Chemotherapy is the primary treatment for advanced non-small-cell lung cancer (NSCLC). However, related dose-dependent toxicity limits its clinical use. Therefore, it is necessary to explore new strategies for improving the clinical outcomes while reducing the side effects of chemotherapy in the treatment of NSCLC.
View Article and Find Full Text PDFMaterials (Basel)
September 2020
In the internal thread extrusion forming, if the process parameters are not selected properly, the extrusion torque will increase, the extrusion temperature will be too high, or even the tap will break. In order to obtain effective process parameters under certain working conditions, this paper uses a combination of numerical simulation and process experiment to analyze the influence of the bottom hole diameter, extrusion speed, and friction factor on the extrusion torque and extrusion temperature. Through an orthogonal experiment, the significant influence law of different process parameters on the extrusion torque and extrusion temperature was studied, and the order of their influence was determined.
View Article and Find Full Text PDFImproved ranging accuracy is obtained by the development of a novel ultrasonic sensor ranging algorithm, unlike the conventional ranging algorithm, which considers the divergence angle and the incidence angle of the ultrasonic sensor synchronously. An ultrasonic sensor scanning method is developed based on this algorithm for the recognition of an inclined plate and to obtain the localization of the ultrasonic sensor relative to the inclined plate reference frame. The ultrasonic sensor scanning method is then leveraged for the omni-directional localization of a mobile robot, where the ultrasonic sensors are installed on a mobile robot and follow the spin of the robot, the inclined plate is recognized and the position and posture of the robot are acquired with respect to the coordinate system of the inclined plate, realizing the localization of the robot.
View Article and Find Full Text PDFIn this study, Hydroxycamptothecin (HCPT)-loaded micelles were formed in water by the self-assembly of folate (FA)-decorated amphiphilic block copolymer, methoxy poly(ethylene glycol)-poly(ε-caprolactone) (MPEG-PCL), and achieved a hydrodynamic diameter about of 132 nm. HCPT release from the micelles exhibited no initial burst but showed a sustained release profile. The cytotoxicity and targeting ability of FA conjugated polymeric micelles was investigated by using methylthiazoletetrazolium (MTT) and fluorescence microscopy.
View Article and Find Full Text PDFObjective: To demonstrate the cause of public health service delivery insufficiency of disease prevention and control system of China.
Methods: 205 literatures in 8 national academic journals concerning health service management have been reviewed. The method of boundary analysis has been employed to conclude the various causes of public health service delivery insufficiency of disease prevention and control system of China.