Burst-mode thulium all-fiber laser delivering femtosecond pulses at a 1 GHz intra-burst repetition rate.

We report on the development of, to the best of our knowledge, the first ultrafast burst-mode laser system operating at a central wavelength of approximately 2 μm, where water absorption and, consequently, the absorption of most biological tissue is very high. The laser comprises a harmonically mode-locked 1-GHz oscillator, which, in turn, seeds a fiber amplifier chain. The amplifier produces 500 ns long bursts containing 500 pulses with 1 GHz intra-burst and 50 kHz inter-burst repetition rates, respectively, at an average power of 1 W, corresponding to 40 nJ pulse and 20 μJ burst energies, respectively.

Ablation-cooled material removal with ultrafast bursts of pulses.

The use of femtosecond laser pulses allows precise and thermal-damage-free removal of material (ablation) with wide-ranging scientific, medical and industrial applications. However, its potential is limited by the low speeds at which material can be removed and the complexity of the associated laser technology. The complexity of the laser design arises from the need to overcome the high pulse energy threshold for efficient ablation.

Texturing of titanium (Ti6Al4V) medical implant surfaces with MHz-repetition-rate femtosecond and picosecond Yb-doped fiber lasers.

We propose and demonstrate the use of short pulsed fiber lasers in surface texturing using MHz-repetition-rate, microjoule- and sub-microjoule-energy pulses. Texturing of titanium-based (Ti6Al4V) dental implant surfaces is achieved using femtosecond, picosecond and (for comparison) nanosecond pulses with the aim of controlling attachment of human cells onto the surface. Femtosecond and picosecond pulses yield similar results in the creation of micron-scale textures with greatly reduced or no thermal heat effects, whereas nanosecond pulses result in strong thermal effects.

Development of a thulium (Tm:YAP) laser system for brain tissue ablation.

In this study, a thulium (Tm:YAP) laser system was developed for brain surgery applications. As the Tm:YAP laser is a continuous-wave laser delivered via silica fibers, it would have great potential for stereotaxic neurosurgery with highest local absorption in the IR region. The laser system developed in this study allowed the user to set the power level, exposure time, and modulation parameters (pulse width and on-off cycles).

Fluence of thulium laser system in skin ablation.

Tm:YAP laser system at power levels up to 1.2 W at 1980 nm was established in both continuous-wave and modulated modes of operation. The fluence effect of the laser system for skin ablation was analyzed by histology analysis with Wistar rat skin tissues.

Modulated and continuous-wave operations of low-power thulium (Tm:YAP) laser in tissue welding.

Our aim is to explore the welding capabilities of a thulium (Tm:YAP) laser in modulated and continuous-wave (CW) modes of operation. The Tm:YAP laser system developed for this study includes a Tm:YAP laser resonator, diode laser driver, water chiller, modulation controller unit, and acquisition/control software. Full-thickness incisions on Wistar rat skin were welded by the Tm:YAP laser system at 100 mW and 5 s in both modulated and CW modes of operation (34.