Establishing a method similar to ICP-MS that can quantitatively analyze multiple heavy metals simultaneously, conveniently, and in situ is highly anticipated. In this study, we integrated the sensing elements of multiple targets and different fluorescence reporting elements to construct an engineered Escherichia coli. When these targets are present, the engineered bacteria can emit a fluorescent signal at the corresponding wavelength.
View Article and Find Full Text PDFA method has been developed to quantify PET and PBT microplastics (MPs) based on depolymerization and detection of depolymerization products by gas chromatography-tandem mass spectrometry (GC-MS/MS) without a complex separation process from environmental samples. Under the optimal depolymerization conditions, PET and PBT were efficiently converted to ethylene glycol (78%) and 1,4-butanediol (87%), respectively. Subsequently, the linear curves were constructed between signal intensities of depolymerization products and polymer masses by GC-MS/MS, and the correlation coefficients of PET and PBT were 0.
View Article and Find Full Text PDFAlthough engineering bacterial sensors have outstanding advantages in reflecting the actual bioavailability and continuous monitoring of pollutants, the potential escape risk of engineering microorganisms and lower detection sensitivity have always been one of the biggest challenges limiting their wider application. In this study, a core-shell hydrogel bead with functionalized silica as the core and alginate-polyacrylamide as the shell have been developed not only to realize zero escape of engineered bacteria but also to maintain cell activity in harsh environments, such as extremely acidic/alkaline pH, high salt concentration, and strong pressure. Particularly, after combining the selective preconcentration toward pollutants by functionalized core and the positive feedback signal amplification of engineering bacteria, biosensors have realized two-stage signal amplification, significantly improving the detection sensitivity and reducing the detection limit.
View Article and Find Full Text PDFTo develop a convenient method for simultaneous detection of As(III/V), Cr(III/VI), and Fe(II/III), three morphologies of CeO oxidase have been prepared. Based on the difference in oxidase activity and binding ability with substrate TMB of CeOof different morphologies, a 3 (Signal unit) × 6 (Target number) × 5 (Repetition) sensor array was constructed to realize simultaneous detection of six variable valence metal ions As(III/V), Cr(III/VI), and Fe(II/III). The lowest detection limit of the array for metal ions was 1.
View Article and Find Full Text PDFThe classes and forms of antibiotics directly determine their ecotoxicity and environmental chemical behavior, and developing a sensor array for simultaneous and in situ detection of antibiotics is highly anticipated. In this study, different morphologies of g-CN with different fluorescence properties and peroxidase activity were prepared by regulating the degree of interlayer stacking and planar connectivity. Subsequently, in order to enhance its enzyme activity and amplify the differences in response signals to different antibiotics, three morphologies of g-CN/MIL-101(Fe) were prepared by in situ growth of equivalent amounts of MIL-101(Fe) on g-CN, respectively.
View Article and Find Full Text PDFTo develop simultaneous and in-situ detection techniques towards Cr(VI) and Mn(II), Eu/Tb@CDs with white fluorescence were prepared by a one-step hydrothermal method. With the increase of Cr(VI), all fluorescence channels of Eu/Tb@CDs exhibited obvious quenching, and the detection limit (LOD) was 0.10 μM.
View Article and Find Full Text PDFTo develop a convenient and intelligent detector for simultaneous and in-situ detection of Al and F in groundwater, a novel organic probe called RBP has been prepared. With the increase of Al, RBP showed a significant fluorescence enhancement at 588 nm, and the detection limit was 0.130 mg/L.
View Article and Find Full Text PDFDue to the extremely low concentration, complex composition and easy to be converted into each other in water and air of water-soluble volatile organic compounds (VOCs), it is a great challenge to the traditional detection technology, pollution control and traceability, etc. Therefore, developing a convenient, swift and on-site detection method for simultaneous quantification of multiple VOCs is highly anticipated. In this paper, a multifunctional sensor array with adsorption and sensing of VOCs has been constructed by four fluorescence channels of small-sized Eu@Uio-66 and Tb@Uio-66.
View Article and Find Full Text PDFThe threat of tetracycline antibiotics to the environment and human health is attracting widespread attention. The development of morphological analysis and quantitative techniques of multiple tetracyclines is of great significance for the evaluation of biochemical toxicity, wide-spectrum antibacterial property and degradation cycle between different tetracyclines. In this study, the white fluorescent Eu/Tb@CDs was synthesized and applied successfully to the identification and detection of the most widely used tetracycline antibiotics (tetracycline (TC), oxytetracycline (OC), chlortetracycline (CC) and doxycycline (DC)) with detection limits all below 1 nM.
View Article and Find Full Text PDFAniline has attracted much concern for its long degradation half-life and huge toxicity to the environment and human beings. Therefore, the development of a multi-functional device for visual detection and efficient removal of aniline was highly anticipated. In our work, the small-size Eu@UiO-66(COOH) was obtained by post-synthesis modification (PSM), and then the film-based fluorescent sensor was prepared by crosslinking reaction.
View Article and Find Full Text PDFDeveloping a portable device for visual and on-site detection of fluoride in groundwater is highly anticipated. In this paper, 2-(tert-butyl-diphenylsilanyloxy)-5-nitro-1H-benzoimidazole (1) has been rationally designed via a silanization reaction for self-calibration detection of fluoride, and the detection limit was calculated as 0.11 μM.
View Article and Find Full Text PDFDue to the huge threat of formaldehyde (FA) on human beings, the development of chemical sensors for swift detection of FA in solutions and gas phase is highly anticipated. In this paper, a versatile logic detector and a portable fluorescent film based on small-scaled Eu-based MOF were applied successfully to detect FA in solutions and gas phase, respectively. For FA in aqueous solution, the design of logic detector will efficiently identify FA in different concentration ranges: when the FA concentration are 0-500 ppb, 500-1000 ppb and >1000 ppb, the output signals of logic detector are the concentration level of FA ("L", "H" and "VH"), and accompanied by red, purple and blue signal lamps to remind, respectively.
View Article and Find Full Text PDF