Interlaboratory comparison of extraction efficiency of pesticides from surface and laboratory water using solid-phase extraction disks.

A continuation of an earlier interlaboratory comparison was conducted (1) to assess solid-phase extraction (SPE) using Empore disks to extract atrazine, bromacil, metolachlor, and chlorpyrifos from various water sources accompanied by different sample shipping and quantitative techniques and (2) to compare quantitative results of individual laboratories with results of one common laboratory. Three replicates of a composite surface water (SW) sample were fortified with the analytes along with three replicates of deionized water (DW). A nonfortified DW sample and a nonfortified SW sample were also extracted.

Kinetics and uptake mechanisms for monomethylmercury between freshwater algae and water.

Uptake kinetics of monomethylmercury chloride (MeHgCl) were measured for two species of green algae (Selenastrum capricomutum and Cosmarium botrytis), one blue-green algae (Schizothrix calcicola), and one diatom (Thalassiosira weissflogii), algal species that are commonly found in natural surface waters. Species differences were found with the two green algae giving the highest uptake rates, and one of them (Cosmarium) showing differences between cultures having widely different cell age (exponential versus stationary), where increases in uptake rate for cells 30 days old were about 25 times greater than cells only 3 days old when weights of cells were considered. Both Schizothrix and Thalassiosira exhibited nearly the same lower uptake rates, approximately 20 times lower than the two green algal species.

Partitioning of monomethylmercury between freshwater algae and water.

Phytoplankton-water monomethylmercury (MeHg) partition constants (KpI) have been determined in the laboratory for two green algae Selenastrum capricornutum and Cosmarium botrytis, the blue-green algae Schizothrix calcicola, and the diatom Thallasiosira spp., algal species that are commonly found in natural surface waters. Two methods were used to determine KpI, the Freundlich isotherm method and the flow-through/dialysis bag method.

Recovery of atrazine, bromacil, chlorpyrifos, and metolachlor from water samples after concentration on solid-phase extraction disks: interlaboratory study.

An interlaboratory comparison was conducted in 1997 and 1998 to examine the feasibility of using C18 solid-phase extraction disks (Empore) to simultaneously determine the herbicides atrazine, bromacil, and metolachlor and the insecticide chlorpyrifos in water samples. A common fortification source and sample processing procedure were used to minimize variation in initial concentrations and operator inconsistencies. The protocol consisted of paired laboratories in different locations coordinating their activities and shipping fortified water samples (deionized or local surface water) or Empore disks on which the pesticides had been retained and then quantitating the analytes by a variety of gas chromatographic methods.

Effect of temperature and humidity on the formation of dibutylurea in benlate fungicide.

Benomyl [methyl 1-(butylcarbamoyl)-2-benzimidazolecarbamate] is the active ingredient in DuPont Benlate fungicides. The formation of N, N'-dibutylurea (DBU), a phytotoxic degradation product of benomyl, in Benlate formulations was evaluated by analyzing Benlate samples maintained under simulated storage conditions and assessing the effects of temperature and humidity on sample moisture content, benomyl degradation, and the rate of DBU formation. Benomyl degraded during storage by the elimination of n-butylisocyanate (BIC) to form methyl 2-benzimidazole carbamate (MBC; carbendazim).