Long-Term Outcomes of Round Window Reinforcement for Superior Semicircular Canal Dehiscence Syndrome.

Objective: To report long-term patient reported outcome measures (PROMs) after standardized round window rein-forcement (RWR) with thin cartilage and perichondrium for superior semicircular canal dehiscence syndrome (SSCDS).

Methods: Cross-sectional survey in 2020 and retrospective longitudinal study of outcomes at 3 months, 1 year, and last follow-up after 28 consecutive RWRs. Endpoints were the last follow-up for PROMs and 1 year postoperatively for audiometry and cVEMP.

The Risk of Benign Paroxysmal Positional Vertigo After Head Trauma.

Objectives: Head trauma may cause dislodgement of otoconia and development of benign paroxysmal positional vertigo (BPPV). The risk of developing BPPV is expected to be highest shortly after the trauma, then decrease and approach the risk seen in the general population. The aim of this study was to estimate the risk-time curve of BPPV development after head trauma.

Validation of nursing documentation regarding in-hospital falls: a cohort study.

Background: In-hospital fall incidents are common and sensitive to nursing care. It is therefore important to have easy access to valid patient data to evaluate and follow-up nursing care. The aim of the study was to validate the nursing documentation, using a specific term in the registered nurses´ (RNs´) discharge note, regarding inpatient falls according to the outcome of a digitalized data extraction tool and the discharge note itself.

Experiences of sensory input in daily occupations for people with serious mental illness.

Background: There is growing evidence that people with serious mental illness have impaired capacity for processing sensory inputs which affects daily occupation. Although this is known, research regarding the target groups experiences of sensory inputs in daily occupations is lacking.

Aim: To investigate the experience of sensory input and strategies used in daily occupations among people with serious mental illness.

The influence of the molecular weight of the water-soluble polymer on phase-separated films for controlled release.

Hydroxypropyl cellulose (HPC) and ethyl cellulose (EC) can be used for extended release coatings, where the water-soluble HPC may act as a pore former. The aim was to investigate the effect of the molecular weight of HPC on the microstructure and mass transport in phase-separated freestanding EC/HPC films with 30% w/w HPC. Four different HPC grades were used, with weight averaged molecular weights (Mw) of 30.

Characterization of pore structure of polymer blended films used for controlled drug release.

The characterization of the pore structure in pharmaceutical coatings is crucial for understanding and controlling mass transport properties and function in controlled drug release. Since the drug release rate can be associated with the film permeability, the effect of the pore structure on the permeability is important to study. In this paper, a new approach for characterizing the pore structure in polymer blended films was developed based on an image processing procedure for given two-dimensional scanning electron microscopy images of film cross-sections.

Renal function three years after early conversion from a calcineurin inhibitor to everolimus: results from a randomized trial in kidney transplantation.

In a 36-month, open-label, multicenter trial, 202 kidney transplant recipients were randomized at week 7 post-transplant to convert to everolimus or remain on cyclosporine: 182 were analyzed to month 36 (92 everolimus, 90 controls). Mean (SD) change in measured GFR (mGFR) from randomization to month 36 was 1.3 (14.

New insights on how to adjust the release profile from coated pellets by varying the molecular weight of ethyl cellulose in the coating film.

The major aims of this work were to study the effect of the molecular weight (Mw) of ethyl cellulose (EC) on the drug release profile from metoprolol succinate pellets coated with films comprising EC and hydroxypropyl cellulose (HPC) with a weight ratio of 70:30, and to understand the mechanisms behind the different release profiles. A broad range of Mws was used, and the kinetics of drug release and HPC leaching followed. The higher the Mw of EC, the slower the HPC leaching and the drug release processes.

Effects of molecular weight on permeability and microstructure of mixed ethyl-hydroxypropyl-cellulose films.

Films of ethyl cellulose (EC) and water-soluble hydroxypropyl cellulose (HPC) can be used for extended release coatings in oral formulations. The permeability and microstructure of free EC/HPC films with 30% w/w HPC were studied to investigate effects of EC molecular weight. Phase separation during film spraying and subsequent HPC leaching after immersion in aqueous media cause pore formation in such films.

Photothrombosis-induced infarction of the mouse cerebral cortex is not affected by the Nrf2-activator sulforaphane.

Sulforaphane-induced activation of the transcription factor NF-E2 related factor 2 (Nrf2 or the gene Nfe2l2) and subsequent induction of the phase II antioxidant system has previously been shown to exert neuroprotective action in a transient model of focal cerebral ischemia. However, its ability to attenuate functional and cellular deficits after permanent focal cerebral ischemia is not clear. We assessed the neuroprotective effects of sulforaphane in the photothrombotic model of permanent focal cerebral ischemia.

Prevalence of antibiotic-resistant bacteria in residents of nursing homes in a Swedish municipality: healthcare staff knowledge of and adherence to principles of basic infection prevention.

Background: The aims of this study were to investigate the prevalence of methicillin-resistant Staphylococcus aureus (MRSA), vancomycin-resistant enterococci (VRE) and extended-spectrum β-lactamase (ESBL)-producing Enterobacteriaceae in residents living in Swedish nursing homes, and if carriage of resistant bacteria was related to antibiotic treatment, other risk factors, and/or staff's adherence to guidelines for infection control.

Methods: Five hundred and sixty residents from 9 nursing homes on a total of 67 wards participated in the study and had microbiological cultures taken. Faecal samples were obtained from 495 residents (88.

Trauma-induced reactive gliosis is reduced after treatment with octanol and carbenoxolone.

Background: Reactive gliosis and scar formation after brain injury can inhibit the recovery process. As many glial cells utilize gap junctions for intercellular signaling, this study investigated whether two commonly used gap junction blockers, octanol and carbenoxolone, could attenuate reactive gliosis following a minor traumatic brain injury.

Methods: Octanol (710 mg/kg) or carbenoxolone (90 mg/kg) was administered 30 minutes before or after a needle track injury in adult male Sprague-Dawley rats.

Repeated transient sulforaphane stimulation in astrocytes leads to prolonged Nrf2-mediated gene expression and protection from superoxide-induced damage.

Oxidative stress is a major contributor to slowly developing diseases like Parkinson's disease, Alzheimer's disease and cancer and one of the main causes of tissue damage following ischemic insults in the brain. Nrf2 is a transcription factor responsible for much of the inducible cellular defense against oxidative stress. Nrf2 can also be activated by xenobiotics like sulforaphane, a component highly enriched in cruciferous vegetables such as broccoli.

A new oxygen carrier for improved long-term storage of human pancreata before islet isolation.

Background: Pancreas oxygenation during cold storage has been established in islet isolation and transplantation to prevent ischemic tissue damage using perfluorodecalin (PFD) as hyperoxygen carrier. However, studies in humans and pigs provided conflicting results about the efficiency of PFD for pancreas oxygenation. The aim of this study was to compare PFD with a newly developed oxygen carrier composed of perfluorohexyloctane and polydimethylsiloxane 5 (F6H8S5) for long-term storage of human pancreata.

Self-assembled and self-sorted array of chemically active beads for analytical and biochemical screening.

A technique for generating a general screening platform consisting of dots of immobilized beads on silicon has been developed via self-sorting and -assembly of different kinds of beads. The dots are defined by a teflon-like film, which due to its hydrophobic characteristics also prevents cross-contamination of liquid from different dots. To enable functionalization of individual dots with different target molecules simultaneously a new way of microcontact printing has been explored where different target solutions are printed in parallel using one stamp.

Viability analysis and apoptosis induction of breast cancer cells in a microfluidic device: effect of cytostatic drugs.

Breast cancer is the leading cause of cancer deaths among non-smoking women worldwide. At the moment the treatment regime is such that patients receive different chemotherapeutic and/or hormonal treatments dependent on the hormone receptor status, the menopausal status and age. However, in vitro sensitivity testing of tumor biopsies could rationalize and improve the choice of chemo- and hormone therapy.

Viability study of HL60 cells in contact with commonly used microchip materials.

This paper presents a study in which different commonly used microchip materials (silicon oxide, borosilicate glass, and PDMS) were analyzed for their effect on human promyelocytic leukemic (HL60) cells. Copper-coated silicon was analyzed for its toxicity and therefore served as a positive control. With quantitative PCR, the expression of the proliferation marker Cyclin D1 and the apoptosis marker tissue transglutaminase were measured.

Rapid melting curve analysis on monolayered beads for high-throughput genotyping of single-nucleotide polymorphisms.

This report describes a rapid solid-phase melting curve analysis method for single-nucleotide polymorphism (SNP) genotyping. The melting curve analysis is based on dynamic allele-specific hybridization (DASH). The DNA duplexes are conjugated on beads that are immobilized on the surface of a microheater chip with integrated heaters and temperature sensors.

A concept for miniaturized 3-D cell culture using an extracellular matrix gel.

This paper presents a novel method to embed, anchor, and cultivate cells in a controlled 3-D flow-through microenvironment. This is realized using an etched silicon pillar flow chamber filled with extracellular matrix (ECM) gel mixed with cells. At 4 degrees C, while in liquid form, ECM gel is mixed with cells and injected into the chamber.

Pyrosequencing in a microfluidic flow-through device.

To explore genome variation meaningfully, there is a critical need for a high-throughput and inexpensive platform for DNA analysis. Pyrosequencing is a nonelectrophoretic bioluminometric DNA sequencing method that uses a four-enzyme mixture reaction to monitor nucleotide incorporation in real time. Currently, the commercialized pyrosequencing technique is limited to a 96-microtiter plate format.

Apoptotic cell death dynamics of HL60 cells studied using a microfluidic cell trap device.

This paper presents the design, fabrication and first results of a microfluidic cell trap device for analysis of apoptosis. The microfluidic silicon-glass chip enables the immobilization of cells and real-time monitoring of the apoptotic process. Induction of apoptosis, either electric field mediated or chemically induced with tumour necrosis factor (TNF-alpha), in combination with cycloheximide (CHX), was addressed.