Publications by authors named "H Tsuruoka"
Article Synopsis
- This study investigated the monitoring of oxygen and ventilation during bronchoscopy since sedatives can suppress breathing and create complications.
- Researchers included patients needing diagnostic procedures and used a transcutaneous blood gas monitor to track changes in carbon dioxide levels and oxygen saturation in real-time.
- The results showed high success in monitoring (96.6%) and indicated that the combination of midazolam and fentanyl led to more significant changes in carbon dioxide levels compared to midazolam alone.
Previous studies have shown that rapid on-site evaluation (ROSE) improves the diagnostic yield of bronchoscopy using endobronchial ultrasound with a guide sheath (EBUS-GS) for peripheral pulmonary lesions (PPL). While ROSE of imprint cytology from forceps biopsy has been widely discussed, there are few reports on ROSE of brush cytology. This study investigated the utility of ROSE of brush cytology during bronchoscopy.
View Article and Find Full Text PDFPurpose: Maxillary molars have low alveolar bone height diameter due to the presence of the maxillary sinus; thus, a sinus lift may be required in some cases. Changes in the volume of bone substitutes can affect the success of implant therapy. Therefore, this study aimed to compare the changes in the volume of two different bone substitutes-one based on carbonate apatite and the other on octacalcium phosphate-used in maxillary sinus floor elevation.
View Article and Find Full Text PDFRecently, several biologics have been approved for the treatment of severe asthma. Dupilumab, a biologic used to treat severe asthma, is a monoclonal antibody targeting interleukin-4 and interleukin-13. In the present case, inhaled corticosteroid-induced glucocorticoid hypersensitivity was suspected, and the administration of omalizumab and mepolizumab had no beneficial effects.
View Article and Find Full Text PDFPolylactic acid (PLA) has gained considerable attention as an alternative to petroleum-based materials due to environmental concerns. We fabricated implant models with fused filament fabrication (FFF) 3D printers using PLA, and the accuracies of these PLA models were compared with those of plaster models made from silicone impressions and resin models made with digital light processing (DLP). A base model was obtained from an impact-training model.
View Article and Find Full Text PDF