Publications by authors named "Halah Thanoon"
Objective: Investigate the effect of solvent-storage on surface hardness and bulk creep of fast photo-cured bulk-fill resin-based composite (RBC) compared to conventionally irradiated bulk-fill RBCs.
Methods: Three bulk-fill RBCs were studied: Tetric® PowerFill (fast photo-cured bulk-fill RBC) (TPF), Tetric EvoCeram® (EVO), and GrandioSO® x-tra (GSOx) (conventional). Disk-shaped specimens of clinically realistic thickness (4 mm) were prepared from each material for: Group A: surface measurements (18 mm diameter) and Group B: 4 mm diameter for bulk compressive creep measurements.
Objective: This study examines the effect of two light-curing protocols from a LED polywave light curing unit (LCU) on water sorption, solubility, and hygroscopic expansion of fast and conventional bulk-fill resin-based composites (RBCs) aged in distilled water for 120 d.
Methods: Three bulk-fill RBCs materials were studied: Tetric PowerFill® (fast photo-polymerised composite) (TPF), Tetric EvoCeram bulk-fill (EVO), and GrandioSo x-tra bulk-fill (GSO) (conventional photo-polymerised composites). Specimens were prepared within a 3D-printed resin mold (8-mm diameter x 4-mm height) and light-cured from one side only with 2 modes of polywave LCU (Bluephase® PowerCure): 3 s mode and for 20 s in "Standard" mode.
Objectives: This study investigated effects of the different emittance-mode protocols from three light curing units (LCUs): (i) a Laser (Monet); (ii) a quad-wave (PinkWave); (iii) a conventional LED (Elipar S10) on the temperature rise (ΔT) and degree of conversion (DC) when photo-curing fast or conventional bulk-fill resin-based composites (RBC). The aim was to correlate ΔT and DC, and the radiant exposure delivered to RBC specimens.
Methods: A 3D-printed resin mold of 4 mm depth was filled with two bulk-fill RBCs: Tetric PowerFill® (fast photo-polymerised composite) (TPF) or Tetric EvoCeram® Bulk-Fill (EVO).