Rapid differentiation of cystic fibrosis-related bacteria via reagentless atmospheric pressure photoionisation mass spectrometry.

Breath analysis is an area of significant interest in medical research as it allows for non-invasive sampling with exceptional potential for disease monitoring and diagnosis. Volatile organic compounds (VOCs) found in breath can offer critical insight into a person's lifestyle and/or disease/health state. To this end, the development of a rapid, sensitive, cost-effective and potentially portable method for the detection of key compounds in breath would mark a significant advancement.

Profiling flavourings in strawberry-flavoured e-liquid using headspace-gas chromatography-mass spectrometry.

E-liquids typically contain nicotine and flavourings in a matrix of propylene glycol (PG) and vegetable glycerine (VG). Some nicotine-free e-liquids are flavouring only in the aerosol carrier with the option for users to add their own nicotine. It is only the nicotine that is monitored in terms of level, as specified by the manufacturers.

An automated micro solid phase extraction gas chromatography-mass spectrometry (μSPE-GC-MS) detection method for geosmin and 2-methylisoborneol in drinking water.

Geosmin and 2-methylisoborneol (2-MIB) are amongst the most common earthy and musty taste and odour (T&O) compounds found in drinking water. With low odour threshold detection limits below 10 ng L, and the complexity of raw water matrices, these two compounds provide a significant challenge for water companies globally. In this research, for the first time, a novel and fully automated micro-solid phase-extraction (μSPE) method coupled with gas chromatography (GC)-mass spectrometry (MS) has been developed for the detection of geosmin and 2-MIB for drinking water analysis.

A simple approach to analysing trace metals in aerosols produced by e-cigarettes.

Electronic cigarettes are a relatively new alternative to cigarettes, which have been marketed as being safer for users than conventional cigarettes. However, they may still result in inhalation of potentially toxic or carcinogenic substances, including metals produced by the heating element. This study looked at the levels of trace metals being produced by different atomizers used in e-cigarettes using a sample introduction technique based on the collection of aerosols produced by e-cigarettes in nitric acid, using glass midget impingers.