Angular Velocity, Moment, and Power Analysis of the Ankle, Knee, and Hip Joints in the Goalkeeper's Diving Save in Football.

The aim of this study was to identify biomechanical characteristics of goalkeeper's diving performance in football. Lower extremity joints powers, moments, and angular velocities, were investigated in seven elite goalkeepers diving to save balls, shot from a ball canon to unanticipated heights (high and low) and sides (right and left). Our result showed that there was a proximal-to-distal sequence for each leg in timing of peak joints powers ( < 0.

The Effect of Preparatory Posture on Goalkeeper's Diving Save Performance in Football.

Identifying the optimal preparatory posture of football goalkeepers can be very relevant for improving goalkeepers' diving save performance, and coaching practices of technical and strength and conditioning coaches. This study aimed to analyse the effect of different starting stance widths and knee flexion angles on movement time, center of mass (CoM) trajectory and velocity in goalkeepers' diving saves. Ten elite goalkeepers performed dives from preferred (PT) and imposed postures, by altering knee angle (45, 75, and 90°) and stance width (50, 75, and 100% of leg length) independently, at the starting position.

Kinematic and kinetic analysis of the goalkeeper's diving save in football.

Kinetics and full body kinematics were measured in ten elite goalkeepers diving to save high and low balls at both sides of the goal, aiming to investigate their starting position, linear and angular momentum, and legs' contribution to end-performance. Our results showed that goalkeepers adopted a starting position with a stance width of 33 ± 1% of leg length, knee flexion angle of 62 ± 18° and hip flexion angle of 63 ± 18°. The contralateral leg contributed more than the ipsilateral leg to COM velocity (p < 0.

An accurate estimation of the horizontal acceleration of a rower's centre of mass using inertial sensors: a validation.

For a valid determination of a rower's mechanical power output, the anterior-posterior (AP) acceleration of a rower's centre of mass (CoM) is required. The current study was designed to evaluate the accuracy of the determination of this acceleration using a full-body inertial measurement units (IMUs) suit in combination with a mass distribution model. Three methods were evaluated.

Estimating the L5S1 flexion/extension moment in symmetrical lifting using a simplified ambulatory measurement system.

Mechanical loading of the spine has been shown to be an important risk factor for the development of low-back pain. Inertial motion capture (IMC) systems might allow measuring lumbar moments in realistic working conditions, and thus support evaluation of measures to reduce mechanical loading. As the number of sensors limits applicability, the objective of this study was to investigate the effect of the number of sensors on estimates of L5S1 moments.

Changes in gait characteristics of women with early and established medial knee osteoarthritis: Results from a 2-years longitudinal study.

Background: Despite the large number of cross-sectional studies on gait in subjects with knee osteoarthritis, there are scarcely any longitudinal studies on gait changes in knee osteoarthritis.

Methods: Gait analysis was performed on 25 women with early and 18 with established medial knee osteoarthritis, as well as a group of 23 healthy controls. Subjects were asked to walk at their comfortable speed.

Validation of a Step Detection Algorithm during Straight Walking and Turning in Patients with Parkinson's Disease and Older Adults Using an Inertial Measurement Unit at the Lower Back.

Introduction: Inertial measurement units (IMUs) positioned on various body locations allow detailed gait analysis even under unconstrained conditions. From a medical perspective, the assessment of vulnerable populations is of particular relevance, especially in the daily-life environment. Gait analysis algorithms need thorough validation, as many chronic diseases show specific and even unique gait patterns.

Dynamic and static knee alignment at baseline predict structural abnormalities on MRI associated with medial compartment knee osteoarthritis after 2 years.

Background: Dynamic and static varus alignment, both, have been reported as risk factors associated with structural progression of knee osteoarthritis. However the association of none of the static and dynamic alignment with structural, clinical, and functional progression associated with knee osteoarthritis has not been assessed yet in a longitudinal study.

Methods: Forty-seven women with early and established medial knee osteoarthritis were evaluated.

Algorithm for Turning Detection and Analysis Validated under Home-Like Conditions in Patients with Parkinson's Disease and Older Adults using a 6 Degree-of-Freedom Inertial Measurement Unit at the Lower Back.

Introduction: Aging and age-associated disorders such as Parkinson's disease (PD) are often associated with turning difficulties, which can lead to falls and fractures. Valid assessment of turning and turning deficits specifically in non-standardized environments may foster specific treatment and prevention of consequences.

Methods: Relative orientation, obtained from 3D-accelerometer and 3D-gyroscope data of a sensor worn at the lower back, was used to develop an algorithm for turning detection and qualitative analysis in PD patients and controls in non-standardized environments.

Regulation of step frequency in transtibial amputee endurance athletes using a running-specific prosthesis.

Running specific prostheses (RSP) are designed to replicate the spring-like behaviour of the human leg during running, by incorporating a real physical spring in the prosthesis. Leg stiffness is an important parameter in running as it is strongly related to step frequency and running economy. To be able to select a prosthesis that contributes to the required leg stiffness of the athlete, it needs to be known to what extent the behaviour of the prosthetic leg during running is dominated by the stiffness of the prosthesis or whether it can be regulated by adaptations of the residual joints.

Varus thrust in women with early medial knee osteoarthritis and its relation with the external knee adduction moment.

Background: Varus thrust, defined as an abrupt increase of the knee varus angle during weight-bearing in gait, has been shown to be present in patients with moderate to severe knee osteoarthritis and is considered to be one of the risk factors for progression of symptomatic medial knee osteoarthritis. We evaluated the presence and magnitude of varus thrust and its relation with the Knee Adduction Moment in women with early medial knee osteoarthritis, and compared it to that in a group of controls and in a group of subjects with established medial knee osteoarthritis.

Methods: Twenty-seven women with early medial knee osteoarthritis, 20 women with established medial knee osteoarthritis and 24 asymptomatic controls were evaluated.

Hip abductor neuromuscular capacity: A limiting factor in mediolateral balance control in older adults?

Background: Mediolateral balance impairment is an important cause of falling in older adults. We aimed to investigate whether hip abductor muscular strength and/or position sense are limiting factors in mediolateral balance control.

Methods: Sixteen community-dwelling older adults performed three different mediolateral weight-shifting tasks, by tracking (1) a sinusoidally moving visual target, "visual-MELBA"; (2) a sinusoidally translating platform without explicit visual feedback, "mechanical-MELBA"; and (3) an unpredictable platform translation, "sudden-platform-translation.

Kinematic analysis of the drag flick in field hockey.

Attaining high speed of the stick head and consequently of the ball is essential for successful performance of the drag flick in field hockey, but the coordination pattern used to maximise stick head speed is unknown. The kinematics of the drag flick was studied in ten elite hockey players who performed twenty shots each towards a target located 1.5 m high.

The validity of assessing temporal events, sub-phases and trunk kinematics of the sit-to-walk movement in older adults using a single inertial sensor.

The aim of this study was to develop a method to identify temporal events, sub-phases and trunk kinematics of the sit-to-walk (STW) using a single inertial sensor (IS) worn at the lower back and to determine the validity of this method. Twenty-seven healthy older adults performed a STW movement, which started from sitting in a chair and included walking 3m. Participants׳ movements were recorded with the IS, a reference measurement system consisting of an optical motion capture system (3 markers on the IS and one on each foot) and on-off switches located in the seat of the chair.

Changes in proprioceptive weighting during quiet standing in women with early and established knee osteoarthritis compared to healthy controls.

Objectives: Knee osteoarthritis (OA) is highly prevalent in people above the age of 60, and is typically associated with pain, stiffness, muscle weakness and proprioceptive deficits. Muscle-tendon vibration has been used to assess the spatial reweighting of proprioceptive input during standing. The current study aimed to investigate whether weighting of proprioceptive input is altered in patients with early and established knee OA compared to asymptomatic controls.

Supporting the upper body with the hand on the thigh reduces back loading during lifting.

When picking objects from the floor, low back pain patients often tend to support the upper body by leaning with one hand on a thigh. While this strategy may reduce back load, this has not yet been assessed, probably due to the difficulty of measuring the forces between hand and thigh. Ten healthy male subjects lifted a pencil and a crate from the floor, with four lifting techniques (free, squat, stoop and a Weight Lifters Technique (WLT)), each of which was performed with and without supporting with one hand on the thigh.

Learning to balance on one leg: motor strategy and sensory weighting.

We investigated motor and sensory changes underlying learning of a balance task. Fourteen participants practiced balancing on one leg on a board that could freely rotate in the frontal plane. They performed six, 16-s trials standing on one leg on a stable surface (2 trials without manipulation, 2 with vestibular, and 2 with visual stimulation) and six trials on the balance board before and after a 30-min training.

Lumbar compression forces while lifting and carrying with two and four workers.

Team lifting and carrying is advised when loads exceed 25 kg and mechanical lifting is not feasible. The aim of this study was to assess mean, maximum and variability of peak lumbar compression forces which occur daily at construction sites. Therefore, 12 ironworkers performed 50-kg two-worker and 100-kg four-worker lifting and carrying tasks in a laboratory experiment.

Upper extremity kinematic and kinetic adaptations during a fatiguing repetitive task.

Repetitive low-force contractions are common in the workplace and yet can lead to muscle fatigue and work-related musculoskeletal disorders. The current study aimed to investigate potential motion adaptations during a simulated repetitive light assembly work task designed to fatigue the shoulder region, focusing on changes over time and age-related group differences. Ten younger and ten older participants performed four 20-min task sessions separated by short breaks.

A novel method for assessing the 3-D orientation accuracy of inertial/magnetic sensors.

A novel method for assessing the accuracy of inertial/magnetic sensors is presented. The method, referred to as the "residual matrix" method, is advantageous because it decouples the sensor's error with respect to Earth's gravity vector (attitude residual error: pitch and roll) from the sensor's error with respect to magnetic north (heading residual error), while remaining insensitive to singularity problems when the second Euler rotation is close to ±90°. As a demonstration, the accuracy of an inertial/magnetic sensor mounted to a participant's forearm was evaluated during a reaching task in a laboratory.

Effect of aging on inter-joint synergies during machine-paced assembly tasks.

In recent years, uncontrolled manifold (UCM) analysis has emerged as an important method to study variability of human movements. The current study investigated the upper extremity movements during typical assembly tasks using the framework of the UCM analysis. Younger and older participants performed machine-paced assembly tasks, while the kinematics of upper extremities were recorded using a motion tracking system.

Estimating dynamic external hand forces during manual materials handling based on ground reaction forces and body segment accelerations.

Direct measurement of hand forces during assessment of manual materials handling is infeasible in most field studies and some laboratory studies (e.g., during patient handling).

Effects of anxiety on the execution of police arrest and self-defense skills.

We investigated the effects of anxiety on the execution of police officers' arrest and self-defense skills. Police officers (n=13) performed three tasks in which they kicked, blocked, or restrained an opponent who attacked them with a rubber knife (low anxiety, LA) or a shock knife (high anxiety, HA) in a within-subject design. We analyzed performance (on a 5-point Likert scale), movement times, posture, and movement velocity and acceleration.

The error of L5/S1 joint moment calculation in a body-centered non-inertial reference frame when the fictitious force is ignored.

In ergonomics studies, linked segment models are commonly used for estimating dynamic L5/S1 joint moments during lifting tasks. The kinematics data input to these models are with respect to an arbitrary stationary reference frame. However, a body-centered reference frame, which is defined using the position and the orientation of human body segments, is sometimes used to conveniently identify the location of the load relative to the body.