.