Microparticles prepared with poly(hydroxybutyrate-co-hydroxyvalerate) and poly(epsilon-caprolactone) blends to control the release of a drug model.

The objective of this work was to verify the influence of the poly(epsilon-caprolactone) PCL concentration in poly(hydroxybutyrate-co-hydroxyvalerate) P(HBHV)/PCL microparticles, prepared by an emulsion/solvent evaporation process, on the release behavior of a drug. Differential Scanning Calorimetry analyses demonstrated that the preparation process increased the crystallite heterogeneity for the P(HBHV) in the particles. The drug caused an increase in the glass transition of the P(HBHV) in the microparticles.

Physico-chemical characterization of nanocapsule polymeric wall using fluorescent benzazole probes.

Fluorescent polymers were used to prepare innovative formulations with the objective of verifying the chemical composition of the particle/water interface of nanocapsules at a molecular level. The benzazole dyes distinguish between apolar and polar/protic environments. Comparing the fluorescent behavior of benzoxazole-loaded nanocapsules (entrapped dye) with that of fluorescent-polymeric nanocapsules (chemically bound dye), the results indicated that the latter was exposed to a different environment than that to which the entrapped dye was exposed.

Dexamethasone-loaded nanoparticle-coated microparticles: correlation between in vitro drug release and drug transport across Caco-2 cell monolayers.

This work reports the preparation of dexamethasone in nanoparticle-coated microparticles and the study of the influence of such microencapsulation on drug absorption across Caco-2 cell monolayers. Nanoparticle-coated microparticles were prepared by spray-drying using nanocapsules (NC) or nanospheres (NS) in aqueous suspensions as coating material. Drug contents ranged from 64 to 134mgg(-1), yields between 49% and 67% and moisture content below 2.

Polymeric nanoparticles, nanospheres and nanocapsules, for cutaneous applications.

This review presents an overview about pharmaceutical and cosmetic topical products containing polymeric nanoparticles (nanospheres and nanocapsules), reporting the main preparation and characterization methods and the studies of penetration and transport of substances through the skin. The penetration and transport extent of those systems through the skin depends on the ingredients chemical composition, on the encapsulation mechanism influencing the drug release, on the size of nanoparticles and on the viscosity of the formulations. The polymeric nanoparticles are able to modify the activity of drugs, delay and control the drug release, and increase the drug adhesivity or its time of permanence in the skin.

Physico-chemical characterization and in vivo evaluation of indomethacin ethyl ester-loaded nanocapsules by PCS, TEM, SAXS, interfacial alkaline hydrolysis and antiedematogenic activity.

Nanocapsules are vesicular drug carriers constituted of an oil core, a polymeric wall, and surfactants. A general understanding about the influence of the polymeric wall of nanocapsules on the release profiles of drugs is not known. So, this work was devoted to characterize formulations prepared without polymer or containing it at different concentrations.

Sodium pantoprazole-loaded enteric microparticles prepared by spray drying: effect of the scale of production and process validation.

Pantoprazole is a prodrug used in the treatment of acid related disorders and Helicobacter pylori infections. It is activated inside gastric parietal cells binding irreversibly to the H(+)/K(+)-ATPase. In this way, pantoprazole must be absorbed intact in the intestinal tract, which indicates that enteric drug delivery systems are required for its oral administration.

Preparation, characterization, and in vivo anti-ulcer evaluation of pantoprazole-loaded microparticles.

Pantoprazole is an important drug in the treatment of acid-related disorders. This work concerns the preparation and characterization of gastro-resistant pantoprazole-loaded microparticles prepared using an O/O emulsification/solvent evaporation technique. The in vivo activity of the pantoprazole-loaded Eudragit S100 microparticles was carried out in rats.

Diffusion and mathematical modeling of release profiles from nanocarriers.

The aim of this work was to establish models and to differentiate the kinetic release behavior of drug models from nanocapsules, nanoemulsion and nanospheres by physico-chemical characterization and release experiments. SAXS analysis showed that the polymer is organized in the nanocapsules, while in the nanospheres the sorbitan monostearate is organized and acts as an impurity of the poly(epsilon-caprolactone) suggesting that constituents in these nanocarriers are differently organized. Formulations presented particle sizes ranging from 178 to 297 nm, probe content from 0.

Semisolid topical formulations containing nimesulide-loaded nanocapsules, nanospheres or nanoemulsion: development and rheological characterization.

The objective of this work was to develop and characterize semisolid topical formulations containing nimesulide-loaded nanospheres, nanocapsules or nanoemulsion. The nanoprecipitation and spontaneous emulsification methods were used to prepare the colloidal suspensions and the nanoemulsion. The hydrodynamic diameters were 282 nm for the nanoemulsion, 293 nm for the nanocapsules and 191 nm for the nanospheres containing nimesulide.

Alkaline hydrolysis as a tool to determine the association form of indomethacin in nanocapsules prepared with poly(eta-caprolactone).

To determine the association form of indomethacin in nanocapsules prepared with poly(eta-caprolactone) as polymer and a triglyceride as oil, two methods were studied. The indomethacin ethyl ester was prepared as control, which showed a higher affinity for the oil than the indomethacin. Two differently loaded nanocapsule formulations were prepared.

LC determination of citral in Cymbopogon citratus volatile oil.

It was the aim of this study to develop and validate a HPLC method for the quantitative determination of citral in Cymbopogon citratus volatile oil. The HPLC assay was performed using a Spherisorb CN column (250 mm x 4.6 mm, 5 microm), a n-hexane:ethanol (85:15) mobile phase and an UV detector (set at 233 nm).

Protective properties of melatonin-loaded nanoparticles against lipid peroxidation.

The aim of this study was to prepare melatonin-loaded nanoparticles (nanocapsules and nanospheres) by nanoprecipitation, using Eudragit S100 as polymer. The potential of these systems to protect lipids against peroxidation was evaluated in comparison to melatonin in aqueous solution and nanoemulsion. Liposomes and microsomes were used as model of a lipid membrane and lipid peroxidation was induced by free radical ascorbyl.

Nanoparticle-coated microparticles: preparation and characterization.

The objective of the present work was to design and prepare new nanoparticle-coated drug-loaded inorganic microparticles by spray-drying using diclofenac as drug model. Previous works presented the process to dry drug-loaded polymeric nanoparticles using silicon dioxide as adjuvant, otherwise in the present proposition the drug is associated with the silicon dioxide and unloaded polymeric nanocapsule or nanosphere suspensions were used as organic coating. Eudragit S100 was chosen because of its gastric resistance.

Microdialysis for evaluating the entrapment and release of a lipophilic drug from nanoparticles.

The aim of the study was to evaluate the microdialysis (MD) as a tool to determine entrapment efficiency and drug release of a lipophilic drug model, diclofenac (DIC), from nanocapsules, nanospheres, and nanoemulsions. Factors that could interfere with the MD probe recovery were investigated: perfusion fluid composition, concentration and form of the drug in the perfusate, and recovery method. DIC entrapment efficiency to nanoparticles and the drug release in phosphate buffer pH 7.

Freeze-drying polymeric colloidal suspensions: nanocapsules, nanospheres and nanodispersion. A comparative study.

Different polymeric nanoparticles were freeze-dried and the powders compared to determine the influence of the lipophilic core (Miglyol 810) or benzyl benzoate) and polymeric material (poly(epsilon-caprolactone) or Eudragit S90) on their drug content and morphology. Diclofenac, a non-steroidal anti-inflammatory drug, was used as a model. To characterize the products, a biological experiment based on the evaluation of the mucosal toxicity of diclofenac was conducted.

Hydrophilic gel containing nanocapsules of diclofenac: development, stability study and physico-chemical characterization.

The purpose of this work was to develop and to characterize hydrophilic gels containing nanocapsules (NC) of diclofenac (DIC). Nanocapsules suspension of poly-epsilon-caprolactone containing free acid diclofenac were prepared by nanoprecipitation. The pH value of the nanocapsules suspension was 5.

Spray-dried diclofenac-loaded poly(epsilon-caprolactone) nanocapsules and nanospheres. Preparation and physicochemical characterization.

The aims of the present study were to prepare spray-dried polymeric nanocapsules (NC) and nanospheres (NS) from poly(epsilon-caprolactone) (P epsilon C) suspensions containing diclofenac (DIC) and to determine the physicochemical properties of the formulations. NC or NS suspensions were prepared by interfacial deposition of the polymer. DSC-thermograms of raw materials and NC or NS suspensions (evaporated or spray-dried) were obtained using a PL-DSC.

Ofloxacin/beta-cyclodextrin complexation.

Ofloxacin (OFX) is a fluorquinolone characterized by photochemical instability. With the goal to improve its photostability in aqueous solutions, the complexation of ofloxacin with beta-cyclodextrin was investigated. The complexes showed a water solubility enhancement of approximately 2.

Poly(rac-lactide) nanocapsules containing diclofenac: protection against muscular damage in rats.

The aim of this work was to determine whether encapsulation of a non steroidal antiinflammatory agent within nanocapsules could reduce local toxicity after intramuscular injection. Diclofenac-loaded nanocapsules were prepared by deposition of poly(rac-lactic acid) polymer, and administered intramuscularly to male Wistar rats. Plasma creatine phosphokinase (CPK) activity and histological examination were used to assess local tissue damage.

Influence of benzyl benzoate as oil core on the physicochemical properties of spray-dried powders from polymeric nanocapsules containing indomethacin.

To prepare spray-dried powders of poly(D,L-lactic acid) (PLA) or poly-epsilon-caprolactone (P epsilonC) from colloidal suspensions containing indomethacin (IND) using benzyl benzoate (BnB), nanocapsules (NC) were prepared by nanoprecipitation. To select the best NC formulations, increasing drug concentrations were tested (1.0, 1.

Polymeric colloidal systems containing ethionamide: preparation and physico-chemical characterization.

The association of ethionamide with different colloidal systems was evaluated. Nanocapsules (NC), nanospheres (NS), and nanoemulsions (NE) were prepared by interfacial deposition and spontaneous emulsification techniques. Ethionamide was incorporated before (B) and after (A) preparation of nanoparticles.

Preparation and characterization of spray-dried polymeric nanocapsules.

Recently, much interest has been generated by colloidal drug delivery systems such as nanocapsules because of the possibilities for controlled release, increased drug efficacy, and reduced toxicity after parenteral administration. Nanocapsules of poly-epsilon-caprolactone and Eudragit S90 were prepared. However, these systems present physicochemical instability.