Coupling of PZT Thin Films with Bimetallic Strip Heat Engines for Thermal Energy Harvesting.

A thermal energy harvester based on a double transduction mechanism and which converts thermal energy into electrical energy by means of piezoelectric membranes and bimetals, has previously been developed and widely presented in the literature In such a device, the thermo-mechanical conversion is ensured by a bimetal whereas the electro-mechanical conversion is generated by a piezoelectric ceramic. However, it has been shown that only 19% of the mechanical energy delivered by the bimetal during its snap is converted into electrical energy. To extract more energy from the bimetallic strip and to increase the transduction efficiency, a new way to couple piezoelectric materials with bimetals has thus been explored through direct deposition of piezoelectric layers on bimetals.

Fatigue effect of elastocaloric properties in natural rubber.

In the framework of elastocaloric (eC) refrigeration, the fatigue effect on the eC effect of natural rubber (NR) is investigated. Repetitive deformation cycles at engineering strain regime from 1 to 6 results in a rapid rupture (approx. 800 cycles).

Investigation of electrostrictive polymer efficiency for mechanical energy harvesting.

The purpose of this paper is to propose new means for harvesting energy using electrostrictive polymers. Recent trends in energy conversion mechanisms have demonstrated the abilities of electrostrictive polymers for converting mechanical vibrations into electricity. In particular, such materials present advantageous features such as a high productivity, high flexibility, and ease of processing; hence, the application of these materials for energy harvesting purposes has been of significant interest over the last few years.

High nonlinearities in Langevin transducer: a comprehensive model.

The design and simulation of power transducers are difficult since piezoelectric, dielectric and elastic properties of ferroelectric materials differ from linear behavior when driven at large levels. This paper is devoted to modeling of a resonant power transducer at a high level of dynamic mechanical stress. The power transducer is subjected to a sine electrical field E of varying frequency which was considered as the excitation of the transducer.

Switching loss reduction in nonlinear piezoelectric conversion under pulsed loading.

Energy conversion enhancement of piezoelectric materials has been subject to intensive research over the last decade. Among the proposed solutions (for instance, single crystal), it has been shown that applying a simple and low-cost nonlinear treatment to the voltage output can significantly increase the conversion abilities of such materials. However, such an approach also adds significant electrical losses, dramatically reducing the available electric energy generated from the mechanical excitation.

Analysis of ac-dc conversion for energy harvesting using an electrostrictive polymer P(VDF-TrFE-CFE).

Harvesting systems capable of transforming unused environmental energy into useful electrical energy have been extensively studied for the last two decades. The recent development of electrostrictive polymers has generated new opportunities for harvesting energy. The contribution of this study lies in the design and validation of electrostrictive polymer- based harvesters able to deliver dc output voltage to the load terminal, making the practical application of such material for self-powered devices much more realistic.

Nonlinear optimization of acoustic energy harvesting using piezoelectric devices.

In the first part of the paper, a single degree-of-freedom model of a vibrating membrane with piezoelectric inserts is introduced and is initially applied to the case when a plane wave is incident with frequency close to one of the resonance frequencies. The model is a prototype of a device which converts ambient acoustical energy to electrical energy with the use of piezoelectric devices. The paper then proposes an enhancement of the energy harvesting process using a nonlinear processing of the output voltage of piezoelectric actuators, and suggests that this improves the energy conversion and reduces the sensitivity to frequency drifts.

Extracellular matrix produced by osteoblasts cultured under low-magnitude, high-frequency stimulation is favourable to osteogenic differentiation of mesenchymal stem cells.

The effects of low-magnitude, high-frequency (LMHF) mechanical stimulation on osteoblastic cells are poorly understood. We have developed a system that generates very small (15-40 με), high-frequency (400 Hz, sine) deformations on osteoblast cultures (MC3T3-E1). We investigated the effects of these LMHF stimulations mainly on extracellular matrix (ECM) synthesis.

Modeling and experimentation on an electrostrictive polymer composite for energy harvesting.

The harvesting of energy from ambient environments is an emerging technology with potential for numerous applications, including portable electronic devices for renewable energy. Most of the current research activities refer to classical piezoelectric ceramic materials, but more recently the development of electrostrictive polymers has generated novel opportunities for high-strain actuators. At present, the investigation of using electrostrictive polymers for energy harvesting (a conversion of mechanical to electrical energy) is beginning to show potential for this application.

A new adaptive resonance frequency of piezoelectric components used for vibration damping.

This paper describes two methods for vibration damping in a broad band frequency range using a piezoelectric patch. The first method, applied to an adaptive device, uses a bias (static voltage control), which applies stresses or releases stresses in a piezoelectric component to modify its mechanical characteristics and thereby its resonance frequency. The second method is based on a semipassive approach [synchronized switch damping (SSD)], developed to control structural vibration damping using a piezoelectric component.

Synthesis of polystyrene coated SiC nanowires as fillers in a polyurethane matrix for electromechanical conversion.

Grafting of polystyrene (PS) from silica coating of silicon carbide nanowires (SiCNWs) has been performed by a two-step nitroxide mediated free radical polymerization (NMP) of styrene. First, an alkoxyamine based on N-tert-butyl-N-(1-diethylphosphono-2,2-dimethylpropyl) nitroxide (DEPN) was covalently attached onto NWs through free surface silanol groups. To immobilize the alkoxyamine initiator on the silica surface, alkoxylamine was formed in situ by the simultaneous reaction of polymerizable acryloxy propyl trimethoxysilane (APTMS), azobis isobutyronitrile (AIBN), and DEPN, which was used as a radical trap.

Low-cost capacitor voltage inverter for outstanding performance in piezoelectric energy harvesting.

The purpose of this paper is to propose a new scheme for piezoelectric energy harvesting optimization. The proposed enhancement relies on a new topology for inverting the voltage across a single capacitor with reduced losses. The increase of the inversion quality allows a much more effective energy harvesting process using the so-called synchronized switch harvesting on inductor (SSHI) nonlinear technique.

Fractional derivative operators for modeling the dynamic polarization behavior as a function of frequency and electric field amplitude.

Polarization phenomena in ferroelectric materials are frequency-dependent, and the present article describes the use of a fractional derivative for the understanding of these phenomena as well as modeling them as functions of frequency and electric field amplitude. The focus was first directed toward the definition and validation of the proposed model through comparisons between simulations and measurements for high electrical field excitation amplitudes on a large frequency bandwidth (major hysteresis loops, measured over 4 decades). Subsequently, the same comparisons were made under ultra-weak as well as weak electric fields.

Nonlinear pyroelectric energy harvesting from relaxor single crystals.

Energy harvesting from temperature variations in a Pb(Zn(1/3)Nb(2/3))(0.955)Ti(0.045)O(3) single crystal was studied and evaluated using the Ericsson thermodynamic cycle.

Pyroelectric energy conversion: optimization principles.

In the framework of microgenerators, we present in this paper the key points for energy harvesting from temperature using ferroelectric materials. Thermoelectric devices profit from temperature spatial gradients, whereas ferroelectric materials require temporal fluctuation of temperature, thus leading to different applications targets. Ferroelectric materials may harvest perfectly the available thermal energy whatever the materials properties (limited by Carnot conversion efficiency) whereas thermoelectric material's efficiency is limited by materials properties (ZT figure of merit).

Energy harvesting based on FE-FE transition in ferroelectric single crystals.

The pyroelectric properties of Pb(Zn(1/3)Nb(2/3))(0955)Ti(0.045)O(3) single crystals versus an electric field have been studied for energy harvesting in this paper. Two thermodynamic cycles (Stirling and Ericsson) were used for this purpose.

Characterization of the mechanical nonlinear behavior of piezoelectric ceramics.

A characterization of the nonlinear behavior with high signal excitation in piezoceramic resonators was carried out. The behavior of power devices working at resonance, in which high strains are involved, is explained. A theoretical model previously described is used to explain the motional impedance variation proportional to the square of the motional current.

Nonlinear processing of the output voltage of a piezoelectric transformer.

Reducing the size of power supplies raises the problem of new components that could be better candidates for integration. In this field, electromagnetic transformers may be replaced with significant benefit by piezoelectric transformers (PT). In a PT, the input electrical energy is transferred to the output by an acoustical means, using the direct and converse effects of piezoelectric materials.

Single crystals and nonlinear process for outstanding vibration-powered electrical generators.

This paper compares the performances of vibration-powered electrical generators using a piezoelectric ceramic and a piezoelectric single crystal associated to several power conditioning circuits. A new approach of the piezoelectric power conversion based on a nonlinear voltage processing is presented, leading to three novel high performance power conditioning interfaces. Theoretical predictions and experimental results show that the nonlinear processing technique may increase the power harvested by a factor of 8 compared to standard techniques.

Wave reflection and transmission reduction using a piezoelectric semipassive nonlinear technique.

This study addresses the problem of noise reduction using piezoelements. The nonlinear technique, synchronized switch damping (SSD), is implemented. The device is a pulse-tube termination equipped with piezoelements, which allows performant damping of the vibration resulting from an incident acoustic wave.

Modeling of elastic nonlinearities in ferroelectric materials including nonlinear losses: application to nonlinear resonance mode of relaxors single crystals.

(1-x)Pb(Mg1/3Nb2/3)O3-xPbTiO3 (PMN-PT) and (1-x)Pb(Zn1/3Nb2/3)O3-xPbTiO3 (PZN-PT) single crystals are considered to behave like soft Pb(Zr,Ti)O3 (PZT) ceramics because of their small mechanical quality factor Qm and poor stability under external disturbances (Qm > 500-1000 for hard PZT ceramic, and Qm < 100 for soft PZT and PMN-PT and PZN-PT single crystals). At weak signal excitation of the first resonance mode, the displacement at the end of a lateral bar is proportional to the Q31d31 figure of merit that is very close to that found for hard PZT. Indeed the very large piezoelectric coefficient compensates the low Qm.

Toward energy harvesting using active materials and conversion improvement by nonlinear processing.

This paper presents a new technique of electrical energy generation using mechanically excited piezoelectric materials and a nonlinear process. This technique, called synchronized switch harvesting (SSH), is derived from the synchronized switch damping (SSD), which is a nonlinear technique previously developed to address the problem of vibration damping on mechanical structures. This technique results in a significant increase of the electromechanical conversion capability of piezoelectric materials.

Stability of morphotropic (110) oriented 0.65PMN-0.35PT single crystals.

Electromechanical properties of (1-x)Pb (Mg1/3Nb2/3)O3-xPbTiO3 (PMN-PT) single crystals with x = 0.35 were investigated as a function of different external disturbances. The polarization dependence on the electromechanical properties was first studied in order to determine the best polarization path.

Investigations on ferroelectric PMN-PT and PZN-PT single crystals ability for power or resonant actuators.

Ferroelectric single crystals of PZN-PT and PMN-PT exhibit outstanding properties: high charge coefficient (dij), high coupling factor (kij) and high strain levels under DC fields. Besides, their mechanical quality factor is believed to be low. Their usefulness for non-resonant or large bandwidth transducers has therefore been previously investigated.