Preparation and characterization of lignin-derived carbon aerogels.

Lignin is considered a valuable renewable resource for building new chemicals and materials, particularly resins and polymers. The aromatic nature of lignin suggests a synthetic route for synthesizing organic aerogels (AGs) similar to the aqueous polycondensation of resorcinol with formaldehyde (FA). The structure and reactivity of lignin largely depend on the severity of the isolation method used, which challenges the development of new organic and carbon materials.

Study of the adhesion of explosive residues to the finger and transfer to clothing and luggage.

It is important to understand the extent of transfer of explosive particles to different surfaces in order to better evaluate potential cross-contamination by explosives in crowded security controls such as those at airports. This work investigated the transfer of nine explosive residues (ANFO, dynamite, black powder, TNT, HMTD, PETN, NHNO, KNO, NaClO) through fingerprints from one surface to another. First, the extent of adhesion of explosive residues from different surfaces to the bare finger, nitrile and latex gloves was studied.

Simple multispectral imaging approach for determining the transfer of explosive residues in consecutive fingerprints.

This novel investigation focused on studying the transfer of explosive residues (TNT, HMTD, PETN, ANFO, dynamite, black powder, NHNO, KNO, NaClO) in ten consecutive fingerprints to two different surfaces - cotton fabric and polycarbonate plastic - by using multispectral imaging (MSI). Imaging was performed employing a reflex camera in a purpose-built photo studio. Images were processed in MATLAB to select the most discriminating frame - the one that provided the sharpest contrast between the explosive and the material in the red-green-blue (RGB) visible region.

Development and comparison of HPLC and MEKC methods for the analysis of cyclic sulfur mustard degradation products.

In this study, novel, fast, and simple methods based on RP-HPLC and MEKC with DAD are developed and validated for the qualitative and quantitative determination of five cyclic sulfur mustard (HD) degradation products (1,4-thioxane, 1,3-dithiolane, 1,4-dithiane, 1,2,5-trithiepane, and 1,4,5-oxadithiepane) in water samples. The HPLC method employs a C18 column and an isocratic water-ACN (55:45, v/v) mobile phase. This method enables separation of all five cyclic compounds within 8 min.

Development of a capillary electrophoresis method with direct UV detection for the analysis of thiodiglycol and its oxidation products.

A novel method based on CE with precolumn derivatization and direct UV detection for the determination of thiodiglycol (TDG), TDG sulfoxide, and TDG sulfone in water samples was developed. The lack of a UV chromophore of target analytes was overcome by derivatization with phthalic anhydride. The reactant concentrations, as well as the derivatization dependence on heating temperature and time, were carefully investigated.

Fingerprinting postblast explosive residues by portable capillary electrophoresis with contactless conductivity detection.

A portable capillary electrophoretic system with contactless conductivity detection was used for fingerprint analysis of postblast explosive residues from commercial organic and improvised inorganic explosives on various surfaces (sand, concrete, metal witness plates). Simple extraction methods were developed for each of the surfaces for subsequent simultaneous capillary electrophoretic analysis of anions and cations. Dual-opposite end injection principle was used for fast (<4 min) separation of 10 common anions and cations from postblast residues using an optimized separation electrolyte composed of 20 mM MES, 20 mM l-histidine, 30 μM CTAB and 2 mM 18-crown-6.