Twin Boundary Superstructures Assembled by Periodic Segregation of Solute Atoms.

Twinning is a common deformation mechanism in metals, and twin boundary (TB) segregation of impurities/solutes plays an important role in the performances of alloys such as thermostability, mobility, and even strengthening. The occurrence of such segregation phenomena is generally believed as a one-layer coverage of solutes alternately distributed at extension/compression sites, in an orderly, continuous manner. However, in the Mn-free and Mn-containing Mg-Nd model systems, we reported unexpected three- and five-layered discontinuous segregation patterns of the coherent {101̅1} TBs, and not all the extension sites occupied by solutes larger in size than Mg, and even some larger sized solutes taking the compression sites.

Two-Dimensional Frank-Kasper Phase with One Unit-Cell Thickness.

phase is one of the three basic units by which the Frank-Kasper (F-K) phases are generally assembled. Compared to the other two basic units, that is, and structures, the structure is rarely experimentally observed because of a relatively large volume ratio among the constituents to inhibit its formation. Moreover, the discovered structures are generally the three-dimensional ordered Gibbs bulk phases to conform to their thermodynamic stability.

Nonsymmetrical Segregation of Solutes in Periodic Misfit Dislocations Separated Tilt Grain Boundaries.

Interfacial segregation is ubiquitous in mulit-component polycrystalline materials and plays a decisive role in material properties. So far, the discovered solute segregation patterns at special high-symmetry interfaces are usually located at the boundary lines or are distributed symmetrically at the boundaries. Here, in a model Mg-Nd-Mn alloy, we confirm that elastic strain minimization facilitated nonsymmetrical segregation of solutes in four types of linear tilt grain boundaries (TGBs) to generate ordered interfacial superstructures.

Regulating Precipitates by Simple Cold Deformations to Strengthen Mg Alloys: A Review.

Regulating precipitates is still an important issue in the development of high-strength Mg alloys, due to it determining the precipitation hardening effect. Cold deformation, as a simple and low-cost method, can remarkably influence the precipitate features. It is found that pre-cold deformation before aging can be utilized to enhance the precipitation hardening effect of Mg alloys.

Self-adapted clustering of solute atoms into a confined two-dimensional prismatic platelet with an ellipse-like quasi-unit cell.

This paper reports a new structured prismatic platelet, self-assembled by an ellipse-like quasi-unit cell, precipitated in Mg-In-Yb and Mg-In-Ca ternary alloys and aged isothermally at 200°C using aberration-corrected high-angle annular dark-field scanning transmission electron microscopy combined with density functional theory computations. The ordered stacking of solute atoms along the [0001] direction based on elliptically shaped self-adapted clustering leads to the generation of the quasi-unit cell. The bonding of these ellipse-like quasi-unit-cell rods by the Mg atomic columns along the 〈〉 directions formed a two-dimensional planar structure, which has three variants with a {} habit plane and full coherence with the α-Mg matrix.

Self-Assembly of Two Unit Cells into a Nanodomain Structure Containing Five-Fold Symmetry.

Five-fold symmetry was forbidden for the periodic crystals until the discovery of the Al-Mn icosahedral quasicrystal. We report a kind of precipitated rod-shaped nanophase containing five-fold symmetry but not belonging to any crystals or quasicrystals discovered so far. These metastable nanodomain phases, which precipitated in Mg-6Zn alloy during isothermal aging at 200 °C, contain two separate unit cells in the 2D plane perpendicular to the five-fold axis but with periodic atom arrangement along the five-fold axis, that is, 72° rhombus structure and 72° equilateral hexagon structure.

New Structured Laves Phase in the Mg-In-Ca System with Nontranslational Symmetry and Two Unit Cells.

All of the AB_{2} Laves phases discovered so far satisfy the general crystalline structure characteristic of translational symmetry; however, we report here a new structured Laves phase directly precipitated in an aged Mg-In-Ca alloy by using aberration-corrected scanning transmission electron microscopy. The nanoprecipitate is determined to be a (Mg,In)_{2}Ca phase, which has a C14 Laves structure (hcp, space group: P6_{3}/mmc, a=6.25  Å, c=10.

Improving Tensile and Compressive Properties of an Extruded AZ91 Rod by the Combined Use of Torsion Deformation and Aging Treatment.

In this study, AZ91 magnesium alloy rods were used to investigate the effects of torsion deformation on microstructure and subsequent aging behavior. Extruded AZ91 rod has a uniform microstructure and typical fiber texture. Torsion deformation can generate a gradient microstructure on the cross-section of the rod.

Microstructure, mechanical properties, bio-corrosion properties and cytotoxicity of as-extruded Mg-Sr alloys.

In this study, as-extruded Mg-Sr alloys were studied for orthopedic application, and the microstructure, mechanical properties, bio-corrosion properties and cytotoxicity of as-extruded Mg-Sr alloys were investigated by optical microscopy, scanning electron microscopy with an energy dispersive X-ray spectroscopy, X-ray diffraction, tensile and compressive tests, immersion test, electrochemical test and cytotoxicity test. The results showed that as-extruded Mg-Sr alloys were composed of α-Mg and MgSr phases, and the content of MgSr phases increased with increasing Sr content. As-extruded Mg-Sr alloy with 0.

Microstructure, corrosion behavior and cytotoxicity of biodegradable Mg-Sn implant alloys prepared by sub-rapid solidification.

In this study, biodegradable Mg-Sn alloys were fabricated by sub-rapid solidification, and their microstructure, corrosion behavior and cytotoxicity were investigated by using optical microscopy, scanning electron microscopy equipped with an energy dispersive X-ray spectroscopy, X-ray diffraction, immersion test, potentiodynamic polarization test and cytotoxicity test. The results showed that the microstructure of Mg-1Sn alloy was almost equiaxed grain, while the Mg-Sn alloys with higher Sn content (Sn≥3 wt.%) displayed α-Mg dendrites, and the secondary dendrite arm spacing of the primary α-Mg decreased significantly with increasing Sn content.