Short-term intervention effect analysis of neuromuscular joint facilitation in patients who experienced stroke with shoulder subluxation: a clinical randomized controlled trial.

[Purpose] Shoulder subluxation is a common complication of acute stroke that affects clinical rehabilitation training and hinders the recovery of upper limb motor function. This study explored the short-term interventional effects of neuromuscular joint facilitation in patients who experienced stroke with shoulder subluxation. [Participants and Methods] We recruited 36 patients who experienced stroke with shoulder subluxation.

Short-term effects of a new resistance exercise approach on physical function during chemotherapy after radical breast cancer surgery: a randomized controlled trial.

Background: Approximately 30% of post-operative breast cancer patients develop shoulder joint movement disorders affecting routine upper limb movement. This study discusses the impact of a neuromuscular joint facilitation (NJF) method on the physical function of breast cancer patients experiencing shoulder dysfunction during chemotherapy after radical surgery.

Methods: This study included 162 female patients who have unilateral breast cancer in a cancer hospital in China.

Biomimetic Design of a New Semi-Rigid Spatial Mesh Antenna Reflector.

The reflective surface accuracy (RSA) of traditional space mesh antennas typically ranges from 0.2 to 6 mmRMS. To improve the RSA, an active control scheme can be employed, although it presents challenges in determining the installation position of the actuator.

The Factors Influencing Shoulder Mobility Disorders in Patients after Radical Breast Cancer Surgery: A Cross-Sectional Study.

Introduction: This study is a cross-sectional study that investigated the factors influencing shoulder mobility in terms of pain, grip strength, and supraspinatus muscle thickness in patients with impaired shoulder mobility during chemotherapy after radical breast cancer surgery.

Methods: This study included 165 female patients with unilateral breast cancer who had shoulder joint mobility disorders during chemotherapy within 3 months after surgery. The clinical examination included the maximum active range of motion of the shoulder (flexion, extension, abduction, adduction, external rotation, and internal rotation), pain score (visual analog scale [VAS]), grip strength, and supraspinatus muscle thickness.

Traditional Chinese exercises on pain and disability in middle-aged and elderly patients with lumbar disc herniation: a systematic review and meta-analysis of randomized controlled trials.

Background: Traditional Chinese exercises (TCEs) have played a significant role in treating various diseases. However, there is limited research assessing the efficacy of TCEs in treating Lumbar disc herniation (LDH). This study aimed to systematically evaluate the effects of four commonly used TCEs (Baduanjin, Yijinjing, Taichi, and Wuqinxi) on pain and disability in elderly patients with LDH.

Study on the mechanical parameters of neuromuscular joint facilitation rehabilitation techniques for lumbar intervention.

[Purpose] To measure the reliability of and quantify the force on the spinous process during lumbar neuromuscular joint facilitation using mechanical measuring gloves. [Participants and Methods] We recruited 12 healthy participants. The operator wore a mechanical measuring glove and performed evaluations in the four modes of neuromuscular joint facilitation of the lumbar spine.

Immediate effects of neuromuscular joint-facilitation bridging exercises on walking ability and balance function in stroke patients.

[Purpose] This study aimed to examine the immediate effects of a pelvic neuromuscular joint-facilitation intervention on the walking and balance ability of patients with hemiplegia caused by cerebrovascular accidents. [Participants and Methods] A total of 15 patients with hemiplegia caused by cerebrovascular accidents underwent a neuromuscular joint-facilitation lumbar-pattern intervention (intervention group), a bridge exercise (bridge intervention group), or a neuromuscular joint-facilitation bridge intervention (neuromuscular joint-facilitation bridge group). Each intervention was randomly administered at 7-day intervals.

Evaluation of supraspinatus muscle changes in the shoulder joint of stroke patients with hemiplegic and shoulder subluxation using ultrasonography: comparison between affected and unaffected sides.

[Purpose] The shoulder joint has a very unstable structure yet a significantly wide range of motion. Weakness of the muscles around the shoulder joint may cause shoulder joint subluxation. This study aimed to determine changes in supraspinatus muscle thickness between different shoulder abduction angles using ultrasonography and to compare differences in supraspinatus muscle thickness changes between the affected and unaffected sides depending on shoulder joint subluxation.

The reliability and effectiveness of shoulder joint evaluation by ultrasonography in stroke patients: deltoid muscle thickness, acromion-humeral distance, acromion-lesser tuberosity distance.

[Purpose] This study aimed to evaluate the reliability of the intraclass correlation coefficient (ICC) in measuring deltoid muscle thickness (DMT) at different angles, acromion-humeral distance (AHD), and acromion nodule tuberosity (ALT) distance in a resting position in stroke patients using ultrasonography. [Participants and Methods] We included 40 stroke patients. During the measurement of parameters by ultrasonography, we measured the deltoid muscle thickness on both sides at three test angles (0°, 30°, and 60° abduction) and AHD and ALT on both sides at 0° angle.

Curative effect of long-term intervention using a new device in patients with chronic low back pain.

[Purpose] This study aimed to observe the changes in the thickness of the transverse abdominis muscle after long-term training with a new device using ultrasound imaging and to determine the impact of these changes on chronic low back pain (CLBP). [Participants and Methods] This study included 60 participants with CLBP, who were divided into groups that adopted different positions during the training regimen: new device intervention group (NDG), sitting training group (STG), and supine training group (SPTG). Patients in the NDG used the new device during training.

Analysis of the relationship between the transversus abdominis and lower back pain using an ultrasound.

[Purpose] This study aimed to observe the thickness of the transverse abdominis muscle in different contraction states using ultrasound, and to investigate the diagnostic capability of transverse abdominal muscle thickness for nonspecific lower back pain. [Participants and Methods] This study included 108 healthy adults (30-50 years old), consisting of 33 participants with low back pain (13 males, 20 females; defined as those who had experienced low back pain for more than six months) and 75 participants without low back pain (22 males, 53 females). The body mass index, body trunk muscle mass, and transverse abdominal muscle thickness, measured at a static state, during the end of inspiration, end of expiration, transverse abdominis contraction, and simultaneous pelvic floor and transverse abdominis muscle contraction, were measured.

Research on Joint-Angle Prediction Based on Artificial Neural Network for Above-Knee Amputees.

In the current study, our research group proposed an asymmetric lower extremity exoskeleton to enable above-knee amputees to walk with a load. Due to the absence of shank and foot, the knee and ankle joint at the amputation side of the exoskeleton lack tracking targets, so it is difficult to realize the function of assisted walking when going up and downstairs. Currently, the use of lower-limb electromyography to predict the angles of lower limb joints has achieved remarkable results.

Effect of Cooling Method on Formability of Laser Cladding IN718 Alloy.

The finite element model (FE) of temperature field of straight thin-walled samples in laser cladding IN718 was established, and the growth of microstructure was simulated by cellular automata (CA) method through macro-micro coupling (CA-FE). The effects of different cooling conditions on microstructure, hardness, and properties of laser-cladding layer were studied by designing cooling device. The results show that the simulation results are in good agreement with the microstructure of the cladding layer observed by the experiment.

Effect of Vanadium Content on the Microstructure and Mechanical Properties of IN718 Alloy by Laser Cladding.

Microalloying vanadium can change the segregation state of Nb element in IN718 alloy, reduce the formation of harmful Laves phase and refine the dendritic structure of IN718 alloy during the laser process. Therefore, IN718 alloys with V content from 0.081 to 1.

Investigation on the Microporosity Formation of IN718 Alloy during Laser Cladding Based on Cellular Automaton.

Porosity is one of the most common defects in the laser cladding of Inconel 718 (IN718) alloy, which can reduce the strength and fatigue performance of the components. However, the dynamic formation of microporosity is challenging to observe through experiments directly. In order to explore the formation mechanism of porosities and dynamically reproduce the competitive growth between porosities and dendrite, a multi-scale numerical model was adopted, combined with a cellular automaton (CA) and finite element method (FEM).

Reliability of ultrasonographic measurement of the supraspinatus thickness at different angles of shoulder abduction in patients with stroke.

[Purpose] The primary purpose of this study was to evaluate the usefulness of the intraclass correlation coefficient for evaluating the reliability of the measurement of the supraspinatus thickness on shoulder ultrasonography at different angles in a resting position in patients with stroke. [Participants and Methods] The study included 20 patients with stroke. The supraspinatus thickness was measured on both sides on ultrasonography, with the participants' shoulders in abduction at 3 testing angles (0°, 30°, and 60° abduction).

Prediction of Limb Joint Angles Based on Multi-Source Signals by GS-GRNN for Exoskeleton Wearer.

To enable exoskeleton wearers to walk on level ground, estimation of lower limb movement is particularly indispensable. In fact, it allows the exoskeleton to follow the human movement in real time. In this paper, the general regression neural network optimized by golden section algorithm (GS-GRNN) is used to realize prediction of the human lower limb joint angle.

Immediate effects of lumbar spine patterns after neuromuscular joint facilitation on balance in stroke patients.

[Purpose] The present study investigated changes in the balance function of stroke patients after neuromuscular joint facilitation treatment. [Participants and Methods] Fourteen stroke patients were randomly subjected to neuromuscular joint facilitation intervention (neuromuscular joint facilitation intervention group) and no intervention (control group), with a 1-day interval between treatments. The interventions were performed consecutively.

Thermal Deformation of PA66/Carbon Powder Composite Made with Fused Deposition Modeling.

Polyamide 66 (PA66) is a material with high wear resistance, toughness, and heat resistance. However, low stiffness and thermal deformation during thermal processes define applications in many conditions. Carbon powder efficiently enhances stiffness and reduces thermal deformation, which makes up defects of plastic materials.

Influence of Vanadium on the Microstructure of IN718 Alloy by Laser Cladding.

A deleterious Laves phase forms in the solidified structure of Inconel 718 (IN718) alloy during laser cladding. However, effective removal methods have not yet been identified. In this study, we first added the IN718 alloy cladding layers with a trace amount of vanadium (V, 0.