On the Springback and Load in Three-Point Air Bending of the AW-2024 Aluminium Alloy Sheet with AW-1050A Aluminium Cladding.

This article presents the results of an analysis of the bending load characteristics and the springback phenomenon occurring during three-point bending of 1.0 and 2.0 mm thick AW-2024 aluminium alloy sheets with rolled AW-1050A cladding.

Springback Prediction for Pure Moment Bending of Aluminum Alloy Square Tube.

The springback phenomenon occurring during cold forming is the main problem affecting the dimensional accuracy of bent products, especially when bending thin-walled profiles, where there are significant changes in the cross-section geometry. This article presents the results of the analysis of the springback phenomenon occurring during shaping with a pure bending moment of square tubes with the cross-sectional dimensions of 21.5 × 21.