Microstructural Evolution in a 6060 Extrudable Al-Alloy: Integrated Modeling and Experimental Validation.

Desirable properties including strength, ductility and extrudability of 6060 Al-alloys are highly dependent on processing to control the development of microstructural features. In this study, the process chain of an extrudable 6060 Al-alloy was modeled in an Integrated Computational Materials Engineering framework and validated experimentally via quantitative SEM-EDX and TEM. All critical processing stages were considered including casting, homogenization heating and holding, extrusion cooling and two-stage aging.

Microstructure and Salt Fog Corrosion of Wrought Mg-Al-Zn and Mg-RE Alloys.

Wrought magnesium alloys have received attention due to their potential application as lightweight materials. However, their use is limited by their poor corrosion resistance. Rare earth additions have the potential to enhance corrosion resistance.

Low Cycle Fatigue Behavior of Plastically Pre-Strained HSLA S355MC and S460MC Steels.

Cold roll forming used in the manufacturing of lightweight steel profiles for racking storage systems is associated with localized, non-uniform plastic deformations in the corner sections of the profiles, which act as fatigue damage initiation sites. In order to obtain a clearer insight on the role of existing plastic deformation on material fatigue performance, the effect of plastic pre-straining on the low cycle fatigue behavior of S355MC and S460MC steels was investigated. The steels were plastically deformed at different pre-strain levels under tension, and subsequently subjected to cyclic strain-controlled testing.