Fiber optical CATV transport systems based on PM and light injection-locked DFB LD as a duplex transceiver.

A bidirectional fiber optical CATV transport system employing phase modulation (PM) scheme and frequency up-conversion technique to deal with downstream CATV signals, and using light injection-locked distributed feedback laser diode (DFB LD) as a duplex transceiver at the receiving site is proposed and experimentally demonstrated. With optimum injection wavelength and power level, a DFB LD is efficiently employed for both the transmitter and receiver operations. Such DFB LD is used to replace the functions of delay interferometer (DI) and CATV receiver, and also to be as the upstream light source.

RoF transport systems with OSNR enhanced multi-band optical carrier generator.

A combination of an economic multi-band optical carrier generator and a novel optical signal to noise ratio (OSNR) enhancement circuit is proposed and demonstrated for radio over fiber (RoF) transport systems. Different from normal RoF transport systems which a central station (CS) needs multiple dedicate wavelength laser diodes (LDs) to support various base stations (BSs), the proposed scheme can employ a single LD to provide multiple optical carriers for various BSs. To verify this scheme, 8 coherent optical carriers are firstly generated using a single LD and a local oscillator (LO).

Full-duplex lightwave transport systems employing phase-modulated RoF and intensity-remodulated CATV signals.

A full-duplex lightwave transport system employing phase-modulated radio-over-fiber (RoF) and intensity-remodulated CATV signals in two-way transmission is proposed and experimentally demonstrated. The transmission performances of RoF and CATV signals are investigated in bidirectional way, with the assistance of only one optical sideband and optical single sideband (SSB) schemes at the receiving sites. The experimental results show that the limitation on the optical modulation index (OMI) of the downlink RoF signal can be relaxed due to the constant intensity of phase modulation scheme.

Hybrid CATV/16-QAM OFDM in-building networks over SMF and GI-POF transport.

A hybrid CATV/16-QAM OFDM in-building network over a combination of single-mode fiber (SMF) and graded-index plastic optical fiber (GI-POF) transport is proposed and experimentally demonstrated with good qualities of service. In this system, a 1556 nm optical signal is directly transmitted along with two fiber spans (20-km SMF + 25-m GI-POF). Without using any wavelength conversion or bridge circuit between SMF and POF connection, error free transmissions with sufficient low bit error rate (BER) values are achieved for 2.

Integration of FTTH and GI-POF in-house networks based on injection locking and direct-detection techniques.

An integration of fiber-to-the-home (FTTH) and graded-index plastic optical fiber (GI-POF) in-house networks based on injection-locked vertical cavity surface emitting lasers (VCSELs) and direct-detection technique is proposed and experimentally demonstrated. Sufficient low bit error rate (BER) values were obtained over a combination of 20-km single-mode fiber (SMF) and 50-m GI-POF links. Signal qualities satisfy the worldwide interoperability for microwave access (WiMAX) requirement with data signals of 20 Mbps/5.

A broadband ASE light source-based full-duplex FTTX/ROF transport system.

A full-duplex fiber-to-the-X (FTTX)/radio-over-fiber (ROF) transport system based on a broadband amplified spontaneous emission (ASE) light source is proposed and demonstrated for rural wide-spread villages. Combining the concepts of long-transmission transmission and ring topology, a long-haul single-mode fiber (SMF) trunk is sharing with multiple rural villages. Externally modulated baseband (BB) (1.