Core-Shell Structured MXene@Carbon Nanodots as Bifunctional Catalysts for Solar-Assisted Water Splitting.

The design of nonprecious bifunctional electrocatalysts with high activity and prolonged durability in a wide pH range is essential for the development of the highly efficient, cost-effective, and simplified overall water splitting systems. Here, we report core-shell structured MXene@carbon (MX@C) nanodot hybrids with high bifunctional activity, where N-doped carbon shells are grown in a heteroepitaxial manner strongly interacting with the MXene core. The resulting MX@C nanodot hybrids show enhanced catalytic activity for electrochemical hydrogen evolution reaction (HER) in various pH media from 0 to 14.

Two-Dimensional Metallic Niobium Diselenide for Sub-micrometer-Thin Antennas in Wireless Communication Systems.

The state-of-the-art of the Internet of things (IoT) and smart electronics demands advances in thin and flexible radio frequency (RF) antennas for wireless communication systems. So far, nanostructured materials such as metals, carbon nanotubes, graphene, MXene, and conducting polymers have been investigated due to their noteworthy electrical conductivity. However, most antennas based on metallic materials are thick, which limits their application in miniaturized and portable electronic devices.

Low-cost flexible supercapacitors with high-energy density based on nanostructured MnO2 and Fe2O3 thin films directly fabricated onto stainless steel.

The facile and economical electrochemical and successive ionic layer adsorption and reaction (SILAR) methods have been employed in order to prepare manganese oxide (MnO2) and iron oxide (Fe2O3) thin films, respectively with the fine optimized nanostructures on highly flexible stainless steel sheet. The symmetric and asymmetric flexible-solid-state supercapacitors (FSS-SCs) of nanostructured (nanosheets for MnO2 and nanoparticles for Fe2O3) electrodes with Na2SO4/Carboxymethyl cellulose (CMC) gel as a separator and electrolyte were assembled. MnO2 as positive and negative electrodes were used to fabricate symmetric SC, while the asymmetric SC was assembled by employing MnO2 as positive and Fe2O3 as negative electrode.

Architectured morphologies of chemically prepared NiO/MWCNTs nanohybrid thin films for high performance supercapacitors.

The preparation of nanostructured metal oxide decorated on multiwalled carbon nanotubes (MWCNTs) nanohybrid films through simple, scalable, additive-free, binderless, and cost-effective route has fascinated significant attention not only in fundamental research areas but also its commercial applications, in order to reduce the growing environmental pollution and the cost of electrode fabrication. Here, we report the fabrication of highly flexible electrode with NiO/MWCNTs nanohybrid thin films directly on stainless steel substrate using successive ionic layer adsorption and reaction (SILAR) method. The impact of ratio of adsorption and reaction cycles on structural, surface areas and electrochemical properties of NiO/MWCNTs nanohybrids was investigated.

Surfactant-assisted morphological tuning of hierarchical CuO thin films for electrochemical supercapacitors.

Copper oxide (CuO) thin films are successfully synthesized using a surfactant assisted chemical bath deposition method for application in supercapacitors. The effect of organic surfactants such as Triton X-100 and polyvinyl alcohol (PVA) on structural, morphological, surface areas and electrochemical properties of CuO thin films is investigated. The films deposited using organic surfactants exhibit different surface morphologies.

Decoration of spongelike Ni(OH)2 nanoparticles onto MWCNTs using an easily manipulated chemical protocol for supercapacitors.

This study uses a "bottom-up" approach chemical method to coat nanocrystalline Ni(OH)2 onto multiwalled carbon nanotubes (MWCNTs) for flexible supercapacitor electrodes, where the higher electronic conductivity of MWCNTs permits their use as the supporting backbone onto which Ni(OH)2 can be deposited. The paper portrays the advantages of the facile successive ionic layer adsorption and reaction (SILAR) method for depositing Ni(OH)2/MWCNT thin films onto large area flexible substrates. We demonstrate that these Ni(OH)2/MWCNT films consist of a uniform coating of sponge-like Ni(OH)2 on the MWCNT network structure using scanning electron micrographs and transmission electron micrographs; this structure is promising for supercapacitor applications.